2.6.31-stable review patch. If anyone has any objections, please let us know. ------------------ From: Nick Kossifidis commit d1cb0bdac180a4afdd3c001acb2618d2a62d9abe upstream. * Set correct xpd curve indices for high/low gain curves during rfbuffer setup on RF5112B with both calibration curves available. * Don't return zero min power when we have the same pcdac value twice because it breaks interpolation. Instead return the right x barrier as we do when we have equal power levels for 2 different pcdac values. Signed-off-by: Nick Kossifidis Acked-by: Bob Copeland Signed-off-by: John W. Linville Cc: Dan Williams Signed-off-by: Greg Kroah-Hartman --- drivers/net/wireless/ath/ath5k/phy.c | 24 +++++++++++++++++------- 1 file changed, 17 insertions(+), 7 deletions(-) --- a/drivers/net/wireless/ath/ath5k/phy.c +++ b/drivers/net/wireless/ath/ath5k/phy.c @@ -740,13 +740,22 @@ int ath5k_hw_rfregs_init(struct ath5k_hw AR5K_RF_XPD_GAIN, true); } else { - /* TODO: Set high and low gain bits */ - ath5k_hw_rfb_op(ah, rf_regs, - ee->ee_x_gain[ee_mode], + u8 *pdg_curve_to_idx = ee->ee_pdc_to_idx[ee_mode]; + if (ee->ee_pd_gains[ee_mode] > 1) { + ath5k_hw_rfb_op(ah, rf_regs, + pdg_curve_to_idx[0], AR5K_RF_PD_GAIN_LO, true); - ath5k_hw_rfb_op(ah, rf_regs, - ee->ee_x_gain[ee_mode], + ath5k_hw_rfb_op(ah, rf_regs, + pdg_curve_to_idx[1], AR5K_RF_PD_GAIN_HI, true); + } else { + ath5k_hw_rfb_op(ah, rf_regs, + pdg_curve_to_idx[0], + AR5K_RF_PD_GAIN_LO, true); + ath5k_hw_rfb_op(ah, rf_regs, + pdg_curve_to_idx[0], + AR5K_RF_PD_GAIN_HI, true); + } /* Lower synth voltage on Rev 2 */ ath5k_hw_rfb_op(ah, rf_regs, 2, @@ -1897,8 +1906,9 @@ ath5k_get_linear_pcdac_min(const u8 *ste s16 min_pwrL, min_pwrR; s16 pwr_i; - if (WARN_ON(stepL[0] == stepL[1] || stepR[0] == stepR[1])) - return 0; + /* Some vendors write the same pcdac value twice !!! */ + if (stepL[0] == stepL[1] || stepR[0] == stepR[1]) + return max(pwrL[0], pwrR[0]); if (pwrL[0] == pwrL[1]) min_pwrL = pwrL[0]; -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/