USB Universal Host Controller Interface driver v3.0 GSI 19 sharing vector 0x92 and IRQ 19 ACPI: PCI Interrupt 0000:00:1d.0[A] -> GSI 21 (level, low) -> IRQ 146 PCI: Setting latency timer of device 0000:00:1d.0 to 64 uhci_hcd 0000:00:1d.0: UHCI Host Controller uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 1 uhci_hcd 0000:00:1d.0: irq 146, io base 0x00001000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected ACPI: PCI Interrupt 0000:00:1d.1[A] -> GSI 21 (level, low) -> IRQ 146 PCI: Setting latency timer of device 0000:00:1d.1 to 64 uhci_hcd 0000:00:1d.1: UHCI Host Controller uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 2 uhci_hcd 0000:00:1d.1: irq 146, io base 0x00001020 usb usb2: configuration #1 chosen from 1 choice hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected GSI 20 sharing vector 0x9A and IRQ 20 ACPI: PCI Interrupt 0000:00:1d.2[B] -> GSI 23 (level, low) -> IRQ 154 PCI: Setting latency timer of device 0000:00:1d.2 to 64 uhci_hcd 0000:00:1d.2: UHCI Host Controller uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 3 uhci_hcd 0000:00:1d.2: irq 154, io base 0x00001040 usb usb3: configuration #1 chosen from 1 choice hub 3-0:1.0: USB hub found hub 3-0:1.0: 2 ports detected usb 1-1: new full speed USB device using uhci_hcd and address 2 GSI 21 sharing vector 0xA2 and IRQ 21 ACPI: PCI Interrupt 0000:00:1d.3[C] -> GSI 22 (level, low) -> IRQ 162 PCI: Setting latency timer of device 0000:00:1d.3 to 64 uhci_hcd 0000:00:1d.3: UHCI Host Controller uhci_hcd 0000:00:1d.3: new USB bus registered, assigned bus number 4 uhci_hcd 0000:00:1d.3: irq 162, io base 0x00001060 usb usb4: configuration #1 chosen from 1 choice hub 4-0:1.0: USB hub found hub 4-0:1.0: 2 ports detected ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) GSI 22 sharing vector 0xAA and IRQ 22 ACPI: PCI Interrupt 0000:00:1d.7[D] -> GSI 20 (level, low) -> IRQ 170 PCI: Setting latency timer of device 0000:00:1d.7 to 64 ehci_hcd 0000:00:1d.7: EHCI Host Controller ehci_hcd 0000:00:1d.7: new USB bus registered, assigned bus number 5 ehci_hcd 0000:00:1d.7: debug port 1 PCI: cache line size of 32 is not supported by device 0000:00:1d.7 ehci_hcd 0000:00:1d.7: irq 170, io mem 0xdf700000 ehci_hcd 0000:00:1d.7: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004 usb usb5: configuration #1 chosen from 1 choice hub 5-0:1.0: USB hub found hub 5-0:1.0: 8 ports detected usb 1-1: device descriptor read/all, error -71 SCSI subsystem initialized megasas: 00.00.03.05 Mon Oct 02 11:21:32 PDT 2006 megasas: 0x1000:0x0060:0x1033:0x835a: bus 3:slot 0:func 0 ACPI: PCI Interrupt 0000:03:00.0[A] -> GSI 16 (level, low) -> IRQ 169 PCI: Setting latency timer of device 0000:03:00.0 to 64 megasas: FW now in Ready state scsi0 : LSI Logic SAS based MegaRAID driver Vendor: SEAGATE Model: ST973402SS Rev: 0002 Type: Direct-Access ANSI SCSI revision: 05 Vendor: SEAGATE Model: ST973402SS Rev: 0002 Type: Direct-Access ANSI SCSI revision: 05 Vendor: LSI Model: MegaRAID SAS RMB Rev: 1.12 Type: Direct-Access ANSI SCSI revision: 05 SCSI device sda: 141885440 512-byte hdwr sectors (72645 MB) sda: Write Protect is off sda: Mode Sense: 1f 00 10 08 SCSI device sda: drive cache: write through w/ FUA SCSI device sda: 141885440 512-byte hdwr sectors (72645 MB) sda: Write Protect is off sda: Mode Sense: 1f 00 10 08 SCSI device sda: drive cache: write through w/ FUA sda: sda1 sda2 sda3 sd 0:2:0:0: Attached scsi disk sda libata version 2.21 loaded. ata_piix 0000:00:1f.2: version 2.11 ata_piix 0000:00:1f.2: MAP [ P0 P2 P1 P3 ] GSI 23 sharing vector 0xB2 and IRQ 23 ACPI: PCI Interrupt 0000:00:1f.2[B] -> GSI 19 (level, low) -> IRQ 178 ata_piix 0000:00:1f.2: 0x1F0 IDE port busy PCI: Setting latency timer of device 0000:00:1f.2 to 64 scsi1 : ata_piix scsi2 : ata_piix ata1: DUMMY ata2: SATA max UDMA/133 cmd 0x0000000000010170 ctl 0x0000000000010376 bmdma 0x00000000000110a8 irq 15 ATA: abnormal status 0x7F on port 0x0000000000010177 usb 5-7: new high speed USB device using ehci_hcd and address 3 usb 5-7: configuration #1 chosen from 1 choice hub 5-7:1.0: USB hub found hub 5-7:1.0: 3 ports detected usb 1-1: new full speed USB device using uhci_hcd and address 4 usb 1-1: configuration #1 chosen from 1 choice input: ServerEngines SE USB Device as /class/input/input0 input: USB HID v1.11 Keyboard [ServerEngines SE USB Device] on usb-0000:00:1d.0-1 input: ServerEngines SE USB Device as /class/input/input1 input: USB HID v1.11 Mouse [ServerEngines SE USB Device] on usb-0000:00:1d.0-1 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. SELinux: Disabled at runtime. SELinux: Unregistering netfilter hooks audit(1184930680.318:2): selinux=0 auid=4294967295 input: PC Speaker as /class/input/input2 Intel(R) PRO/1000 Network Driver - version 7.2.9-k2-NAPI Copyright (c) 1999-2006 Intel Corporation. ACPI: PCI Interrupt 0000:14:00.0[A] -> GSI 18 (level, low) -> IRQ 185 PCI: Setting latency timer of device 0000:14:00.0 to 64 e1000: 0000:14:00.0: e1000_probe: (PCI Express:2.5Gb/s:32-bit) 00:0e:0c:e2:e5:78 e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network Connection ACPI: PCI Interrupt 0000:14:00.1[B] -> GSI 19 (level, low) -> IRQ 178 PCI: Setting latency timer of device 0000:14:00.1 to 64 e1000: 0000:14:00.1: e1000_probe: (PCI Express:2.5Gb/s:32-bit) 00:0e:0c:e2:e5:79 e1000: eth1: e1000_probe: Intel(R) PRO/1000 Network Connection shpchp: Standard Hot Plug PCI Controller Driver version: 0.4 ACPI: PCI Interrupt 0000:00:1f.3[B] -> GSI 19 (level, low) -> IRQ 178 hda: ATAPI 24X DVD-ROM CD-R/RW drive, 2048kB Cache Uniform CD-ROM driver Revision: 3.20 intel_rng: FWH not detected input: PS/2 Generic Mouse as /class/input/input3 sd 0:2:0:0: Attached scsi generic sg0 type 0 floppy0: no floppy controllers found lp: driver loaded but no devices found ACPI: Power Button (FF) [PWRF] ibm_acpi: ec object not found