linux-kernel - [PATCH v2 (updated) -mm 4/9] netconsole: Add some useful tips to documentation

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [thread-next>] [day] [month] [year] [list]

Message-Id: <20070710221929.3414.80246.sendpatchset@cselinux1.cse.iitk.ac.in>
Date:	Wed, 11 Jul 2007 03:49:29 +0530
From:	Satyam Sharma <ssatyam@....iitk.ac.in>
To:	Linux Kernel Mailing List <linux-kernel@...r.kernel.org>
Cc:	Stephen Hemminger <shemminger@...ux-foundation.org>,
	Netdev <netdev@...r.kernel.org>,
	Keiichi Kii <k-keiichi@...jp.nec.com>,
	Satyam Sharma <ssatyam@....iitk.ac.in>,
	Jesper Juhl <jesper.juhl@...il.com>,
	Joel Becker <joel.becker@...cle.com>,
	Matt Mackall <mpm@...enic.com>,
	Andrew Morton <akpm@...ux-foundation.org>,
	David Miller <davem@...emloft.net>
Subject: [PATCH v2 (updated) -mm 4/9] netconsole: Add some useful tips to documentation

[4/9 (updated)] netconsole: Add some useful tips to documentation

Add some useful general-purpose tips. Also suggest solution for the frequent
problem of console_loglevel set too low numerically (i.e. for high priority
messages only) on the sender.

Cc: Matt Mackall <mpm@...enic.com>
Cc: Jesper Juhl <jesper.juhl@...il.com>
Signed-off-by: Satyam Sharma <ssatyam@....iitk.ac.in>

---

 Documentation/networking/netconsole.txt |   24 ++++++++++++++++++++++++
 1 file changed, 24 insertions(+)

---

diff -ruNp a/Documentation/networking/netconsole.txt b/Documentation/networking/netconsole.txt
--- a/Documentation/networking/netconsole.txt	2007-04-26 08:38:32.000000000 +0530
+++ b/Documentation/networking/netconsole.txt	2007-07-11 03:11:08.000000000 +0530
@@ -44,11 +44,35 @@ WARNING: the default target ethernet set
 ethernet address to send packets, which can cause increased load on
 other systems on the same ethernet segment.
 
+TIP: some LAN switches may be configured to suppress ethernet broadcasts
+so it is advised to explicitly specify the remote agents' MAC addresses
+from the config parameters passed to netconsole.
+
+TIP: to find out the MAC address of, say, 10.0.0.2, you may try using:
+
+ ping -c 1 10.0.0.2 ; /sbin/arp -n | grep 10.0.0.2
+
+TIP: in case the remote logging agent is on a separate LAN subnet than
+the sender, it is suggested to try specifying the MAC address of the
+default gateway (you may use /sbin/route -n to find it out) as the
+remote MAC address instead.
+
 NOTE: the network device (eth1 in the above case) can run any kind
 of other network traffic, netconsole is not intrusive. Netconsole
 might cause slight delays in other traffic if the volume of kernel
 messages is high, but should have no other impact.
 
+NOTE: if you find that the remote logging agent is not receiving or
+printing all messages from the sender, it is likely that you have set the
+"console_loglevel" parameter (on the sender) to only send high priority
+messages to the console. You can change this at runtime by updating
+/proc/sys/kernel/printk appropriately, say by:
+
+ echo 9 > /proc/sys/kernel/printk
+
+which would send all kernel messages to the console. Refer the proc(5)
+man page for more details.
+
 Netconsole was designed to be as instantaneous as possible, to
 enable the logging of even the most critical kernel bugs. It works
 from IRQ contexts as well, and does not enable interrupts while
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/