--- /tmp/tmp.5198.41 2010-02-01 15:04:45.000000000 -0800 +++ ./linux-2.6.32.3/drivers/net/ll_temac.h 2010-01-28 15:06:17.000000000 -0800 @@ -338,6 +338,7 @@ /* IO registers and IRQs */ void __iomem *regs; dcr_host_t sdma_dcrs; + u32 __iomem *sdma_regs; int tx_irq; int rx_irq; int emac_num; --- /tmp/tmp.5198.53 2010-02-01 15:04:45.000000000 -0800 +++ ./linux-2.6.32.3/drivers/net/ll_temac_main.c 2010-02-01 15:04:01.000000000 -0800 @@ -20,9 +20,6 @@ * or rx, so this should be okay. * * TODO: - * - Fix driver to work on more than just Virtex5. Right now the driver - * assumes that the locallink DMA registers are accessed via DCR - * instructions. * - Factor out locallink DMA code into separate driver * - Fix multicast assignment. * - Fix support for hardware checksumming. @@ -117,12 +114,20 @@ static u32 temac_dma_in32(struct temac_local *lp, int reg) { - return dcr_read(lp->sdma_dcrs, reg); + if (lp->sdma_regs) { + return __raw_readl(lp->sdma_regs + reg); + } else { + return dcr_read(lp->sdma_dcrs, reg); + } } static void temac_dma_out32(struct temac_local *lp, int reg, u32 value) { - dcr_write(lp->sdma_dcrs, reg, value); + if (lp->sdma_regs) { + __raw_writel(value, lp->sdma_regs + reg); + } else { + dcr_write(lp->sdma_dcrs, reg, value); + } } /** @@ -862,13 +867,17 @@ goto nodev; } - dcrs = dcr_resource_start(np, 0); - if (dcrs == 0) { - dev_err(&op->dev, "could not get DMA register address\n"); + lp->sdma_regs = NULL; + + if ((dcrs = dcr_resource_start(np, 0)) != 0) { + lp->sdma_dcrs = dcr_map(np, dcrs, dcr_resource_len(np, 0)); + dev_dbg(&op->dev, "DCR base: %x\n", dcrs); + } else if ((lp->sdma_regs = of_iomap(np, 0))) { + dev_dbg(&op->dev, "MEM base: %p\n", lp->sdma_regs); + } else { + dev_err(&op->dev, "unable to map DMA registers\n"); goto nodev; } - lp->sdma_dcrs = dcr_map(np, dcrs, dcr_resource_len(np, 0)); - dev_dbg(&op->dev, "DCR base: %x\n", dcrs); lp->rx_irq = irq_of_parse_and_map(np, 0); lp->tx_irq = irq_of_parse_and_map(np, 1); @@ -895,7 +904,7 @@ lp->phy_node = of_parse_phandle(op->node, "phy-handle", 0); if (lp->phy_node) - dev_dbg(lp->dev, "using PHY node %s (%p)\n", np->full_name, np); + dev_dbg(lp->dev, "using PHY node %s (%p)\n", lp->phy_node->full_name, lp->phy_node); /* Add the device attributes */ rc = sysfs_create_group(&lp->dev->kobj, &temac_attr_group);