Linux version 2.6.18.1 (root@willow.de) (gcc version 4.0.0 20050423 (Red Hat 4.0.0-2)) #7 Sun Oct 29 13:53:40 CET 2006 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000014000000 (usable) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 320MB LOWMEM available. On node 0 totalpages: 81920 DMA zone: 4096 pages, LIFO batch:0 Normal zone: 77824 pages, LIFO batch:15 DMI 2.1 present. ACPI: Unable to locate RSDP Allocating PCI resources starting at 20000000 (gap: 14000000:ebff0000) Detected 400.998 MHz processor. Built 1 zonelists. Total pages: 81920 Kernel command line: BOOT_IMAGE=2.6.18.1poll root=801 ide2=noprobe ide3=noprobe ide4=noprobe ide5=noprobe ro root=/dev/sda1 usb-storage.delay_use=0 irqpoll ide_setup: ide2=noprobe ide_setup: ide3=noprobe ide_setup: ide4=noprobe ide_setup: ide5=noprobe Misrouted IRQ fixup and polling support enabled This may significantly impact system performance Initializing CPU#0 PID hash table entries: 2048 (order: 11, 8192 bytes) Console: colour VGA+ 80x25 Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 321460k/327680k available (1696k kernel code, 5736k reserved, 635k data, 204k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 802.62 BogoMIPS (lpj=1605255) Mount-cache hash table entries: 512 CPU: After generic identify, caps: 008021bf 808029bf 00000000 00000000 00000000 00000000 00000000 CPU: After vendor identify, caps: 008021bf 808029bf 00000000 00000000 00000000 00000000 00000000 CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line) CPU: After all inits, caps: 008021bf 808029bf 00000000 00000002 00000000 00000000 00000000 CPU: AMD-K6(tm) 3D processor stepping 0c Checking 'hlt' instruction... OK. NET: Registered protocol family 16 EISA bus registered PCI: PCI BIOS revision 2.10 entry at 0xfb3c0, last bus=1 PCI: Using configuration type 1 Setting up standard PCI resources ACPI: Interpreter disabled. SCSI subsystem initialized usbcore: registered new driver usbfs usbcore: registered new driver hub PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI quirk: region 4000-40ff claimed by vt82c586 ACPI PCI: Using IRQ router VIA [1106/0586] at 0000:00:07.0 PCI: Bridge: 0000:00:01.0 IO window: d000-dfff MEM window: disabled. PREFETCH window: disabled. PCI: Setting latency timer of device 0000:00:01.0 to 64 NET: Registered protocol family 2 IP route cache hash table entries: 4096 (order: 2, 16384 bytes) TCP established hash table entries: 16384 (order: 4, 65536 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 16384 bind 8192) TCP reno registered Initializing Cryptographic API io scheduler noop registered io scheduler deadline registered (default) Activating ISA DMA hang workarounds. Real Time Clock Driver v1.12ac loop: loaded (max 8 devices) PCI: setting IRQ 5 as level-triggered PCI: Found IRQ 5 for device 0000:00:12.0 PCI: Sharing IRQ 5 with 0000:00:14.1 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html 0000:00:12.0: 3Com PCI 3c905B Cyclone 100baseTx at d4800000. PCI: setting IRQ 9 as level-triggered PCI: Found IRQ 9 for device 0000:00:13.0 PCI: Sharing IRQ 9 with 0000:00:14.2 0000:00:13.0: 3Com PCI 3c905C Tornado at d4802000. PPP generic driver version 2.4.2 PPP Deflate Compression module registered PPP BSD Compression module registered NET: Registered protocol family 24 Linux video capture interface: v2.00 saa7146: register extension 'budget dvb'. PCI: setting IRQ 10 as level-triggered PCI: Found IRQ 10 for device 0000:00:11.0 PCI: Sharing IRQ 10 with 0000:00:14.0 saa7146: found saa7146 @ mem d4804000 (revision 1, irq 10) (0x13c2,0x1003). saa7146 (0): dma buffer size 192512 DVB: registering new adapter (TT-Budget/WinTV-NOVA-S PCI). adapter has MAC addr = 00:d0:5c:1f:c0:b6 DVB: registering frontend 0 (ST STV0299 DVB-S)... Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller at PCI slot 0000:00:07.1 VP_IDE: chipset revision 6 VP_IDE: not 100% native mode: will probe irqs later VP_IDE: VIA vt82c586b (rev 47) IDE UDMA33 controller on pci0000:00:07.1 ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:DMA, hdd:DMA Probing IDE interface ide0... hda: ExcelStor Technology J360, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: Maxtor 6Y160L0, ATA DISK drive ide1 at 0x170-0x177,0x376 on irq 15 hda: max request size: 512KiB hda: 120103200 sectors (61492 MB) w/1821KiB Cache, CHS=16383/255/63, UDMA(33) hda: cache flushes supported hda: hda1 hda2 hdc: max request size: 512KiB hdc: 320173056 sectors (163928 MB) w/2048KiB Cache, CHS=19929/255/63, UDMA(33) hdc: cache flushes supported hdc: hdc1 usbmon: debugfs is not available PCI: setting IRQ 15 as level-triggered PCI: Found IRQ 15 for device 0000:00:14.3 IRQ routing conflict for 0000:00:07.2, have irq 11, want irq 15 IRQ routing conflict for 0000:00:14.3, have irq 11, want irq 15 ehci_hcd 0000:00:14.3: EHCI Host Controller ehci_hcd 0000:00:14.3: new USB bus registered, assigned bus number 1 ehci_hcd 0000:00:14.3: debug port 1 ehci_hcd 0000:00:14.3: irq 11, io mem 0xe6006000 ehci_hcd 0000:00:14.3: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 6 ports detected USB Universal Host Controller Interface driver v3.0 PCI: Found IRQ 15 for device 0000:00:07.2 IRQ routing conflict for 0000:00:07.2, have irq 11, want irq 15 IRQ routing conflict for 0000:00:14.3, have irq 11, want irq 15 uhci_hcd 0000:00:07.2: UHCI Host Controller uhci_hcd 0000:00:07.2: new USB bus registered, assigned bus number 2 uhci_hcd 0000:00:07.2: irq 11, io base 0x0000e400 usb usb2: configuration #1 chosen from 1 choice hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected Initializing USB Mass Storage driver... usb 1-2: new high speed USB device using ehci_hcd and address 2 usb 1-2: configuration #1 chosen from 1 choice scsi0 : SCSI emulation for USB Mass Storage devices usbcore: registered new driver usb-storage USB Mass Storage support registered. usb-storage: device found at 2 Vendor: USB 2.0 Model: Memory Adapter Rev: Type: Direct-Access ANSI SCSI revision: 02 serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 mice: PS/2 mouse device common for all mice SCSI device sda: 251904 512-byte hdwr sectors (129 MB) sda: Write Protect is off sda: Mode Sense: 03 00 00 00 sda: assuming drive cache: write through input: PC Speaker as /class/input/input0 SCSI device sda: 251904 512-byte hdwr sectors (129 MB) sda: Write Protect is off sda: Mode Sense: 03 00 00 00 sda: assuming drive cache: write through sda: sda1 EISA: Probing bus 0 at eisa.0 ip_conntrack version 2.4 (2560 buckets, 20480 max) - 204 bytes per conntrack sd 0:0:0:0: Attached scsi removable disk sda usb-storage: device scan complete ip_tables: (C) 2000-2006 Netfilter Core Team irq 15: nobody cared (try booting with the "irqpoll" option) [] __report_bad_irq+0x2b/0x69 [] note_interrupt+0x189/0x1c3 [] __do_IRQ+0x72/0xa1 [] do_IRQ+0x40/0x4d [] common_interrupt+0x1a/0x20 [] default_idle+0x31/0x59 [] cpu_idle+0x38/0x4d [] start_kernel+0x246/0x248 handlers: [] (ide_intr+0x0/0x16e) Disabling IRQ #15 TCP bic registered Initializing IPsec netlink socket NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 15 Using IPI Shortcut mode Time: tsc clocksource has been installed. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 204k freed input: AT Translated Set 2 keyboard as /class/input/input1 input: AT Translated Set 2 keyboard as /class/input/input2 EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended ReiserFS: hda2: found reiserfs format "3.6" with standard journal ReiserFS: hda2: using ordered data mode ReiserFS: hda2: journal params: device hda2, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30 ReiserFS: hda2: checking transaction log (hda2) ReiserFS: hda2: Using r5 hash to sort names PM: Writing back config space on device 0000:00:12.0 at offset 1 (was 82100007, writing 2100007) eth0: setting full-duplex. PM: Writing back config space on device 0000:00:13.0 at offset 1 (was 82100007, writing 2100007) dsl0: setting full-duplex.