| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1295378505-15221-4-git-send-email-cyril@ti.com>
Date: Tue, 18 Jan 2011 14:21:37 -0500
From: Cyril Chemparathy <cyril@...com>
To: davinci-linux-open-source@...ux.davincidsp.com,
spi-devel-general@...ts.sourceforge.net, sameo@...ux.intel.com,
rpurdie@...ys.net, dbrownell@...rs.sourceforge.net
Cc: c-park@...com, linux-arm-kernel@...ts.arm.linux.org.uk,
linux-kernel@...r.kernel.org, Cyril Chemparathy <cyril@...com>
Subject: [PATCH v8 03/11] gpio: add ti-ssp gpio driver
TI's SSP controller pins can be directly read and written to behave like a
GPIO. This patch adds a GPIO driver that exposes such functionality.
Signed-off-by: Cyril Chemparathy <cyril@...com>
---
drivers/gpio/Kconfig | 10 ++
drivers/gpio/Makefile | 1 +
drivers/gpio/ti-ssp-gpio.c | 207 ++++++++++++++++++++++++++++++++++++++++++++
include/linux/mfd/ti_ssp.h | 4 +
4 files changed, 222 insertions(+), 0 deletions(-)
create mode 100644 drivers/gpio/ti-ssp-gpio.c
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index 3143ac7..05bbe4c 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -128,6 +128,16 @@ config GPIO_VX855
additional drivers must be enabled in order to use the
functionality of the device.
+config GPIO_TI_SSP
+ tristate "TI Sequencer Serial Port - GPIO Support"
+ depends on MFD_TI_SSP
+ help
+ Say yes here to support a GPIO interface on TI SSP port pins.
+ Each SSP port translates into 4 GPIOs.
+
+ This driver can also be built as a module. If so, the module
+ will be called ti-ssp-gpio.
+
comment "I2C GPIO expanders:"
config GPIO_MAX7300
diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
index bdf3dde..0e2a844 100644
--- a/drivers/gpio/Makefile
+++ b/drivers/gpio/Makefile
@@ -26,6 +26,7 @@ obj-$(CONFIG_GPIO_PL061) += pl061.o
obj-$(CONFIG_GPIO_STMPE) += stmpe-gpio.o
obj-$(CONFIG_GPIO_TC35892) += tc35892-gpio.o
obj-$(CONFIG_GPIO_TIMBERDALE) += timbgpio.o
+obj-$(CONFIG_GPIO_TI_SSP) += ti-ssp-gpio.o
obj-$(CONFIG_GPIO_TWL4030) += twl4030-gpio.o
obj-$(CONFIG_GPIO_UCB1400) += ucb1400_gpio.o
obj-$(CONFIG_GPIO_XILINX) += xilinx_gpio.o
diff --git a/drivers/gpio/ti-ssp-gpio.c b/drivers/gpio/ti-ssp-gpio.c
new file mode 100644
index 0000000..edc3142
--- /dev/null
+++ b/drivers/gpio/ti-ssp-gpio.c
@@ -0,0 +1,207 @@
+/*
+ * Sequencer Serial Port (SSP) based virtual GPIO driver
+ *
+ * Copyright (C) 2010 Texas Instruments Inc
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; either version 2 of the License, or
+ * (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program; if not, write to the Free Software
+ * Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA 02111-1307 USA
+ */
+
+#include <linux/init.h>
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/io.h>
+#include <linux/err.h>
+#include <linux/slab.h>
+#include <linux/gpio.h>
+#include <linux/platform_device.h>
+#include <linux/mfd/ti_ssp.h>
+
+struct ti_ssp_gpio_chip {
+ struct gpio_chip chip;
+ struct device *dev;
+ spinlock_t lock;
+ u8 out;
+ u32 iosel;
+};
+
+#define to_ssp_gpio_chip(c) container_of(c, struct ti_ssp_gpio_chip, chip)
+
+static int ti_ssp_gpio_dir_in(struct gpio_chip *chip, unsigned gpio_num)
+{
+ struct ti_ssp_gpio_chip *gpio = to_ssp_gpio_chip(chip);
+ int error = 0;
+
+ spin_lock(&gpio->lock);
+
+ gpio->iosel &= ~SSP_PIN_MASK(gpio_num);
+ gpio->iosel |= SSP_PIN_SEL(gpio_num, SSP_IN);
+
+ error = ti_ssp_set_iosel(gpio->dev, gpio->iosel);
+
+ spin_unlock(&gpio->lock);
+
+ return error;
+}
+
+static int ti_ssp_gpio_dir_out(struct gpio_chip *chip, unsigned gpio_num,
+ int val)
+{
+ struct ti_ssp_gpio_chip *gpio = to_ssp_gpio_chip(chip);
+ int error;
+
+ spin_lock(&gpio->lock);
+
+ gpio->iosel &= ~SSP_PIN_MASK(gpio_num);
+ gpio->iosel |= SSP_PIN_SEL(gpio_num, SSP_OUT);
+
+ error = ti_ssp_set_iosel(gpio->dev, gpio->iosel);
+
+ if (error < 0)
+ goto error;
+
+ if (val)
+ gpio->out |= BIT(gpio_num);
+ else
+ gpio->out &= ~BIT(gpio_num);
+
+ error = ti_ssp_raw_write(gpio->dev, gpio->out);
+
+error:
+ spin_unlock(&gpio->lock);
+ return error;
+}
+
+static int ti_ssp_gpio_get(struct gpio_chip *chip, unsigned gpio_num)
+{
+ struct ti_ssp_gpio_chip *gpio = to_ssp_gpio_chip(chip);
+ int ret;
+
+ spin_lock(&gpio->lock);
+
+ ret = ti_ssp_raw_read(gpio->dev);
+ if (ret >= 0)
+ ret = !!(ret & BIT(gpio_num));
+
+ spin_unlock(&gpio->lock);
+ return ret;
+}
+
+static void ti_ssp_gpio_set(struct gpio_chip *chip, unsigned gpio_num, int val)
+{
+ struct ti_ssp_gpio_chip *gpio = to_ssp_gpio_chip(chip);
+
+ spin_lock(&gpio->lock);
+
+ if (val)
+ gpio->out |= BIT(gpio_num);
+ else
+ gpio->out &= ~BIT(gpio_num);
+
+ ti_ssp_raw_write(gpio->dev, gpio->out);
+
+ spin_unlock(&gpio->lock);
+}
+
+static int __devinit ti_ssp_gpio_probe(struct platform_device *pdev)
+{
+ const struct ti_ssp_gpio_data *pdata = pdev->dev.platform_data;
+ struct device *dev = &pdev->dev;
+ struct ti_ssp_gpio_chip *gpio;
+ int error;
+
+ if (!pdata) {
+ dev_err(dev, "platform data not found\n");
+ return -EINVAL;
+ }
+
+ gpio = kzalloc(sizeof(*gpio), GFP_KERNEL);
+ if (!gpio) {
+ dev_err(dev, "cannot allocate driver data\n");
+ return -ENOMEM;
+ }
+
+ gpio->dev = dev;
+ gpio->iosel = SSP_PIN_SEL(0, SSP_IN) | SSP_PIN_SEL(1, SSP_IN) |
+ SSP_PIN_SEL(2, SSP_IN) | SSP_PIN_SEL(3, SSP_IN);
+ error = ti_ssp_set_iosel(gpio->dev, gpio->iosel);
+ if (error < 0) {
+ dev_err(dev, "gpio io setup failed (%d)\n", error);
+ goto error;
+ }
+
+ spin_lock_init(&gpio->lock);
+ platform_set_drvdata(pdev, gpio);
+
+ gpio->chip.base = pdata->start;
+ gpio->chip.ngpio = 4;
+ gpio->chip.dev = &pdev->dev;
+ gpio->chip.label = "ti_ssp_gpio";
+ gpio->chip.owner = THIS_MODULE;
+ gpio->chip.get = ti_ssp_gpio_get;
+ gpio->chip.set = ti_ssp_gpio_set;
+ gpio->chip.direction_input = ti_ssp_gpio_dir_in;
+ gpio->chip.direction_output = ti_ssp_gpio_dir_out;
+
+ error = gpiochip_add(&gpio->chip);
+ if (error < 0) {
+ dev_err(dev, "gpio chip registration failed (%d)\n", error);
+ goto error;
+ }
+
+ dev_info(dev, "ssp gpio interface registered\n");
+ return 0;
+
+error:
+ kfree(gpio);
+ return error;
+}
+
+static int __devexit ti_ssp_gpio_remove(struct platform_device *pdev)
+{
+ struct ti_ssp_gpio_chip *gpio = platform_get_drvdata(pdev);
+ int error;
+
+ error = gpiochip_remove(&gpio->chip);
+ if (error < 0)
+ return error;
+ kfree(gpio);
+ return 0;
+}
+
+static struct platform_driver ti_ssp_gpio_driver = {
+ .probe = ti_ssp_gpio_probe,
+ .remove = __devexit_p(ti_ssp_gpio_remove),
+ .driver = {
+ .name = "ti-ssp-gpio",
+ .owner = THIS_MODULE,
+ },
+};
+
+static int __init ti_ssp_gpio_init(void)
+{
+ return platform_driver_register(&ti_ssp_gpio_driver);
+}
+module_init(ti_ssp_gpio_init);
+
+static void __exit ti_ssp_gpio_exit(void)
+{
+ platform_driver_unregister(&ti_ssp_gpio_driver);
+}
+module_exit(ti_ssp_gpio_exit);
+
+MODULE_DESCRIPTION("GPIO interface for TI-SSP");
+MODULE_AUTHOR("Cyril Chemparathy <cyril@...com>");
+MODULE_LICENSE("GPL");
+MODULE_ALIAS("platform:ti-ssp-gpio");
diff --git a/include/linux/mfd/ti_ssp.h b/include/linux/mfd/ti_ssp.h
index dbb4b43..10c65bb 100644
--- a/include/linux/mfd/ti_ssp.h
+++ b/include/linux/mfd/ti_ssp.h
@@ -38,6 +38,10 @@ struct ti_ssp_spi_data {
void (*select)(int cs);
};
+struct ti_ssp_gpio_data {
+ int start;
+};
+
/*
* Sequencer port IO pin configuration bits. These do not correlate 1-1 with
* the hardware. The iosel field in the port data combines iosel1 and iosel2,
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists