Linux version 2.6.23-rc3-g2a677896-dirty (ytao@ytao-desktop) (gcc version 4.1.2 (Ubuntu 4.1.2-0ubuntu4)) #2 SMP PREEMPT Mon Aug 20 15:18:42 EDT 2007 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009e400 (usable) BIOS-e820: 000000000009e400 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001fff0000 (usable) BIOS-e820: 000000001fff0000 - 000000001ffff000 (ACPI data) BIOS-e820: 000000001ffff000 - 0000000020000000 (ACPI NVS) BIOS-e820: 00000000fec00000 - 00000000fed00000 (reserved) BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved) BIOS-e820: 00000000ffb00000 - 0000000100000000 (reserved) 0MB HIGHMEM available. 511MB LOWMEM available. found SMP MP-table at 000ff780 Entering add_active_range(0, 0, 131056) 0 entries of 256 used Zone PFN ranges: DMA 0 -> 4096 Normal 4096 -> 131056 HighMem 131056 -> 131056 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0 -> 131056 On node 0 totalpages: 131056 DMA zone: 32 pages used for memmap DMA zone: 0 pages reserved DMA zone: 4064 pages, LIFO batch:0 Normal zone: 991 pages used for memmap Normal zone: 125969 pages, LIFO batch:31 HighMem zone: 0 pages used for memmap Movable zone: 0 pages used for memmap DMI 2.3 present. Intel MultiProcessor Specification v1.4 Virtual Wire compatibility mode. OEM ID: INTEL Product ID: KC861I3B.86E APIC at: 0xFEE00000 Processor #0 15:2 APIC version 20 Processor #6 15:2 APIC version 20 I/O APIC #8 Version 32 at 0xFEC00000. I/O APIC #9 Version 32 at 0xFEC81000. I/O APIC #10 Version 32 at 0xFEC81400. Enabling APIC mode: Flat. Using 3 I/O APICs Processors: 2 Allocating PCI resources starting at 30000000 (gap: 20000000:dec00000) Built 1 zonelists in Zone order. Total pages: 130033 Kernel command line: ksdevice=eth1 console=ttyS0,9600n8 root=/dev/nfs rw ip=dhcp BOOT_IMAGE=vlm-boards/8151/kernel ip=192.168.29.97:192.168.29.11:192.168.29.1:255.255.255.0 mapped APIC to ffffb000 (fee00000) mapped IOAPIC to ffffa000 (fec00000) mapped IOAPIC to ffff9000 (fec81000) mapped IOAPIC to ffff8000 (fec81400) Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 PID hash table entries: 2048 (order: 11, 8192 bytes) Detected 1999.886 MHz processor. Console: colour dummy device 80x25 console [ttyS0] enabled Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 515440k/524224k available (1972k kernel code, 8300k reserved, 659k data, 228k init, 0k highmem) virtual kernel memory layout: fixmap : 0xfff4e000 - 0xfffff000 ( 708 kB) pkmap : 0xff800000 - 0xffc00000 (4096 kB) vmalloc : 0xe0800000 - 0xff7fe000 ( 495 MB) lowmem : 0xc0000000 - 0xdfff0000 ( 511 MB) .init : 0xc0398000 - 0xc03d1000 ( 228 kB) .data : 0xc02ed294 - 0xc0391ffc ( 659 kB) .text : 0xc0100000 - 0xc02ed294 (1972 kB) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 4003.61 BogoMIPS (lpj=8007232) Mount-cache hash table entries: 512 CPU: After generic identify, caps: bfebfbff 00000000 00000000 00000000 00004400 00000000 00000000 00000000 CPU: Trace cache: 12K uops, L1 D cache: 8K CPU: L2 cache: 512K CPU: Physical Processor ID: 0 CPU: After all inits, caps: bfebfbf7 00000000 00000000 0000b080 00004400 00000000 00000000 00000000 Compat vDSO mapped to ffffe000. Checking 'hlt' instruction... OK. Freeing SMP alternatives: 12k freed CPU0: Intel(R) Xeon(TM) CPU 2.00GHz stepping 09 Booting processor 1/6 eip 2000 Initializing CPU#1 Calibrating delay using timer specific routine.. 3999.90 BogoMIPS (lpj=7999806) CPU: After generic identify, caps: bfebfbff 00000000 00000000 00000000 00004400 00000000 00000000 00000000 CPU: Trace cache: 12K uops, L1 D cache: 8K CPU: L2 cache: 512K CPU: Physical Processor ID: 3 CPU: After all inits, caps: bfebfbf7 00000000 00000000 0000b080 00004400 00000000 00000000 00000000 CPU1: Intel(R) Xeon(TM) CPU 2.00GHz stepping 09 Total of 2 processors activated (8003.51 BogoMIPS). ExtINT not setup in hardware but reported by MP table ENABLING IO-APIC IRQs ..TIMER: vector=0x31 apic1=0 pin1=2 apic2=0 pin2=0 checking TSC synchronization [CPU#0 -> CPU#1]: passed. Brought up 2 CPUs NET: Registered protocol family 16 PCI: PCI BIOS revision 2.10 entry at 0xf0031, last bus=4 PCI: Using configuration type 1 Setting up standard PCI resources PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI quirk: region 0400-047f claimed by ICH4 ACPI/GPIO/TCO PCI quirk: region 0500-053f claimed by ICH4 GPIO PCI: Transparent bridge - 0000:00:1e.0 PCI: Using IRQ router PIIX/ICH [8086/2480] at 0000:00:1f.0 PCI->APIC IRQ transform: 0000:00:1d.0[A] -> IRQ 16 PCI->APIC IRQ transform: 0000:00:1f.1[A] -> IRQ 18 PCI->APIC IRQ transform: 0000:00:1f.3[B] -> IRQ 17 PCI->APIC IRQ transform: 0000:04:01.0[A] -> IRQ 48 PCI->APIC IRQ transform: 0000:04:01.1[B] -> IRQ 49 Time: tsc clocksource has been installed. PCI: Bridge: 0000:02:1d.0 IO window: e000-efff MEM window: ff800000-ff8fffff PREFETCH window: ff300000-ff3fffff PCI: Bridge: 0000:02:1f.0 IO window: disabled. MEM window: ff700000-ff7fffff PREFETCH window: ff200000-ff2fffff PCI: Bridge: 0000:00:03.0 IO window: e000-efff MEM window: ff700000-ff9fffff PREFETCH window: ff200000-ff4fffff PCI: Bridge: 0000:00:1e.0 IO window: disabled. MEM window: ff600000-ff6fffff PREFETCH window: ff100000-ff1fffff PCI: Setting latency timer of device 0000:00:1e.0 to 64 NET: Registered protocol family 2 IP route cache hash table entries: 4096 (order: 2, 16384 bytes) TCP established hash table entries: 16384 (order: 6, 262144 bytes) TCP bind hash table entries: 16384 (order: 5, 196608 bytes) TCP: Hash tables configured (established 16384 bind 16384) TCP reno registered io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered (default) Real Time Clock Driver v1.12ac Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize Intel(R) PRO/1000 Network Driver - version 7.3.20-k2 Copyright (c) 1999-2006 Intel Corporation. Clocksource tsc unstable (delta = 322848815 ns) e1000: 0000:04:01.0: e1000_probe: (PCI-X:133MHz:64-bit) 00:02:b3:f1:88:c4 e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network Connection Time: jiffies clocksource has been installed. e1000: 0000:04:01.1: e1000_probe: (PCI-X:133MHz:64-bit) 00:02:b3:f1:88:c5 e1000: eth1: e1000_probe: Intel(R) PRO/1000 Network Connection netconsole: not configured, aborting Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx Probing IDE interface ide0... hda: FUJITSU MHT2020AT, ATA DISK drive Probing IDE interface ide1... ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: max request size: 128KiB hda: 39070080 sectors (20003 MB) w/2048KiB Cache, CHS=38760/16/63 hda: cache flushes supported hda: hda1 hda2 hda3 hda4 md: linear personality registered for level -1 md: raid0 personality registered for level 0 md: raid1 personality registered for level 1 md: raid10 personality registered for level 10 md: multipath personality registered for level -4 md: faulty personality registered for level -5 device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel@redhat.com TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 Starting balanced_irq Using IPI Shortcut mode e1000: eth0: e1000_watchdog: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX Sending DHCP requests . OK IP-Config: Got DHCP answer from 192.168.29.11, my address is 192.168.29.97 IP-Config: Complete: device=eth0, addr=192.168.29.97, mask=255.255.255.0, gw=192.168.29.1, host=kennicott-node4, domain=tuxlab.wrs.com, nis-domain=swamp, bootserver=192.168.29.11, rootserver=192.168.29.11, rootpath=/export/pxeboot/vlm-boards/8151/rootfs md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. Looking up port of RPC 100003/2 on 192.168.29.11 Looking up port of RPC 100005/1 on 192.168.29.11 VFS: Mounted root (nfs filesystem). Freeing unused kernel memory: 228k freed Write protecting the kernel text: 1976k Write protecting the kernel read-only data: 496k