| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <1295257308.2884.14.camel@realization>
Date: Mon, 17 Jan 2011 10:41:48 +0100
From: Alberto Panizzo <maramaopercheseimorto@...il.com>
To: Guennadi Liakhovetski <g.liakhovetski@....de>
Cc: HansVerkuil <hverkuil@...all.nl>, linux-media@...r.kernel.org,
linux-kernel <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH 2/2] Fix capture issues for non 8-bit per pixel formats
On Sat, 2011-01-15 at 22:35 +0100, Guennadi Liakhovetski wrote:
> On Wed, 12 Jan 2011, Alberto Panizzo wrote:
>
> > If the camera was set to output formats like RGB565 YUYV or SBGGR10,
> > the resulting image was scrambled due to erroneous interpretations of
> > horizontal parameter's units.
> >
> > This patch in fourcc_to_ipu_pix, eliminate also the pixel formats mappings
> > that, first are not used within mainline code and second, standing at
> > the datasheets, they will not work properly:
> >
> > The IPU internal bus support only the following data formatting
> > (44.1.1.3 Data Flows and Formats):
> > 1 YUV 4:4:4 or RGB-8 bits per color component
> > 2 YUV 4:4:4 or RGB-10 bits per color component
> > 3 Generic data (from sensor to the system memory only)
> >
> > And format conversions are done:
> > - from memory: de-packing from other formats to IPU supported ones
>
> did you mean "unpacking" (also below)?
>
> > - to memory: packing in the inverse order.
I mean:
- from memory: unpacking from other formats to IPU supported ones
- to memory: packing in the inverse order.
To indicate the oneway direction of packing and unpacking. I'll
resend the patch with the updated comment.
> >
> > So, assigning a packing/depacking strategy to the IPU for that formats
> > will produce a packing to memory and not the inverse.
> >
> > In the end in mx3_camera_get_formats, is fixed an erroneous debug message
> > that try to shows info from an invalid xlate pointer.
> >
> > Signed-off-by: Alberto Panizzo <maramaopercheseimorto@...il.com>
> > ---
> > drivers/media/video/mx3_camera.c | 66 +++++++++++++++++++++++++++++--------
> > 1 files changed, 51 insertions(+), 15 deletions(-)
> >
> > diff --git a/drivers/media/video/mx3_camera.c b/drivers/media/video/mx3_camera.c
> > index b9cb4a4..6b9d019 100644
> > --- a/drivers/media/video/mx3_camera.c
> > +++ b/drivers/media/video/mx3_camera.c
> > @@ -324,14 +324,10 @@ static enum pixel_fmt fourcc_to_ipu_pix(__u32 fourcc)
> > {
> > /* Add more formats as need arises and test possibilities appear... */
> > switch (fourcc) {
> > - case V4L2_PIX_FMT_RGB565:
> > - return IPU_PIX_FMT_RGB565;
> > case V4L2_PIX_FMT_RGB24:
> > return IPU_PIX_FMT_RGB24;
> > - case V4L2_PIX_FMT_RGB332:
> > - return IPU_PIX_FMT_RGB332;
> > - case V4L2_PIX_FMT_YUV422P:
> > - return IPU_PIX_FMT_YVU422P;
> > + case V4L2_PIX_FMT_UYVY:
> > + case V4L2_PIX_FMT_RGB565:
> > default:
> > return IPU_PIX_FMT_GENERIC;
> > }
> > @@ -359,9 +355,31 @@ static void mx3_videobuf_queue(struct videobuf_queue *vq,
> >
> > /* This is the configuration of one sg-element */
> > video->out_pixel_fmt = fourcc_to_ipu_pix(fourcc);
> > - video->out_width = icd->user_width;
> > - video->out_height = icd->user_height;
> > - video->out_stride = icd->user_width;
> > +
> > + if (video->out_pixel_fmt == IPU_PIX_FMT_GENERIC) {
> > + /*
> > + * If the IPU DMA channel is configured to transport
> > + * generic 8-bit data, we have to set up correctly the
> > + * geometry parameters upon the current pixel format.
> > + * So, since the DMA horizontal parameters are expressed
> > + * in bytes not pixels, convert these in the right unit.
> > + */
> > + int bytes_per_line = soc_mbus_bytes_per_line(icd->user_width,
> > + icd->current_fmt->host_fmt);
> > + BUG_ON(bytes_per_line <= 0);
> > +
> > + video->out_width = bytes_per_line;
> > + video->out_height = icd->user_height;
> > + video->out_stride = bytes_per_line;
> > + } else {
> > + /*
> > + * For IPU known formats the pixel unit will be managed
> > + * successfully by the IPU code
> > + */
> > + video->out_width = icd->user_width;
> > + video->out_height = icd->user_height;
> > + video->out_stride = icd->user_width;
> > + }
> >
> > #ifdef DEBUG
> > /* helps to see what DMA actually has written */
> > @@ -734,18 +752,36 @@ static int mx3_camera_get_formats(struct soc_camera_device *icd, unsigned int id
> > if (xlate) {
> > xlate->host_fmt = fmt;
> > xlate->code = code;
> > + dev_dbg(dev, "Providing format %c%c%c%c in pass-through mode\n",
> > + (fmt->fourcc >> (0*8)) & 0xFF,
> > + (fmt->fourcc >> (1*8)) & 0xFF,
> > + (fmt->fourcc >> (2*8)) & 0xFF,
> > + (fmt->fourcc >> (3*8)) & 0xFF);
> > xlate++;
> > - dev_dbg(dev, "Providing format %x in pass-through mode\n",
> > - xlate->host_fmt->fourcc);
> > }
> >
> > return formats;
> > }
> >
> > static void configure_geometry(struct mx3_camera_dev *mx3_cam,
> > - unsigned int width, unsigned int height)
> > + unsigned int width, unsigned int height,
> > + enum v4l2_mbus_pixelcode code)
> > {
> > u32 ctrl, width_field, height_field;
> > + const struct soc_mbus_pixelfmt *fmt;
> > +
> > + fmt = soc_mbus_get_fmtdesc(code);
> > + BUG_ON(!fmt);
> > +
> > + if (fourcc_to_ipu_pix(fmt->fourcc) == IPU_PIX_FMT_GENERIC) {
> > + /*
> > + * As the CSI will be configured to output BAYER, here
> > + * the width parameter count the number of samples to
> > + * capture to complete the whole image width.
> > + */
> > + width *= soc_mbus_samples_per_pixel(fmt);
>
> Wouldn't
>
> + width = soc_mbus_bytes_per_line(width, fmt);
>
> produce the same result here? Then we wouldn't need your patch 1/2 at all.
No, because CSI units are number of samples. This differs from number of
bytes for formats like SBGGR10 (EXTEND16 formats).
I tested this working.
>
> > + BUG_ON(!width);
> > + }
> >
> > /* Setup frame size - this cannot be changed on-the-fly... */
> > width_field = width - 1;
> > @@ -854,7 +890,7 @@ static int mx3_camera_set_crop(struct soc_camera_device *icd,
> > return ret;
> > }
> >
> > - configure_geometry(mx3_cam, mf.width, mf.height);
> > + configure_geometry(mx3_cam, mf.width, mf.height, mf.code);
> > }
> >
> > dev_dbg(icd->dev.parent, "Sensor cropped %dx%d\n",
> > @@ -897,7 +933,7 @@ static int mx3_camera_set_fmt(struct soc_camera_device *icd,
> > * mxc_v4l2_s_fmt()
> > */
> >
> > - configure_geometry(mx3_cam, pix->width, pix->height);
> > + configure_geometry(mx3_cam, pix->width, pix->height, xlate->code);
> >
> > mf.width = pix->width;
> > mf.height = pix->height;
> > @@ -1152,7 +1188,7 @@ static int mx3_camera_set_bus_param(struct soc_camera_device *icd, __u32 pixfmt)
> >
> > csi_reg_write(mx3_cam, sens_conf | dw, CSI_SENS_CONF);
> >
> > - dev_dbg(dev, "Set SENS_CONF to %x\n", sens_conf | dw);
> > + dev_info(dev, "Set SENS_CONF to %x\n", sens_conf | dw);
>
> This was unintentional, right?
Yes, unintentional, thanks!!
I'll resend the patch right now.
Best Regards,
Alberto!
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists