linux-kernel - Re: [RFC PATCH] nForce4 ADMA with NCQ: It's aliiiive..

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-ID: <20061011103038.GK6515@kernel.dk>
Date:	Wed, 11 Oct 2006 12:30:38 +0200
From:	Jens Axboe <jens.axboe@...cle.com>
To:	Robert Hancock <hancockr@...w.ca>
Cc:	Allen Martin <AMartin@...dia.com>, Jeff Garzik <jeff@...zik.org>,
	linux-kernel <linux-kernel@...r.kernel.org>,
	linux-ide@...r.kernel.org, prakash@...noor.de
Subject: Re: [RFC PATCH] nForce4 ADMA with NCQ: It's aliiiive..

On Tue, Oct 10 2006, Robert Hancock wrote:
> Allen Martin wrote:
> >>But I really don't think that is necessary.  I will take a 
> >>look at docs and see how things match up, when I am much more 
> >>awake.  Most likely you need to be using another set of 
> >>registers, and be all MMIO, all the time.
> >
> >You shouldn't be touching BM registers when ADMA is enabled, it can
> >cause bad things to happen.
> >
> >You should be using BM registers when doing ATAPI protocol though, as it
> >doesn't work through ADMA.  So I wouldn't say you should be using MMIO
> >all the time.
> >
> >-Allen
> 
> OK, I've updated the code to take this into account, an updated patch is 
> attached. However, this does raise an issue. If we have to fall back to 
> legacy mode to do ATAPI DMA, this means that we can't do 64-bit DMA for 
> such transfers. Since by the time the driver gets a request the SGs have 
> already been created based on the set DMA mask, the only way I can see 
> to handle this is to either allow ATAPI DMA or 64-bit DMA, not both. 
> I've chosen to default to 64-bit DMA in this version, but there is a 
> module parameter which allows overriding this if you care more about 
> using ATAPI devices than efficiency with over 4GB of RAM. I'm open to 
> suggestions on a better way to handle this..

Should be easily fixable - in general, set 64-bit dma mask. Then when
you detect an atapi device, lower the dma mask settings to 32-bit dma
for that device only. So the pci device in question gets a full 64-bit
dma mask, the attached scsi devices can have lower masks if necessary.
I'd suggest doing this off slave config.

-- 
Jens Axboe

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/