| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Date: Sat, 03 Apr 2010 14:22:06 -0700 (PDT)
From: leon.woestenberg@...il.com
To: Leon Woestenberg <leon@...ebranch.com>
Subject: [PATCH] staging: crystalhd: Fix for big-endian systems
The original CrystalHD driver assumes a little endian bitfield host.
This patch adds support for big-endian bitfield hosts.
It was tested by verifying the values of all hardware register accesses
on a big-endian host were equal to a little-endian host.
The use of bitfields is discouraged for hardware access, so this needs
to be rewritten to use macro definitions at some point.
Signed-off-by: Leon Woestenberg <leon@...ebranch.com>
--- git.orig/drivers/staging/crystalhd/crystalhd_hw.h 2010-03-21 16:05:52.000000000 +0100
+++ git/drivers/staging/crystalhd/crystalhd_hw.h 2010-04-03 23:05:58.290430827 +0200
@@ -121,6 +121,7 @@
typedef union _intr_mask_reg_ {
struct {
+#ifdef __LITTLE_ENDIAN_BITFIELD
uint32_t mask_tx_done:1;
uint32_t mask_tx_err:1;
uint32_t mask_rx_done:1;
@@ -129,6 +130,16 @@
uint32_t mask_pcie_rbusmast_err:1;
uint32_t mask_pcie_rgr_bridge:1;
uint32_t reserved:25;
+#else
+ uint32_t reserved:25;
+ uint32_t mask_pcie_rgr_bridge:1;
+ uint32_t mask_pcie_rbusmast_err:1;
+ uint32_t mask_pcie_err:1;
+ uint32_t mask_rx_err:1;
+ uint32_t mask_rx_done:1;
+ uint32_t mask_tx_err:1;
+ uint32_t mask_tx_done:1;
+#endif
};
uint32_t whole_reg;
@@ -137,10 +148,17 @@
typedef union _link_misc_perst_deco_ctrl_ {
struct {
+#ifdef __LITTLE_ENDIAN_BITFIELD //ok
uint32_t bcm7412_rst:1; /* 1 -> BCM7412 is held in reset. Reset value 1.*/
uint32_t reserved0:3; /* Reserved.No Effect*/
uint32_t stop_bcm_7412_clk:1; /* 1 ->Stops branch of 27MHz clk used to clk BCM7412*/
uint32_t reserved1:27; /* Reseved. No Effect*/
+#else
+ uint32_t reserved1:27; /* Reseved. No Effect*/
+ uint32_t stop_bcm_7412_clk:1; /* 1 ->Stops branch of 27MHz clk used to clk BCM7412*/
+ uint32_t reserved0:3; /* Reserved.No Effect*/
+ uint32_t bcm7412_rst:1; /* 1 -> BCM7412 is held in reset. Reset value 1.*/
+#endif
};
uint32_t whole_reg;
@@ -149,6 +167,7 @@
typedef union _link_misc_perst_clk_ctrl_ {
struct {
+#ifdef __LITTLE_ENDIAN_BITFIELD
uint32_t sel_alt_clk:1; /* When set, selects a 6.75MHz clock as the source of core_clk */
uint32_t stop_core_clk:1; /* When set, stops the branch of core_clk that is not needed for low power operation */
uint32_t pll_pwr_dn:1; /* When set, powers down the main PLL. The alternate clock bit should be set
@@ -157,6 +176,16 @@
uint32_t pll_mult:8; /* This setting controls the multiplier for the PLL. */
uint32_t pll_div:4; /* This setting controls the divider for the PLL. */
uint32_t reserved1:12; /* Reserved */
+#else
+ uint32_t reserved1:12; /* Reserved */
+ uint32_t pll_div:4; /* This setting controls the divider for the PLL. */
+ uint32_t pll_mult:8; /* This setting controls the multiplier for the PLL. */
+ uint32_t reserved0:5; /* Reserved */
+ uint32_t pll_pwr_dn:1; /* When set, powers down the main PLL. The alternate clock bit should be set
+ to select an alternate clock before setting this bit.*/
+ uint32_t stop_core_clk:1; /* When set, stops the branch of core_clk that is not needed for low power operation */
+ uint32_t sel_alt_clk:1; /* When set, selects a 6.75MHz clock as the source of core_clk */
+#endif
};
uint32_t whole_reg;
@@ -166,10 +195,17 @@
typedef union _link_misc_perst_decoder_ctrl_ {
struct {
+#ifdef __LITTLE_ENDIAN_BITFIELD
uint32_t bcm_7412_rst:1; /* 1 -> BCM7412 is held in reset. Reset value 1.*/
uint32_t res0:3; /* Reserved.No Effect*/
uint32_t stop_7412_clk:1; /* 1 ->Stops branch of 27MHz clk used to clk BCM7412*/
uint32_t res1:27; /* Reseved. No Effect */
+#else
+ uint32_t res1:27; /* Reseved. No Effect */
+ uint32_t stop_7412_clk:1; /* 1 ->Stops branch of 27MHz clk used to clk BCM7412*/
+ uint32_t res0:3; /* Reserved.No Effect*/
+ uint32_t bcm_7412_rst:1; /* 1 -> BCM7412 is held in reset. Reset value 1.*/
+#endif
};
uint32_t whole_reg;
@@ -179,9 +215,15 @@
typedef union _desc_low_addr_reg_ {
struct {
+#ifdef __LITTLE_ENDIAN_BITFIELD
uint32_t list_valid:1;
uint32_t reserved:4;
uint32_t low_addr:27;
+#else
+ uint32_t low_addr:27;
+ uint32_t reserved:4;
+ uint32_t list_valid:1;
+#endif
};
uint32_t whole_reg;
@@ -189,6 +231,7 @@
} desc_low_addr_reg;
typedef struct _dma_descriptor_ { /* 8 32-bit values */
+#ifdef __LITTLE_ENDIAN_BITFIELD
/* 0th u32 */
uint32_t sdram_buff_addr:28; /* bits 0-27: SDRAM Address */
uint32_t res0:4; /* bits 28-31: Reserved */
@@ -219,7 +262,38 @@
/* 7th u32 */
uint32_t res8; /* Last 32bits reserved */
+#else
+ /* 0th u32 */
+ uint32_t res0:4; /* bits 28-31: Reserved */
+ uint32_t sdram_buff_addr:28; /* bits 0-27: SDRAM Address */
+
+ /* 1st u32 */
+ uint32_t buff_addr_low; /* 1 buffer address low */
+ uint32_t buff_addr_high; /* 2 buffer address high */
+ /* 3rd u32 */
+ uint32_t intr_enable:1; /* 31 - Interrupt After this desc */
+ uint32_t res3:6; /* 25-30 reserved */
+ uint32_t xfer_size:23; /* 2-24 = Xfer size in words */
+ uint32_t res2:2; /* 0-1 - Reserved */
+
+ /* 4th u32 */
+ uint32_t last_rec_indicator:1; /* 31 bit Last Record Indicator */
+ uint32_t dma_dir:1; /* 30 bit DMA Direction */
+ uint32_t fill_bytes:2; /* 28-29 Bits Fill Bytes */
+ uint32_t res4:25; /* 3 - 27 Reserved bits */
+ uint32_t next_desc_cont:1; /* 2 - Next desc is in contig memory */
+ uint32_t endian_xlat_align:2; /* 0-1 Endian Translation */
+
+ /* 5th u32 */
+ uint32_t next_desc_addr_low; /* 32-bits Next Desc Addr lower */
+
+ /* 6th u32 */
+ uint32_t next_desc_addr_high; /* 32-bits Next Desc Addr Higher */
+
+ /* 7th u32 */
+ uint32_t res8; /* Last 32bits reserved */
+#endif
} dma_descriptor, *pdma_descriptor;
/*
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists