| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <tkrat.1e07144d0042077e@s5r6.in-berlin.de>
Date: Sun, 23 Jul 2006 22:59:47 +0200 (CEST)
From: Stefan Richter <stefanr@...6.in-berlin.de>
To: linux1394-devel@...ts.sourceforge.net
cc: Ben Collins <bcollins@...ntu.com>, linux-kernel@...r.kernel.org
Subject: [PATCH 2.6.18-rc1-mm2 5/6] ieee1394: sbp2: more checks of status
block
- Add checks for the (very unlikely) cases that the target writes too
little or too much status data or writes unsolicited status.
- Indicate that these and similar conditions are unlikely().
- Check the 'resp' and 'sbp_status' fields for possible failure status.
- Slightly optimize access macros for the status block bitfields.
- Unify a few related log messages.
Signed-off-by: Stefan Richter <stefanr@...6.in-berlin.de>
---
drivers/ieee1394/sbp2.c | 70 +++++++++++++++++-----------------------
drivers/ieee1394/sbp2.h | 14 ++++----
2 files changed, 38 insertions(+), 46 deletions(-)
TODO:
Check if status' 'src'==1, then withhold the respective ORB from reuse
until status for any subsequent ORB was received.
Index: linux/drivers/ieee1394/sbp2.h
===================================================================
--- linux.orig/drivers/ieee1394/sbp2.h 2006-07-23 10:11:34.000000000 +0200
+++ linux/drivers/ieee1394/sbp2.h 2006-07-23 10:21:31.000000000 +0200
@@ -180,12 +180,14 @@ struct sbp2_unrestricted_page_table {
#define SBP2_SCSI_STATUS_SELECTION_TIMEOUT 0xff
-#define STATUS_GET_ORB_OFFSET_HI(value) (value & 0xffff)
-#define STATUS_GET_SBP_STATUS(value) ((value >> 16) & 0xff)
-#define STATUS_GET_LENGTH(value) ((value >> 24) & 0x7)
-#define STATUS_GET_DEAD_BIT(value) ((value >> 27) & 0x1)
-#define STATUS_GET_RESP(value) ((value >> 28) & 0x3)
-#define STATUS_GET_SRC(value) ((value >> 30) & 0x3)
+#define STATUS_GET_SRC(value) (((value) >> 30) & 0x3)
+#define STATUS_GET_LEN(value) (((value) >> 24) & 0x7)
+#define STATUS_GET_ORB_OFFSET_HI(value) ((value) & 0x0000ffff)
+#define STATUS_TEST_D(value) ((value) & 0x08000000)
+/* test 'resp' | 'sbp2_status' */
+#define STATUS_TEST_RS(value) ((value) & 0x30ff0000)
+/* test 'resp' | 'dead' | 'sbp2_status' */
+#define STATUS_TEST_RDS(value) ((value) & 0x38ff0000)
struct sbp2_status_block {
u32 ORB_offset_hi_misc;
Index: linux/drivers/ieee1394/sbp2.c
===================================================================
--- linux.orig/drivers/ieee1394/sbp2.c 2006-07-23 10:21:07.000000000 +0200
+++ linux/drivers/ieee1394/sbp2.c 2006-07-23 10:21:31.000000000 +0200
@@ -1201,11 +1201,8 @@ static int sbp2_query_logins(struct scsi
return -EIO;
}
- if (STATUS_GET_RESP(scsi_id->status_block.ORB_offset_hi_misc) ||
- STATUS_GET_DEAD_BIT(scsi_id->status_block.ORB_offset_hi_misc) ||
- STATUS_GET_SBP_STATUS(scsi_id->status_block.ORB_offset_hi_misc)) {
-
- SBP2_INFO("Error querying logins to SBP-2 device - timed out");
+ if (STATUS_TEST_RDS(scsi_id->status_block.ORB_offset_hi_misc)) {
+ SBP2_INFO("Error querying logins to SBP-2 device - failed");
return -EIO;
}
@@ -1298,18 +1295,12 @@ static int sbp2_login_device(struct scsi
* Sanity. Make sure status returned matches login orb.
*/
if (scsi_id->status_block.ORB_offset_lo != scsi_id->login_orb_dma) {
- SBP2_ERR("Error logging into SBP-2 device - login timed-out");
+ SBP2_ERR("Error logging into SBP-2 device - timed out");
return -EIO;
}
- /*
- * Check status
- */
- if (STATUS_GET_RESP(scsi_id->status_block.ORB_offset_hi_misc) ||
- STATUS_GET_DEAD_BIT(scsi_id->status_block.ORB_offset_hi_misc) ||
- STATUS_GET_SBP_STATUS(scsi_id->status_block.ORB_offset_hi_misc)) {
-
- SBP2_ERR("Error logging into SBP-2 device - login failed");
+ if (STATUS_TEST_RDS(scsi_id->status_block.ORB_offset_hi_misc)) {
+ SBP2_ERR("Error logging into SBP-2 device - failed");
return -EIO;
}
@@ -1333,9 +1324,7 @@ static int sbp2_login_device(struct scsi
scsi_id->sbp2_command_block_agent_addr &= 0x0000ffffffffffffULL;
SBP2_INFO("Logged into SBP-2 device");
-
return 0;
-
}
/*
@@ -1466,25 +1455,17 @@ static int sbp2_reconnect_device(struct
* Sanity. Make sure status returned matches reconnect orb.
*/
if (scsi_id->status_block.ORB_offset_lo != scsi_id->reconnect_orb_dma) {
- SBP2_ERR("Error reconnecting to SBP-2 device - reconnect timed-out");
+ SBP2_ERR("Error reconnecting to SBP-2 device - timed out");
return -EIO;
}
- /*
- * Check status
- */
- if (STATUS_GET_RESP(scsi_id->status_block.ORB_offset_hi_misc) ||
- STATUS_GET_DEAD_BIT(scsi_id->status_block.ORB_offset_hi_misc) ||
- STATUS_GET_SBP_STATUS(scsi_id->status_block.ORB_offset_hi_misc)) {
-
- SBP2_ERR("Error reconnecting to SBP-2 device - reconnect failed");
+ if (STATUS_TEST_RDS(scsi_id->status_block.ORB_offset_hi_misc)) {
+ SBP2_ERR("Error reconnecting to SBP-2 device - failed");
return -EIO;
}
HPSB_DEBUG("Reconnected to SBP-2 device");
-
return 0;
-
}
/*
@@ -2115,18 +2096,19 @@ static int sbp2_handle_status_write(stru
sbp2util_packet_dump(data, length, "sbp2 status write by device", (u32)addr);
- if (!host) {
+ if (unlikely(length < 8 || length > sizeof(struct sbp2_status_block))) {
+ SBP2_ERR("Wrong size of status block");
+ return RCODE_ADDRESS_ERROR;
+ }
+ if (unlikely(!host)) {
SBP2_ERR("host is NULL - this is bad!");
return RCODE_ADDRESS_ERROR;
}
-
hi = hpsb_get_hostinfo(&sbp2_highlevel, host);
-
- if (!hi) {
+ if (unlikely(!hi)) {
SBP2_ERR("host info is NULL - this is bad!");
return RCODE_ADDRESS_ERROR;
}
-
/*
* Find our scsi_id structure by looking at the status fifo address
* written to by the sbp2 device.
@@ -2138,8 +2120,7 @@ static int sbp2_handle_status_write(stru
break;
}
}
-
- if (!scsi_id) {
+ if (unlikely(!scsi_id)) {
SBP2_ERR("scsi_id is NULL - device is gone?");
return RCODE_ADDRESS_ERROR;
}
@@ -2156,12 +2137,14 @@ static int sbp2_handle_status_write(stru
sbp2util_be32_to_cpu_buffer(sb, 8);
/*
- * Handle command ORB status here if necessary. First, need to match
- * status with command.
+ * Ignore unsolicited status. Handle command ORB status.
*/
- command = sbp2util_find_command_for_orb(scsi_id, sb->ORB_offset_lo);
+ if (unlikely(STATUS_GET_SRC(sb->ORB_offset_hi_misc) == 2))
+ command = NULL;
+ else
+ command = sbp2util_find_command_for_orb(scsi_id,
+ sb->ORB_offset_lo);
if (command) {
-
SBP2_DEBUG("Found status for command ORB");
pci_dma_sync_single_for_cpu(hi->host->pdev, command->command_orb_dma,
sizeof(struct sbp2_command_orb),
@@ -2177,16 +2160,23 @@ static int sbp2_handle_status_write(stru
* Matched status with command, now grab scsi command pointers
* and check status.
*/
+ /*
+ * FIXME: If the src field in the status is 1, the ORB DMA must
+ * not be reused until status for a subsequent ORB is received.
+ */
SCpnt = command->Current_SCpnt;
spin_lock_irqsave(&scsi_id->sbp2_command_orb_lock, flags);
sbp2util_mark_command_completed(scsi_id, command);
spin_unlock_irqrestore(&scsi_id->sbp2_command_orb_lock, flags);
if (SCpnt) {
+ if (STATUS_TEST_RS(sb->ORB_offset_hi_misc))
+ scsi_status =
+ SBP2_SCSI_STATUS_COMMAND_TERMINATED;
/*
* See if the target stored any scsi status information.
*/
- if (STATUS_GET_LENGTH(sb->ORB_offset_hi_misc) > 1) {
+ if (STATUS_GET_LEN(sb->ORB_offset_hi_misc) > 1) {
SBP2_DEBUG("CHECK CONDITION");
scsi_status = sbp2_status_to_sense_data(
(unchar *)sb, SCpnt->sense_buffer);
@@ -2196,7 +2186,7 @@ static int sbp2_handle_status_write(stru
* Check to see if the dead bit is set. If so, we'll
* have to initiate a fetch agent reset.
*/
- if (STATUS_GET_DEAD_BIT(sb->ORB_offset_hi_misc)) {
+ if (STATUS_TEST_D(sb->ORB_offset_hi_misc)) {
SBP2_DEBUG("Dead bit set - "
"initiating fetch agent reset");
sbp2_agent_reset(scsi_id, 0);
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists