--- dmesg.bad	2007-01-24 10:06:46.000000000 +1100
+++ dmesg.good2	2007-01-24 10:05:37.000000000 +1100
@@ -1,4 +1,4 @@
-Linux version 2.6.20-rc5 (npiggin@didi) (gcc version 4.1.2 20061020 (prerelease) (Debian 4.1.1-17)) #27 SMP PREEMPT Tue Jan 23 17:13:01 EST 2007
+Linux version 2.6.20-rc5 (npiggin@didi) (gcc version 4.1.2 20061020 (prerelease) (Debian 4.1.1-17)) #3 SMP PREEMPT Tue Jan 23 22:41:31 EST 2007
 BIOS-provided physical RAM map:
 sanitize start
 sanitize end
@@ -58,7 +58,7 @@
 Enabling APIC mode:  Flat.  Using 1 I/O APICs
 Using ACPI (MADT) for SMP configuration information
 Allocating PCI resources starting at 20000000 (gap: 10000000:eec00000)
-Detected 996.609 MHz processor.
+Detected 996.633 MHz processor.
 Built 1 zonelists.  Total pages: 65009
 Kernel command line: BOOT_IMAGE=linuxtest2 ro root=305 nmi_watchdog=1
 mapped APIC to ffffd000 (fee00000)
@@ -80,7 +80,7 @@
       .data : 0xc0327a4f - 0xc03d128c   ( 678 kB)
       .text : 0xc0100000 - 0xc0327a4f   (2206 kB)
 Checking if this processor honours the WP bit even in supervisor mode... Ok.
-Calibrating delay using timer specific routine.. 1994.39 BogoMIPS (lpj=997195)
+Calibrating delay using timer specific routine.. 1994.41 BogoMIPS (lpj=997207)
 Mount-cache hash table entries: 512
 CPU: After generic identify, caps: 0383fbff 00000000 00000000 00000000 00000000 00000000 00000000
 CPU: L1 I cache: 16K, L1 D cache: 16K
@@ -95,7 +95,7 @@
 Booting processor 1/1 eip 2000
 CPU 1 irqstacks, hard=c0411000 soft=c040f000
 Initializing CPU#1
-Calibrating delay using timer specific routine.. 1992.80 BogoMIPS (lpj=996402)
+Calibrating delay using timer specific routine.. 1992.83 BogoMIPS (lpj=996416)
 CPU: After generic identify, caps: 0383fbff 00000000 00000000 00000000 00000000 00000000 00000000
 CPU: L1 I cache: 16K, L1 D cache: 16K
 CPU: L2 cache: 256K
@@ -103,12 +103,12 @@
 Intel machine check architecture supported.
 Intel machine check reporting enabled on CPU#1.
 CPU1: Intel Pentium III (Coppermine) stepping 0a
-Total of 2 processors activated (3987.19 BogoMIPS).
+Total of 2 processors activated (3987.24 BogoMIPS).
 ENABLING IO-APIC IRQs
 ..TIMER: vector=0x31 apic1=0 pin1=2 apic2=-1 pin2=-1
 checking TSC synchronization across 2 CPUs: passed.
 Brought up 2 CPUs
-migration_cost=691
+migration_cost=689
 NET: Registered protocol family 16
 ACPI: bus type pci registered
 PCI: PCI BIOS revision 2.10 entry at 0xfdb01, last bus=1
@@ -143,6 +143,8 @@
   IO window: 9000-9fff
   MEM window: dde00000-dfefffff
   PREFETCH window: d9c00000-ddcfffff
+quirk_via_vlink 1
+quirk_via_vlink 2
 PCI: Setting latency timer of device 0000:00:01.0 to 64
 NET: Registered protocol family 2
 IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
@@ -178,6 +180,9 @@
 Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
 VP_IDE: IDE controller at PCI slot 0000:00:07.1
+quirk_via_vlink 1
+quirk_via_vlink 2
+quirk_via_vlink 3
 VP_IDE: chipset revision 6
 VP_IDE: not 100% native mode: will probe irqs later
 VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci0000:00:07.1
@@ -206,24 +211,30 @@
 Testing NMI watchdog ... OK.
 Starting balanced_irq
 Using IPI Shortcut mode
-BIOS EDD facility v0.16 2004-Jun-25, 1 devices found
 Time: tsc clocksource has been installed.
+BIOS EDD facility v0.16 2004-Jun-25, 1 devices found
 kjournald starting.  Commit interval 5 seconds
 EXT3-fs: mounted filesystem with ordered data mode.
 VFS: Mounted root (ext3 filesystem) readonly.
 Freeing unused kernel memory: 200k freed
 Real Time Clock Driver v1.12ac
+hdc: ATAPI 24X CD-ROM CD-R/RW drive, 2048kB Cache, DMA
+Uniform CD-ROM driver Revision: 3.20
+hdd: ATAPI 20X CD-ROM drive, 120kB Cache, DMA
 Floppy drive(s): fd0 is 1.44M
 FDC 0 is a post-1991 82077
 usbcore: registered new interface driver usbfs
 usbcore: registered new interface driver hub
 usbcore: registered new device driver usb
-hdc: ATAPI 24X CD-ROM CD-R/RW drive, 2048kB Cache, DMA
-Uniform CD-ROM driver Revision: 3.20
-hdd: ATAPI 20X CD-ROM drive, 120kB Cache, DMA
 USB Universal Host Controller Interface driver v3.0
 ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11
 ACPI: PCI Interrupt 0000:00:07.2[D] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
+quirk_via_vlink 1
+quirk_via_vlink 2
+quirk_via_vlink 3
+quirk_via_vlink 4
+quirk_via_vlink 5
+PCI: VIA VLink IRQ fixup for 0000:00:07.2, from 12 to 11
 uhci_hcd 0000:00:07.2: UHCI Host Controller
 uhci_hcd 0000:00:07.2: new USB bus registered, assigned bus number 1
 uhci_hcd 0000:00:07.2: irq 11, io base 0x0000cc00
@@ -231,16 +242,33 @@
 hub 1-0:1.0: USB hub found
 hub 1-0:1.0: 2 ports detected
 ACPI: PCI Interrupt 0000:00:07.3[D] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
+quirk_via_vlink 1
+quirk_via_vlink 2
+quirk_via_vlink 3
+quirk_via_vlink 4
+quirk_via_vlink 5
+PCI: VIA VLink IRQ fixup for 0000:00:07.3, from 12 to 11
 uhci_hcd 0000:00:07.3: UHCI Host Controller
 uhci_hcd 0000:00:07.3: new USB bus registered, assigned bus number 2
 uhci_hcd 0000:00:07.3: irq 11, io base 0x0000d000
 usb usb2: configuration #1 chosen from 1 choice
 hub 2-0:1.0: USB hub found
 hub 2-0:1.0: 2 ports detected
-usb 1-1: new low speed USB device using uhci_hcd and address 2
 ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 10
 ACPI: PCI Interrupt 0000:00:07.5[C] -> Link [LNKC] -> GSI 10 (level, low) -> IRQ 10
+quirk_via_vlink 1
+quirk_via_vlink 2
+quirk_via_vlink 3
+quirk_via_vlink 4
+quirk_via_vlink 5
 PCI: Setting latency timer of device 0000:00:07.5 to 64
+usb 1-1: new low speed USB device using uhci_hcd and address 2
+usb 1-1: configuration #1 chosen from 1 choice
+usbcore: registered new interface driver hiddev
+input: A4Tech USB Wheel Mouse as /class/input/input5
+input: USB HID v1.10 Mouse [A4Tech USB Wheel Mouse] on usb-0000:00:07.2-1
+usbcore: registered new interface driver usbhid
+drivers/usb/input/hid-core.c: v2.6:USB HID core driver
 Adding 254984k swap on /dev/hda9.  Priority:-1 extents:1 across:254984k
 EXT3 FS on hda5, internal journal
 kjournald starting.  Commit interval 5 seconds
@@ -251,13 +279,7 @@
 kjournald starting.  Commit interval 5 seconds
 EXT3 FS on hda8, internal journal
 EXT3-fs: mounted filesystem with ordered data mode.
-usb 1-1: configuration #1 chosen from 1 choice
 skge eth1: enabling interface
-usbcore: registered new interface driver hiddev
-input: A4Tech USB Wheel Mouse as /class/input/input5
-input: USB HID v1.10 Mouse [A4Tech USB Wheel Mouse] on usb-0000:00:07.2-1
-usbcore: registered new interface driver usbhid
-drivers/usb/input/hid-core.c: v2.6:USB HID core driver
 skge eth1: Link is up at 100 Mbps, full duplex, flow control both
 IA-32 Microcode Update Driver: v1.14a <tigran@aivazian.fsnet.co.uk>
 NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory