Linux video capture interface: v2.00
bttv: driver version 0.9.17 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI Interrupt 0000:04:00.0[A] -> GSI 16 (level, low) -> IRQ 17
bttv0: Bt878 (rev 17) at 0000:04:00.0, irq: 17, latency: 64, mmio: 0xfdffe000
bttv0: detected: Hauppauge WinTV [card=10], PCI subsystem ID is 0070:13eb
bttv0: using: Hauppauge (bt878) [card=10,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00ffffdb [init]
bttv0: Hauppauge/Voodoo msp34xx: reset line init [5]
tveeprom 1-0050: Hauppauge model 44354, rev C121, serial# 2268107
tveeprom 1-0050: tuner model is Philips FM1216 (idx 21, type 5)
tveeprom 1-0050: TV standards PAL(B/G) (eeprom 0x04)
tveeprom 1-0050: audio processor is MSP3415 (idx 6)
tveeprom 1-0050: has radio
bttv0: Hauppauge eeprom indicates model#44354
bttv0: tuner type=5
bttv0: i2c: checking for MSP34xx @ 0x80... found
msp3400 1-0040: MSP3415D-B3 found @ 0x80 (bt878 #0 [sw])
msp3400 1-0040: MSP3415D-B3 supports nicam, mode is autodetect
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
tuner 1-0061: chip found @ 0xc2 (bt878 #0 [sw])
tuner-simple 1-0061: type set to 5 (Philips PAL_BG (FI1216 and compatibles))
tuner 1-0061: type set to Philips PAL_BG (FI1
tuner-simple 1-0061: type set to 5 (Philips PAL_BG (FI1216 and compatibles))
tuner 1-0061: type set to Philips PAL_BG (FI1
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: registered device radio0
bttv0: PLL: 28636363 => 35468950 .. ok
ACPI: PCI Interrupt 0000:04:00.1[A] -> GSI 16 (level, low) -> IRQ 17
bt87x0: Using board 1, analog, digital (rate 32000 Hz)
bt878: AUDIO driver version 0.0.0 loaded