| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <201004011535.59629.fzuuzf@googlemail.com>
Date: Thu, 1 Apr 2010 14:35:59 +0100
From: Karsten Wiese <fzuuzf@...glemail.com>
To: Andy Lutomirski <luto@...ealbox.com>
Cc: linux-kernel@...r.kernel.org, Eric Anholt <eric@...olt.net>
Subject: Re: i915 lockup / extreme delay
Am Donnerstag 01 April 2010 schrieb Andy Lutomirski:
> Karl Vogel wrote:
> > On Mon, Mar 22, 2010 at 4:34 PM, Eric Anholt <eric@...olt.net> wrote:
> >> On Mon, 22 Mar 2010 09:11:06 +0100, Karl Vogel <karl.vogel@...il.com> wrote:
> >>> On Mon, Mar 22, 2010 at 5:20 AM, Eric Anholt <eric@...olt.net> wrote:
> >>>> On Sat, 20 Mar 2010 14:41:41 +0100, Karl Vogel <karl.vogel@...il.com> wrote:
> >>>>> The 'effect' is that only the mouse pointer works in the X server. The
> >>>>> cpu usage on the laptop during the sluggishness is minimal. When I
> >>>>> suspend the game with winedbg, the X server slowly becomes responsive again.
> >>>>>
> >>>>> The output from latencytop seems to point to i915 being the culprit:
> >>>> If there's some code doing glFlush()es, it's probably that code at
> >>>> fault. You don't need to do that unless you're doing frontbuffer
> >>>> rendering, and if you're doing frontbuffer rendering you should really
> >>>> be doing backbuffer rendering. I don't see a kernel issue here.
> >>> That doesnt explain why the box completely locks up on 2.6.34-rc2
> >>> though, where only a cold reboot works.
> >> Missed that part of the message. If there's a regression, bisect
> >> please.
> >
> > Apparently the crash was caused by a hardware bug in the intel chipset
> > which is 8086:2a40 rev 07. While doing the bisect I got an error:
> >
> > DRHD: handling fault status reg 2
> > DMAR:[DMA Write] Request device [00:02.0] fault addr dd69a000
> > DMAR:[fault reason 05] PTE Write access is not set
> >
> > After some googling around, I found this bugzilla entry which explains it:
> >
> > https://bugzilla.redhat.com/show_bug.cgi?id=538163#c58
> >
> > The issue appears that the graphics chip is corrupting memory:
> >
> > "Unfortunately, this particular chipset sometimes reads from the GTT, does the
> > translation, then writes the translated address back to the _original_ GTT
> > instead of to the shadow GTT. That's why you're seeing real physical addresses
> > where you should have 'virtual DMA addresses', and you get the faults. "
> >
> > Adding "intel_iommu=igfx_off" to the kernel command line resolved the issue.
> > The fedora kernel automatically disables this when it detects this particular
> > chipset revision.
> >
> > As for the freeze/slowdown right after booting, sysprof shows that more than 77%
> > of the time is spent inside: drm_mode_getconnector
>
> http://lists.freedesktop.org/archives/intel-gfx/2010-February/005922.html
>
> I'm waiting for the encoder/connector stuff to get merged before I
> either pester people about that bug again or try to fix it myself.
>
> You can try the same hack I use (comment out the initialization of all
> digital outputs) if you don't use them -- that completely fixes it for me.
Andy, please try this patch.
Eric, please review.
Thanks,
Karsten
[RFC PATCH] drm/i915: Don't touch PORT_HOTPLUG_EN in intel_dp_detect()
Von: Karsten Wiese <fzuuzf@...glemail.com>
An: linux-kernel@...r.kernel.org, Jesse Barnes <jbarnes@...tuousgeek.org>, Eric Anholt <eric@...olt.net>
PORT_HOTPLUG_EN has allready been setup in i915_driver_irq_postinstall(),
when intel_dp_detect() runs.
Delete the DP[BCD]_HOTPLUG_INT_EN defines, they are not referenced anymore.
I found this while searching for a fix for
https://bugzilla.redhat.com/show_bug.cgi?id=528312
Signed-off-by: Karsten Wiese <fzu@...gehoertderstaat.de>
---
See also
"drm/i915: only enable hotplug for detected outputs"
b01f2c3a4a37d09a47ad73ccbb46d554d21cfeb0
drivers/gpu/drm/i915/i915_reg.h | 3 ---
drivers/gpu/drm/i915/intel_dp.c | 10 ----------
2 files changed, 0 insertions(+), 13 deletions(-)
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index ab1bd2d..92f440d 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -854,11 +854,8 @@
/* Hotplug control (945+ only) */
#define PORT_HOTPLUG_EN 0x61110
#define HDMIB_HOTPLUG_INT_EN (1 << 29)
-#define DPB_HOTPLUG_INT_EN (1 << 29)
#define HDMIC_HOTPLUG_INT_EN (1 << 28)
-#define DPC_HOTPLUG_INT_EN (1 << 28)
#define HDMID_HOTPLUG_INT_EN (1 << 27)
-#define DPD_HOTPLUG_INT_EN (1 << 27)
#define SDVOB_HOTPLUG_INT_EN (1 << 26)
#define SDVOC_HOTPLUG_INT_EN (1 << 25)
#define TV_HOTPLUG_INT_EN (1 << 18)
diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
index 439506c..7a3b5c8 100644
--- a/drivers/gpu/drm/i915/intel_dp.c
+++ b/drivers/gpu/drm/i915/intel_dp.c
@@ -1179,16 +1179,6 @@ intel_dp_detect(struct drm_connector *connector)
if (IS_IRONLAKE(dev))
return ironlake_dp_detect(connector);
- temp = I915_READ(PORT_HOTPLUG_EN);
-
- I915_WRITE(PORT_HOTPLUG_EN,
- temp |
- DPB_HOTPLUG_INT_EN |
- DPC_HOTPLUG_INT_EN |
- DPD_HOTPLUG_INT_EN);
-
- POSTING_READ(PORT_HOTPLUG_EN);
-
switch (dp_priv->output_reg) {
case DP_B:
bit = DPB_HOTPLUG_INT_STATUS;
--
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists