| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20070102023255.GA21546@thunk.org>
Date: Mon, 1 Jan 2007 21:32:55 -0500
From: Theodore Tso <tytso@....edu>
To: Linus Torvalds <torvalds@...l.org>
Cc: Alan <alan@...rguk.ukuu.org.uk>, Jeff Garzik <jgarzik@...ox.com>,
Alessandro Suardi <alessandro.suardi@...il.com>,
Linux Kernel Mailing List <linux-kernel@...r.kernel.org>
Subject: Re: Happy New Year (and v2.6.20-rc3 released)
On Mon, Jan 01, 2007 at 03:34:53PM -0800, Linus Torvalds wrote:
>
>
> On Mon, 1 Jan 2007, Alan wrote:
> >
> > Want a fix Linus given Jeff is away ?
>
> Send it over, and please cc Alessandro and others that can test it. Things
> obviously aren't broken on _my_ machines ;)
Can I get a copy of the fix for testing as well? I can confirm that
Alan's 368c73d4f689dae0807d0a2aa74c61fd2b9b075f breaks for me on my
T60 thinkpad. Unfortunately I missed the earlier discussion on this,
and I didn't have time to test -rc1 and -rc2, so I spent a few hours
doing the git bisection in order to determine that it was Alan's
2b9b075f patch which was breaking -rc3 for me.
My current plan for testing -rc3 was to back out Alan's patch
(attached below for others' convenience), but I'm happy to test an
alternative fix.
- Ted
Revert "PCI: quirks: fix the festering mess that claims to handle IDE quirks"
This reverts commit 368c73d4f689dae0807d0a2aa74c61fd2b9b075f.
This is needed to fix booting on a Thinkpad T60. Without this patch,
we see the following error messages, and the SATA drive in the laptop
isn't detected, with the following messages printed during the boot
sequence:
ata_piix 0000:00:1f.2: MAP [ P0 P2 IDE IDE ]
ACPI: PCI Interrupt 0000:00:1f.2[B] -> GSI 16 (level, low) -> IRQ 16
PCI: Unable to reserve I/O Region #1:8@1f0 for device 0000:00:1f.2
ata_piix: probe of 0000:00:1f.2 failed with error -16
Signed-off-by: "Theodore Ts'o" <tytso@....edu>
---
arch/i386/pci/fixup.c | 46 ++++++++++++++++++++++++++++++++++++++
drivers/pci/probe.c | 27 ----------------------
drivers/pci/quirks.c | 59 ++++++++++++++++++++++++++++++++++++++++++++++--
3 files changed, 102 insertions(+), 30 deletions(-)
diff --git a/arch/i386/pci/fixup.c b/arch/i386/pci/fixup.c
index 8053b17..422483e 100644
--- a/arch/i386/pci/fixup.c
+++ b/arch/i386/pci/fixup.c
@@ -74,6 +74,52 @@ static void __devinit pci_fixup_ncr53c810(struct pci_dev *d)
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_NCR, PCI_DEVICE_ID_NCR_53C810, pci_fixup_ncr53c810);
+static void __devinit pci_fixup_ide_bases(struct pci_dev *d)
+{
+ int i;
+
+ /*
+ * PCI IDE controllers use non-standard I/O port decoding, respect it.
+ */
+ if ((d->class >> 8) != PCI_CLASS_STORAGE_IDE)
+ return;
+ DBG("PCI: IDE base address fixup for %s\n", pci_name(d));
+ for(i=0; i<4; i++) {
+ struct resource *r = &d->resource[i];
+ if ((r->start & ~0x80) == 0x374) {
+ r->start |= 2;
+ r->end = r->start;
+ }
+ }
+}
+DECLARE_PCI_FIXUP_HEADER(PCI_ANY_ID, PCI_ANY_ID, pci_fixup_ide_bases);
+
+static void __devinit pci_fixup_ide_trash(struct pci_dev *d)
+{
+ int i;
+
+ /*
+ * Runs the fixup only for the first IDE controller
+ * (Shai Fultheim - shai@...on.com)
+ */
+ static int called = 0;
+ if (called)
+ return;
+ called = 1;
+
+ /*
+ * There exist PCI IDE controllers which have utter garbage
+ * in first four base registers. Ignore that.
+ */
+ DBG("PCI: IDE base address trash cleared for %s\n", pci_name(d));
+ for(i=0; i<4; i++)
+ d->resource[i].start = d->resource[i].end = d->resource[i].flags = 0;
+}
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_SI, PCI_DEVICE_ID_SI_5513, pci_fixup_ide_trash);
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, pci_fixup_ide_trash);
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_11, pci_fixup_ide_trash);
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801DB_9, pci_fixup_ide_trash);
+
static void __devinit pci_fixup_latency(struct pci_dev *d)
{
/*
diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c
index 0e0401d..8e077b1 100644
--- a/drivers/pci/probe.c
+++ b/drivers/pci/probe.c
@@ -681,33 +681,6 @@ static int pci_setup_device(struct pci_dev * dev)
pci_read_bases(dev, 6, PCI_ROM_ADDRESS);
pci_read_config_word(dev, PCI_SUBSYSTEM_VENDOR_ID, &dev->subsystem_vendor);
pci_read_config_word(dev, PCI_SUBSYSTEM_ID, &dev->subsystem_device);
-
- /*
- * Do the ugly legacy mode stuff here rather than broken chip
- * quirk code. Legacy mode ATA controllers have fixed
- * addresses. These are not always echoed in BAR0-3, and
- * BAR0-3 in a few cases contain junk!
- */
- if (class == PCI_CLASS_STORAGE_IDE) {
- u8 progif;
- pci_read_config_byte(dev, PCI_CLASS_PROG, &progif);
- if ((progif & 1) == 0) {
- dev->resource[0].start = 0x1F0;
- dev->resource[0].end = 0x1F7;
- dev->resource[0].flags = LEGACY_IO_RESOURCE;
- dev->resource[1].start = 0x3F6;
- dev->resource[1].end = 0x3F6;
- dev->resource[1].flags = LEGACY_IO_RESOURCE;
- }
- if ((progif & 4) == 0) {
- dev->resource[2].start = 0x170;
- dev->resource[2].end = 0x177;
- dev->resource[2].flags = LEGACY_IO_RESOURCE;
- dev->resource[3].start = 0x376;
- dev->resource[3].end = 0x376;
- dev->resource[3].flags = LEGACY_IO_RESOURCE;
- }
- }
break;
case PCI_HEADER_TYPE_BRIDGE: /* bridge header */
diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c
index 8f0322d..d6c4130 100644
--- a/drivers/pci/quirks.c
+++ b/drivers/pci/quirks.c
@@ -827,6 +827,56 @@ DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_CYRIX, PCI_DEVICE_ID_CYRIX_PCI_MASTER, qui
DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_CYRIX, PCI_DEVICE_ID_CYRIX_PCI_MASTER, quirk_mediagx_master );
/*
+ * As per PCI spec, ignore base address registers 0-3 of the IDE controllers
+ * running in Compatible mode (bits 0 and 2 in the ProgIf for primary and
+ * secondary channels respectively). If the device reports Compatible mode
+ * but does use BAR0-3 for address decoding, we assume that firmware has
+ * programmed these BARs with standard values (0x1f0,0x3f4 and 0x170,0x374).
+ * Exceptions (if they exist) must be handled in chip/architecture specific
+ * fixups.
+ *
+ * Note: for non x86 people. You may need an arch specific quirk to handle
+ * moving IDE devices to native mode as well. Some plug in card devices power
+ * up in compatible mode and assume the BIOS will adjust them.
+ *
+ * Q: should we load the 0x1f0,0x3f4 into the registers or zap them as
+ * we do now ? We don't want is pci_enable_device to come along
+ * and assign new resources. Both approaches work for that.
+ */
+static void __devinit quirk_ide_bases(struct pci_dev *dev)
+{
+ struct resource *res;
+ int first_bar = 2, last_bar = 0;
+
+ if ((dev->class >> 8) != PCI_CLASS_STORAGE_IDE)
+ return;
+
+ res = &dev->resource[0];
+
+ /* primary channel: ProgIf bit 0, BAR0, BAR1 */
+ if (!(dev->class & 1) && (res[0].flags || res[1].flags)) {
+ res[0].start = res[0].end = res[0].flags = 0;
+ res[1].start = res[1].end = res[1].flags = 0;
+ first_bar = 0;
+ last_bar = 1;
+ }
+
+ /* secondary channel: ProgIf bit 2, BAR2, BAR3 */
+ if (!(dev->class & 4) && (res[2].flags || res[3].flags)) {
+ res[2].start = res[2].end = res[2].flags = 0;
+ res[3].start = res[3].end = res[3].flags = 0;
+ last_bar = 3;
+ }
+
+ if (!last_bar)
+ return;
+
+ printk(KERN_INFO "PCI: Ignoring BAR%d-%d of IDE controller %s\n",
+ first_bar, last_bar, pci_name(dev));
+}
+DECLARE_PCI_FIXUP_HEADER(PCI_ANY_ID, PCI_ANY_ID, quirk_ide_bases);
+
+/*
* Ensure C0 rev restreaming is off. This is normally done by
* the BIOS but in the odd case it is not the results are corruption
* hence the presence of a Linux check
@@ -878,10 +928,11 @@ static void __devinit quirk_svwks_csb5ide(struct pci_dev *pdev)
prog &= ~5;
pdev->class &= ~5;
pci_write_config_byte(pdev, PCI_CLASS_PROG, prog);
- /* PCI layer will sort out resources */
+ /* need to re-assign BARs for compat mode */
+ quirk_ide_bases(pdev);
}
}
-DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_SERVERWORKS, PCI_DEVICE_ID_SERVERWORKS_CSB5IDE, quirk_svwks_csb5ide );
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_SERVERWORKS, PCI_DEVICE_ID_SERVERWORKS_CSB5IDE, quirk_svwks_csb5ide );
/*
* Intel 82801CAM ICH3-M datasheet says IDE modes must be the same
@@ -897,9 +948,11 @@ static void __init quirk_ide_samemode(struct pci_dev *pdev)
prog &= ~5;
pdev->class &= ~5;
pci_write_config_byte(pdev, PCI_CLASS_PROG, prog);
+ /* need to re-assign BARs for compat mode */
+ quirk_ide_bases(pdev);
}
}
-DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, quirk_ide_samemode);
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_10, quirk_ide_samemode);
/* This was originally an Alpha specific thing, but it really fits here.
* The i82375 PCI/EISA bridge appears as non-classified. Fix that.
--
1.5.0.rc0.g1d42
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists