Message-ID: <20090507144710.GB20099@csn.ul.ie>
Date:	Thu, 7 May 2009 15:47:11 +0100
From:	Mel Gorman <mel@....ul.ie>
To:	Ingo Molnar <mingo@...e.hu>
Cc:	Yinghai Lu <yinghai@...nel.org>,
	Thomas Gleixner <tglx@...utronix.de>,
	"H. Peter Anvin" <hpa@...or.com>,
	Andrew Morton <akpm@...ux-foundation.org>,
	"linux-kernel@...r.kernel.org" <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH] x86: fix nodes_cover_memory

On Thu, May 07, 2009 at 04:21:21PM +0200, Ingo Molnar wrote:
> 
> * Mel Gorman <mel@....ul.ie> wrote:
> 
> > On Wed, May 06, 2009 at 09:53:35AM -0700, Yinghai Lu wrote:
> > > 
> > > found one system that missed one entry for one node in SRAT, and that SRAT is not
> > > rejected by nodes_cover_memory()
> > > 
> > > it turns out that we can not use absent_page_in_range to calaulate
> > > e820ram, bacause that will use early_node_map and that is AND result of
> > > e820 and SRAT.
> > > 
> > 
> > Correct, good spot.
> > 
> > > revert back to use e820_hole_size instead.
> > > 
> > 
> > I think the patch fixing this part of the problem is good, but the changelog
> > could be better. It took me a while to figure out what the problem was and
> > why this patch addressed it.
> > 
> > How about something like the following?
> > 
> > ====
> > Sanity check the e820 against the SRAT table using only information from the e820 map
> > 
> > node_cover_memory() sanity checks the SRAT table by ensuring that all
> > PXMs cover the memory reported in the e820. However, when calculating
> > the size of the holes in the e820, it uses the early_node_map[] which
> > contains information taken from both SRAT and e820. If the SRAT is
> > missing an entry, then it is not detected that the SRAT table is
> > incorrect and missing entries.
> > 
> > This patch uses the e820 map to calculate the holes instead of
> > early_node_map[].
> > ====
> > 
> > As an aside, it strikes me as odd that we discard an entire SRAT because it
> > is missing an entry in the e820. The impact may only be that the affinity
> > for a range of memory is incorrect, but it does not necessarily mean that the
> > entire table is incorrect. The intention of the code appears to be "if there is
> > any error in the SRAT, it's best ignored" though so maybe it's best left alone.
> > 
> > > also change that difference checking to 1M instead of 4G,
> > > because e820ram, and pxmram are in pages.
> > > 
> > 
> > While I agree with you, this should be a separate patch with its own
> > changelog. Something like
> > 
> > ===
> > Allow 1MB of slack between the e820 map and SRAT, not 4GB
> > 
> > It is expected that there be slight differences between the e820 map and
> > the SRAT table and the intention was that 1MB of slack be allowed. The
> > calculation comparing e820ram and pxmram assumes the units are bytes,
> > when they are in fact pages. This means 4GB of slack is being allowed,
> > not 1MB. This patch makes the correct comparison
> > ===
> > 
> > (1<<(20 - PAGE_SHIFT)) is a bit unreadable. At the very least, change the
> > comment above from "Allow a bit of slack" to "Allow 1MB of slack" so the
> > next reader knows what the intention of (1<<(20 - PAGE_SHIFT)) is.
> > 
> > Thanks
> 
> thanks Mel!
> 
> Yinghai, mind resending the patch as two patches, with Mel's 
> changelogs in place and with Mel's Acked-by as well?
> 

My bad for leaving it out, but yes. Assuming there are two patches with the
updated changelog, I'm fine with adding the

Acked-by: Mel Gorman <mel@....ul.ie>

-- 
Mel Gorman
Part-time Phd Student                          Linux Technology Center
University of Limerick                         IBM Dublin Software Lab
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Powered by blists - more mailing lists