[ 24.368869] Linux video capture interface: v2.00 [ 24.404665] bttv: driver version 0.9.17 loaded [ 24.429120] bttv: using 8 buffers with 2080k (520 pages) each for capture [ 24.453477] ACPI: PCI Interrupt 0000:04:00.1[A] -> GSI 16 (level, low) -> IRQ 16 [ 24.476702] bt87x0: Using board 1, analog, digital (rate 32000 Hz) [ 24.512622] bttv: Bt8xx card found (0). [ 24.512622] ACPI: PCI Interrupt 0000:04:00.0[A] -> GSI 16 (level, low) -> IRQ 16 [ 24.544708] bttv0: Bt878 (rev 17) at 0000:04:00.0, irq: 16, latency: 64, mmio: 0xfdffe000 [ 24.570800] bttv0: detected: Hauppauge WinTV [card=10], PCI subsystem ID is 0070:13eb [ 24.597855] bttv0: using: Hauppauge (bt878) [card=10,autodetected] [ 24.621849] bttv0: gpio: en=00000000, out=00000000 in=00ffffdb [init] [ 24.641830] bttv0: Hauppauge/Voodoo msp34xx: reset line init [5] [ 24.690793] tveeprom 1-0050: Hauppauge model 44354, rev C121, serial# 2268107 [ 24.710797] tveeprom 1-0050: tuner model is Philips FM1216 (idx 21, type 5) [ 24.731631] tveeprom 1-0050: TV standards PAL(B/G) (eeprom 0x04) [ 24.750048] tveeprom 1-0050: audio processor is MSP3415 (idx 6) [ 24.767768] tveeprom 1-0050: has radio [ 24.779001] bttv0: Hauppauge eeprom indicates model#44354 [ 24.795167] bttv0: tuner type=5 [ 24.806331] bttv0: i2c: checking for MSP34xx @ 0x80... found [ 24.855672] msp3400' 1-0040: MSP3415D-B3 found @ 0x80 (bt878 #0 [sw]) [ 24.875254] msp3400' 1-0040: msp3400 supports nicam, mode is autodetect [ 24.903715] bttv0: i2c: checking for TDA9875 @ 0xb0... not found [ 24.919763] bttv0: i2c: checking for TDA7432 @ 0x8a... not found [ 24.988073] tuner' 1-0061: chip found @ 0xc2 (bt878 #0 [sw]) [ 25.096455] tuner-simple 1-0061: creating new instance [ 25.109634] tuner-simple 1-0061: type set to 5 (Philips PAL_BG (FI1216 and compatibles)) [ 25.158913] bttv0: registered device video0 [ 25.172353] bttv0: registered device vbi0 [ 25.186470] bttv0: registered device radio0 [ 25.204435] bttv0: PLL: 28636363 => 35468950 .. ok [ 25.280931] bt878: AUDIO driver version 0.0.0 loaded