| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20110327213220.GE2322@linux.vnet.ibm.com> Date: Sun, 27 Mar 2011 14:32:20 -0700 From: "Paul E. McKenney" <paulmck@...ux.vnet.ibm.com> To: sedat.dilek@...il.com Cc: Josh Triplett <josh@...htriplett.org>, linux-next <linux-next@...r.kernel.org>, LKML <linux-kernel@...r.kernel.org>, Stephen Rothwell <sfr@...b.auug.org.au>, Randy Dunlap <randy.dunlap@...cle.com>, "Theodore Ts'o" <tytso@....edu>, Jens Axboe <axboe@...nel.dk>, Tejun Heo <tj@...nel.org>, Al Viro <viro@...iv.linux.org.uk>, Nick Piggin <npiggin@...nel.dk> Subject: Re: linux-next: Tree for March 25 (Call trace: RCU|workqueues|block|VFS|ext4 related?) On Sun, Mar 27, 2011 at 02:26:15PM +0200, Sedat Dilek wrote: > On Sun, Mar 27, 2011 at 7:07 AM, Paul E. McKenney > <paulmck@...ux.vnet.ibm.com> wrote: > > On Sat, Mar 26, 2011 at 08:25:29PM -0700, Paul E. McKenney wrote: > >> On Sun, Mar 27, 2011 at 03:30:34AM +0200, Sedat Dilek wrote: > >> > On Sun, Mar 27, 2011 at 1:09 AM, Paul E. McKenney > >> > <paulmck@...ux.vnet.ibm.com> wrote: > >> > > On Sat, Mar 26, 2011 at 11:15:22PM +0100, Sedat Dilek wrote: > > > > [ . . . ] > > > >> > >> But then came RCU :-(. > >> > > > >> > > Well, if it turns out to be a problem in RCU I will certainly apologize. > >> > > > >> > > >> > No, that's not so dramatic. > >> > Dealing with this RCU issue has nice side-effects: I remembered (and > >> > finally did) to use a reduced kernel-config set. > >> > The base for it I created with 'make localmodconfig' and did some > >> > manual fine-tuning afterwards (throw out media, rc, dvd, unneeded FSs, > >> > etc.). > >> > Also, I can use fresh gcc-4.6 (4.6.0-1) from the official Debian repos. > >> > > >> > So, I started building with > >> > "revert-rcu-patches/0001-Revert-rcu-introduce-kfree_rcu.patch". > >> > I will let you know. > >> > >> And please also check for tasks consuming all available CPU. > > > > And I still cannot reproduce with the full RCU stack (but based off of > > 2.6.38 rather than -next). Nevertheless, if you would like to try a > > speculative patch, here you go. > > You are right and my strategy on handling the (possible RCU?) issue is wrong. > Surely, you tested your RCU stuff in your own repo and everything > might be OK on top of stable 2.6.38. > Linux-next gets daily updates from a lot of different trees, so there > might be interferences with other stuff. > Please, understand I am interested in finding out what is the cause > for my issues, my aim is not to blame you. I am not worried about blame, but rather getting the bug fixed. The bug might be in RCU, it might be elsewhere, or it might be a combination of problems in RCU and elsewhere. So the first priority is locating the bug. And that is why I have been asking you over and over to PLEASE take a look at what tasks are consuming CPU while the problem is occuring. The reason that I have been asking over and over is that the symptoms you describe are likely caused by a loop in some kernel code. Yes, there might be other causes, but this is the most likely. Given that TREE_PREEMPT_RCU behaves better than TREE_RCU, it is likely that this loop is in preemptible code with irqs enabled. Therefore, the process accounting code is likely to be able to see the CPU consumption, and you should be able to see it via the "top" or "ps" commands -- or via any number of other tools. For example, if the problem is confined to RCU, you would likely see the "rcuc0" or "rcun0" tasks consuming lots of CPU. This would narrow the problem down to a few tens of lines of code. If the problem was in some other kthread, then identifying the kthread would very likely narrow things down as well. So, please do take a look to see what taks consuming CPU. > As I was wrong and want to be 99.9% sure it is RCU stuff, I reverted > all (18) RCU patches from linux-next (next-20110325) by keeping the > RCU|PREEMPT|HZ settings from last working next-20110323. Makes sense. > $ egrep 'RCU|PREEMPT|_HZ' /boot/config-2.6.38-next20110325-7-686-iniza > # RCU Subsystem > CONFIG_TREE_RCU=y > # CONFIG_PREEMPT_RCU is not set > # CONFIG_RCU_TRACE is not set > CONFIG_RCU_FANOUT=32 > # CONFIG_RCU_FANOUT_EXACT is not set > CONFIG_RCU_FAST_NO_HZ=y > # CONFIG_TREE_RCU_TRACE is not set > CONFIG_PREEMPT_NOTIFIERS=y > CONFIG_NO_HZ=y > # CONFIG_PREEMPT_NONE is not set > CONFIG_PREEMPT_VOLUNTARY=y > # CONFIG_PREEMPT is not set > # CONFIG_HZ_100 is not set > CONFIG_HZ_250=y > # CONFIG_HZ_300 is not set > # CONFIG_HZ_1000 is not set > CONFIG_HZ=250 > # CONFIG_SPARSE_RCU_POINTER is not set > # CONFIG_RCU_TORTURE_TEST is not set > # CONFIG_RCU_CPU_STALL_DETECTOR is not set > > I will work and stress this kernel before doing any step-by-step > revert of RCU stuff. > > Thanks for your patch, I applied it on top of "naked" next-20110325, > but I still see call-traces. Thank you very much for testing it! I intend to keep that patch, as it should increase robustness in other situations. Thanx, Paul > - Sedat - > > > > > Thanx, Paul > > > > ------------------------------------------------------------------------ > > > > rcu: further lower priority in rcu_yield() > > > > Although rcu_yield() dropped from real-time to normal priority, there > > is always the possibility that the competing tasks have been niced. > > So nice to 19 in rcu_yield() to help ensure that other tasks have a > > better chance of running. > > > > Signed-off-by: Paul E. McKenney <paulmck@...ux.vnet.ibm.com> > > > > diff --git a/kernel/rcutree.c b/kernel/rcutree.c > > index 759f54b..5477764 100644 > > --- a/kernel/rcutree.c > > +++ b/kernel/rcutree.c > > @@ -1492,6 +1492,7 @@ static void rcu_yield(void (*f)(unsigned long), unsigned long arg) > > mod_timer(&yield_timer, jiffies + 2); > > sp.sched_priority = 0; > > sched_setscheduler_nocheck(current, SCHED_NORMAL, &sp); > > + set_user_nice(current, 19); > > schedule(); > > sp.sched_priority = RCU_KTHREAD_PRIO; > > sched_setscheduler_nocheck(current, SCHED_FIFO, &sp); > > -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@...r.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists