Linux version 2.6.18-rc3-git1 (gcc version 3.3.5 (Debian 1:3.3.5-13)) #1 Wed Aug 2 17:45:06 CEST 2006 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001fff0000 (usable) BIOS-e820: 000000001fff0000 - 000000001fffffc0 (ACPI data) BIOS-e820: 000000001fffffc0 - 0000000020000000 (ACPI NVS) BIOS-e820: 00000000ffb80000 - 00000000ffc00000 (reserved) BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved) 511MB LOWMEM available. On node 0 totalpages: 131056 DMA zone: 4096 pages, LIFO batch:0 Normal zone: 126960 pages, LIFO batch:31 DMI 2.3 present. ACPI: RSDP (v000 OID_00 ) @ 0x000e6010 ACPI: RSDT (v001 INSYDE RSDT_000 0x00000001 _CSI 0x00010101) @ 0x1fffa9e0 ACPI: FADT (v001 INSYDE FACP_000 0x00000100 _CSI 0x00010101) @ 0x1ffffb00 ACPI: BOOT (v001 INSYDE SYS_BOOT 0x00000100 _CSI 0x00010101) @ 0x1ffffb90 ACPI: DBGP (v001 INSYDE DBGP_000 0x00000100 _CSI 0x00010101) @ 0x1ffffbc0 ACPI: SSDT (v001 INSYDE GV3Ref 0x00002000 INTL 0x20021002) @ 0x1fffaa20 ACPI: DSDT (v001 TOSINV INT810 0x00001002 INTL 0x02002036) @ 0x00000000 ACPI: PM-Timer IO Port: 0x1008 Allocating PCI resources starting at 30000000 (gap: 20000000:dfb80000) Detected 1594.902 MHz processor. Built 1 zonelists. Total pages: 131056 Kernel command line: root=/dev/hda3 ro resume=/dev/hda2 pci=assign-busses 1 init=/bin/bash Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 PID hash table entries: 2048 (order: 11, 8192 bytes) Console: colour VGA+ 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 516756k/524224k available (1425k kernel code, 6916k reserved, 607k data, 136k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 3191.69 BogoMIPS (lpj=6383380) Mount-cache hash table entries: 512 CPU: After generic identify, caps: afe9f9bf 00000000 00000000 00000000 00000180 00000000 00000000 CPU: After vendor identify, caps: afe9f9bf 00000000 00000000 00000000 00000180 00000000 00000000 CPU: L1 I cache: 32K, L1 D cache: 32K CPU: L2 cache: 2048K CPU: After all inits, caps: afe9f9bf 00000000 00000000 00000040 00000180 00000000 00000000 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. Compat vDSO mapped to ffffe000. CPU: Intel(R) Pentium(R) M processor 1.60GHz stepping 06 Checking 'hlt' instruction... OK. ACPI: Core revision 20060707 ACPI: setting ELCR to 0200 (from 0800) NET: Registered protocol family 16 ACPI: ACPI Dock Station Driver ACPI: bus type pci registered PCI: PCI BIOS revision 2.10 entry at 0xe9db4, last bus=2 Setting up standard PCI resources ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: PCI Root Bridge [PCI0] (0000:00) PCI: Probing PCI hardware (bus 00) ACPI: Assume root bridge [\_SB_.PCI0] bus is 0 PCI quirk: region 1000-107f claimed by ICH4 ACPI/GPIO/TCO PCI quirk: region 1300-133f claimed by ICH4 GPIO PCI: Ignoring BAR0-3 of IDE controller 0000:00:1f.1 Boot video device is 0000:01:00.0 PCI: Transparent bridge - 0000:00:1e.0 ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PCI2._PRT] ACPI: PCI Interrupt Link [LNKA] (IRQs *11) ACPI: PCI Interrupt Link [LNKB] (IRQs *11) ACPI: PCI Interrupt Link [LNKC] (IRQs *11) ACPI: PCI Interrupt Link [LNKD] (IRQs *11) ACPI: PCI Interrupt Link [LNKE] (IRQs 6) *11 ACPI: PCI Interrupt Link [LNKF] (IRQs 11) *0, disabled. ACPI: PCI Interrupt Link [LNKG] (IRQs 11) *0, disabled. ACPI: PCI Interrupt Link [LNKH] (IRQs 11) *0, disabled. ACPI: Embedded Controller [EC0] (gpe 16) interrupt mode. ACPI: Power Resource [PFA1] (off) ACPI: Power Resource [PFA0] (off) Linux Plug and Play Support v0.97 (c) Adam Belay PCI: Using ACPI for IRQ routing PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report PCI: Bridge: 0000:00:01.0 IO window: c000-dfff MEM window: e0000000-efffffff PREFETCH window: a0000000-afffffff PCI: Bus 3, cardbus bridge: 0000:02:09.0 IO window: 0000a400-0000a4ff IO window: 0000a800-0000a8ff PREFETCH window: 90000000-91ffffff MEM window: d2000000-d3ffffff PCI: Bus 7, cardbus bridge: 0000:02:09.1 IO window: 0000ac00-0000acff IO window: 0000b000-0000b0ff PREFETCH window: 92000000-93ffffff MEM window: d4000000-d5ffffff PCI: Bridge: 0000:00:1e.0 IO window: a000-bfff MEM window: d0000000-dfffffff PREFETCH window: 90000000-9fffffff PCI: Setting latency timer of device 0000:00:1e.0 to 64 ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11 PCI: setting IRQ 11 as level-triggered ACPI: PCI Interrupt 0000:02:09.0[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11 ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11 ACPI: PCI Interrupt 0000:02:09.1[B] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11 NET: Registered protocol family 2 IP route cache hash table entries: 4096 (order: 2, 16384 bytes) TCP established hash table entries: 16384 (order: 4, 65536 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 16384 bind 8192) TCP reno registered Simple Boot Flag at 0x37 set to 0x1 Machine check exception polling timer started. VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) Initializing Cryptographic API io scheduler noop registered io scheduler anticipatory registered (default) io scheduler deadline registered io scheduler cfq registered pci 0000:00:1d.0: uhci_check_and_reset_hc: legsup = 0x0f30 pci 0000:00:1d.0: Performing full reset pci 0000:00:1d.1: uhci_check_and_reset_hc: legsup = 0x0030 pci 0000:00:1d.1: Performing full reset pci 0000:00:1d.2: uhci_check_and_reset_hc: legsup = 0x0030 pci 0000:00:1d.2: Performing full reset ibm_acpi: ec object not found isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found toshiba: not a supported Toshiba laptop RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH4: IDE controller at PCI slot 0000:00:1f.1 PCI: Enabling device 0000:00:1f.1 (0005 -> 0007) ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11 ACPI: PCI Interrupt 0000:00:1f.1[A] -> Link [LNKC] -> GSI 11 (level, low) -> IRQ 11 ICH4: chipset revision 3 ICH4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x1100-0x1107, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x1108-0x110f, BIOS settings: hdc:DMA, hdd:pio Probing IDE interface ide0... hda: IC25N060ATMR04-0, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: DW-224E, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 hda: max request size: 512KiB hda: 117210240 sectors (60011 MB) w/7884KiB Cache, CHS=16383/255/63, UDMA(100) hda: cache flushes supported hda: hda1 hda2 hda3 PNP: No PS/2 controller found. Probing ports directly. i8042.c: Detected active multiplexing controller, rev 1.1. serio: i8042 AUX0 port at 0x60,0x64 irq 12 serio: i8042 AUX1 port at 0x60,0x64 irq 12 serio: i8042 AUX2 port at 0x60,0x64 irq 12 serio: i8042 AUX3 port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 mice: PS/2 mouse device common for all mice TCP bic registered NET: Registered protocol family 8 NET: Registered protocol family 20 ieee80211: 802.11 data/management/control stack, git-1.1.13 ieee80211: Copyright (C) 2004-2005 Intel Corporation ieee80211_crypt: registered algorithm 'NULL' ieee80211_crypt: registered algorithm 'WEP' ieee80211_crypt: registered algorithm 'CCMP' ieee80211_crypt: registered algorithm 'TKIP' Using IPI Shortcut mode ACPI: (supports S0 S3 S4 S5) Time: tsc clocksource has been installed. input: AT Translated Set 2 keyboard as /class/input/input0