USB Universal Host Controller Interface driver v3.0
ACPI: PCI Interrupt 0000:00:1d.0[A] -> GSI 23 (level, low) -> IRQ 233
PCI: Setting latency timer of device 0000:00:1d.0 to 64
uhci_hcd 0000:00:1d.0: UHCI Host Controller
uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 1
uhci_hcd 0000:00:1d.0: irq 233, io base 0x00003000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ACPI: PCI Interrupt 0000:00:1d.1[B] -> GSI 22 (level, low) -> IRQ 50
PCI: Setting latency timer of device 0000:00:1d.1 to 64
uhci_hcd 0000:00:1d.1: UHCI Host Controller
uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 2
uhci_hcd 0000:00:1d.1: irq 50, io base 0x00003020
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
ACPI: PCI Interrupt 0000:00:1d.2[B] -> GSI 22 (level, low) -> IRQ 50
PCI: Setting latency timer of device 0000:00:1d.2 to 64
uhci_hcd 0000:00:1d.2: UHCI Host Controller
uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 3
uhci_hcd 0000:00:1d.2: irq 50, io base 0x00003040
usb usb3: configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
ACPI: PCI Interrupt 0000:00:1d.3[C] -> GSI 21 (level, low) -> IRQ 58
PCI: Setting latency timer of device 0000:00:1d.3 to 64
uhci_hcd 0000:00:1d.3: UHCI Host Controller
uhci_hcd 0000:00:1d.3: new USB bus registered, assigned bus number 4
uhci_hcd 0000:00:1d.3: irq 58, io base 0x00003060
usb usb4: configuration #1 chosen from 1 choice
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 2 ports detected
usb 1-1: new full speed USB device using uhci_hcd and address 2
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
ACPI: PCI Interrupt 0000:00:1d.7[D] -> GSI 20 (level, low) -> IRQ 66
PCI: Setting latency timer of device 0000:00:1d.7 to 64
ehci_hcd 0000:00:1d.7: EHCI Host Controller
ehci_hcd 0000:00:1d.7: new USB bus registered, assigned bus number 5
ehci_hcd 0000:00:1d.7: debug port 1
PCI: cache line size of 128 is not supported by device 0000:00:1d.7
ehci_hcd 0000:00:1d.7: irq 66, io mem 0xdfd00000
ehci_hcd 0000:00:1d.7: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb5: configuration #1 chosen from 1 choice
hub 5-0:1.0: USB hub found
hub 5-0:1.0: 8 ports detected
SCSI subsystem initialized
libata version 2.21 loaded.
ata_piix 0000:00:1f.2: version 2.11
ata_piix 0000:00:1f.2: MAP [ P0 P2 P1 P3 ]
ACPI: PCI Interrupt 0000:00:1f.2[B] -> GSI 19 (level, low) -> IRQ 74
PCI: Setting latency timer of device 0000:00:1f.2 to 64
scsi0 : ata_piix
scsi1 : ata_piix
ata1: SATA max UDMA/133 cmd 0x000130e8 ctl 0x000130de bmdma 0x000130b0 irq 0
ata2: SATA max UDMA/133 cmd 0x000130e0 ctl 0x000130da bmdma 0x000130b8 irq 0
usb 1-1: device not accepting address 2, error -71
ata1.00: ata_hpa_resize 1: sectors = 156250080, hpa_sectors = 156301488
ata1.00: Host Protected Area detected:
	current size: 156250080 sectors
	native size: 156301488 sectors
ata1.00: ATA-7: WDC WD800JD-19MSA1, 10.01E01, max UDMA/133
ata1.00: 156250080 sectors, multi 16: LBA48 NCQ (depth 0/32)
ata1.00: ata_hpa_resize 1: sectors = 156250080, hpa_sectors = 156301488
ata1.00: Host Protected Area detected:
	current size: 156250080 sectors
	native size: 156301488 sectors
ata1.00: configured for UDMA/133
ATA: abnormal status 0x7F on port 0x000130e7
ATA: abnormal status 0x7F on port 0x000130e7
ata2.01: ata_hpa_resize 1: sectors = 156250080, hpa_sectors = 156301488
ata2.01: Host Protected Area detected:
	current size: 156250080 sectors
	native size: 156301488 sectors
ata2.01: ATA-7: WDC WD800JD-19MSA1, 10.01E01, max UDMA/133
ata2.01: 156250080 sectors, multi 16: LBA48 NCQ (depth 0/32)
ata2.01: ata_hpa_resize 1: sectors = 156250080, hpa_sectors = 156301488
ata2.01: Host Protected Area detected:
	current size: 156250080 sectors
	native size: 156301488 sectors
ata2.01: configured for UDMA/133
  Vendor: ATA       Model: WDC WD800JD-19MS  Rev: 10.0
  Type:   Direct-Access                      ANSI SCSI revision: 05
SCSI device sda: 156250080 512-byte hdwr sectors (80000 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
SCSI device sda: 156250080 512-byte hdwr sectors (80000 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
 sda: sda1 sda2 sda3
sd 0:0:0:0: Attached scsi disk sda
  Vendor: ATA       Model: WDC WD800JD-19MS  Rev: 10.0
  Type:   Direct-Access                      ANSI SCSI revision: 05
SCSI device sdb: 156250080 512-byte hdwr sectors (80000 MB)
sdb: Write Protect is off
sdb: Mode Sense: 00 3a 00 00
SCSI device sdb: drive cache: write back
SCSI device sdb: 156250080 512-byte hdwr sectors (80000 MB)
sdb: Write Protect is off
sdb: Mode Sense: 00 3a 00 00
SCSI device sdb: drive cache: write back
 sdb:
sd 1:0:1:0: Attached scsi disk sdb
usb 1-1: new full speed USB device using uhci_hcd and address 4
usb 1-1: configuration #1 chosen from 1 choice
input: ServerEngines SE USB Device as /class/input/input0
input: USB HID v1.11 Keyboard [ServerEngines SE USB Device] on usb-0000:00:1d.0-1
input: ServerEngines SE USB Device as /class/input/input1
input: USB HID v1.11 Mouse [ServerEngines SE USB Device] on usb-0000:00:1d.0-1
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
SELinux:  Disabled at runtime.
SELinux:  Unregistering netfilter hooks
audit(1184168677.728:2): selinux=0 auid=4294967295
intel_rng: FWH not detected
input: PC Speaker as /class/input/input2
input: PS/2 Generic Mouse as /class/input/input3
ACPI: PCI Interrupt 0000:00:1f.3[B] -> GSI 19 (level, low) -> IRQ 74
hda: ATAPI 24X DVD-ROM drive, 256kB Cache, UDMA(66)
Uniform CD-ROM driver Revision: 3.20
Intel(R) PRO/1000 Network Driver - version 7.2.9-k2-NAPI
Copyright (c) 1999-2006 Intel Corporation.
ACPI: PCI Interrupt 0000:0a:00.0[A] -> GSI 16 (level, low) -> IRQ 169
PCI: Setting latency timer of device 0000:0a:00.0 to 64
e1000: 0000:0a:00.0: e1000_probe: (PCI Express:2.5Gb/s:32-bit) 00:16:e6:5c:e0:fe
sd 0:0:0:0: Attached scsi generic sg0 type 0
sd 1:0:1:0: Attached scsi generic sg1 type 0
e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network Connection
ACPI: PCI Interrupt 0000:0b:00.0[A] -> GSI 17 (level, low) -> IRQ 177
PCI: Setting latency timer of device 0000:0b:00.0 to 64
e1000: 0000:0b:00.0: e1000_probe: (PCI Express:2.5Gb/s:32-bit) 00:16:e6:5c:e0:ff
e1000: eth1: e1000_probe: Intel(R) PRO/1000 Network Connection
floppy0: no floppy controllers found
lp: driver loaded but no devices found
ACPI: Power Button (FF) [PWRF]
ACPI: Power Button (CM) [PWRB]
ibm_acpi: ec object not found