| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <BANLkTi=ey_dGo2W6SG4su_VaNP56nC8s3w@mail.gmail.com>
Date: Mon, 28 Mar 2011 18:13:03 +0200
From: "Andre \"Osku\" Schmidt" <andre.osku.schmidt@...glemail.com>
To: Greg KH <gregkh@...e.de>
Cc: linux-kernel@...r.kernel.org, stable@...nel.org,
stable-review@...nel.org, torvalds@...ux-foundation.org,
akpm@...ux-foundation.org, alan@...rguk.ukuu.org.uk,
Alan Stern <stern@...land.harvard.edu>,
David Brownell <david-b@...bell.net>
Subject: Re: [39/45] OHCI: work around for nVidia shutdown problem
On Fri, Nov 19, 2010 at 10:43 PM, Greg KH <gregkh@...e.de> wrote:
> 2.6.32-stable review patch. If anyone has any objections, please let us know.
>
> ------------------
>
> From: Alan Stern <stern@...land.harvard.edu>
>
> commit 3df7169e73fc1d71a39cffeacc969f6840cdf52b upstream.
>
> This patch (as1417) fixes a problem affecting some (or all) nVidia
> chipsets. When the computer is shut down, the OHCI controllers
> continue to power the USB buses and evidently they drive a Reset
> signal out all their ports. This prevents attached devices from going
> to low power. Mouse LEDs stay on, for example, which is disconcerting
> for users and a drain on laptop batteries.
>
> The fix involves leaving each OHCI controller in the OPERATIONAL state
> during system shutdown rather than putting it in the RESET state.
> Although this nominally means the controller is running, in fact it's
> not doing very much since all the schedules are all disabled. However
> there is ongoing DMA to the Host Controller Communications Area, so
> the patch also disables the bus-master capability of all PCI USB
> controllers after the shutdown routine runs.
>
> The fix is applied only to nVidia-based PCI OHCI controllers, so it
> shouldn't cause problems on systems using other hardware. As an added
> safety measure, in case the kernel encounters one of these running
> controllers during boot, the patch changes quirk_usb_handoff_ohci()
> (which runs early on during PCI discovery) to reset the controller
> before anything bad can happen.
>
> Reported-by: Pali Rohár <pali.rohar@...il.com>
> Signed-off-by: Alan Stern <stern@...land.harvard.edu>
> CC: David Brownell <david-b@...bell.net>
> Tested-by: Pali Rohár <pali.rohar@...il.com>
> Signed-off-by: Greg Kroah-Hartman <gregkh@...e.de>
>
> ---
> drivers/usb/core/hcd-pci.c | 4 +++-
> drivers/usb/host/ohci-hcd.c | 9 ++++++++-
> drivers/usb/host/ohci-pci.c | 18 ++++++++++++++++++
> drivers/usb/host/ohci.h | 1 +
> drivers/usb/host/pci-quirks.c | 18 +++++++++++-------
> 5 files changed, 41 insertions(+), 9 deletions(-)
>
> --- a/drivers/usb/core/hcd-pci.c
> +++ b/drivers/usb/core/hcd-pci.c
> @@ -197,8 +197,10 @@ void usb_hcd_pci_shutdown(struct pci_dev
> if (!hcd)
> return;
>
> - if (hcd->driver->shutdown)
> + if (hcd->driver->shutdown) {
> hcd->driver->shutdown(hcd);
> + pci_disable_device(dev);
> + }
> }
> EXPORT_SYMBOL_GPL(usb_hcd_pci_shutdown);
>
> --- a/drivers/usb/host/ohci-hcd.c
> +++ b/drivers/usb/host/ohci-hcd.c
> @@ -398,7 +398,14 @@ ohci_shutdown (struct usb_hcd *hcd)
>
> ohci = hcd_to_ohci (hcd);
> ohci_writel (ohci, OHCI_INTR_MIE, &ohci->regs->intrdisable);
> - ohci_usb_reset (ohci);
> + ohci->hc_control = ohci_readl(ohci, &ohci->regs->control);
> +
> + /* If the SHUTDOWN quirk is set, don't put the controller in RESET */
> + ohci->hc_control &= (ohci->flags & OHCI_QUIRK_SHUTDOWN ?
> + OHCI_CTRL_RWC | OHCI_CTRL_HCFS :
> + OHCI_CTRL_RWC);
> + ohci_writel(ohci, ohci->hc_control, &ohci->regs->control);
> +
> /* flush the writes */
> (void) ohci_readl (ohci, &ohci->regs->control);
> }
> --- a/drivers/usb/host/ohci-pci.c
> +++ b/drivers/usb/host/ohci-pci.c
> @@ -201,6 +201,20 @@ static int ohci_quirk_amd700(struct usb_
> return 0;
> }
>
> +/* nVidia controllers continue to drive Reset signalling on the bus
> + * even after system shutdown, wasting power. This flag tells the
> + * shutdown routine to leave the controller OPERATIONAL instead of RESET.
> + */
> +static int ohci_quirk_nvidia_shutdown(struct usb_hcd *hcd)
> +{
> + struct ohci_hcd *ohci = hcd_to_ohci(hcd);
> +
> + ohci->flags |= OHCI_QUIRK_SHUTDOWN;
> + ohci_dbg(ohci, "enabled nVidia shutdown quirk\n");
> +
> + return 0;
> +}
> +
> /*
> * The hardware normally enables the A-link power management feature, which
> * lets the system lower the power consumption in idle states.
> @@ -332,6 +346,10 @@ static const struct pci_device_id ohci_p
> PCI_DEVICE(PCI_VENDOR_ID_ATI, 0x4399),
> .driver_data = (unsigned long)ohci_quirk_amd700,
> },
> + {
> + PCI_DEVICE(PCI_VENDOR_ID_NVIDIA, PCI_ANY_ID),
> + .driver_data = (unsigned long) ohci_quirk_nvidia_shutdown,
> + },
>
> /* FIXME for some of the early AMD 760 southbridges, OHCI
> * won't work at all. blacklist them.
> --- a/drivers/usb/host/ohci.h
> +++ b/drivers/usb/host/ohci.h
> @@ -403,6 +403,7 @@ struct ohci_hcd {
> #define OHCI_QUIRK_HUB_POWER 0x100 /* distrust firmware power/oc setup */
> #define OHCI_QUIRK_AMD_ISO 0x200 /* ISO transfers*/
> #define OHCI_QUIRK_AMD_PREFETCH 0x400 /* pre-fetch for ISO transfer */
> +#define OHCI_QUIRK_SHUTDOWN 0x800 /* nVidia power bug */
> // there are also chip quirks/bugs in init logic
>
> struct work_struct nec_work; /* Worker for NEC quirk */
> --- a/drivers/usb/host/pci-quirks.c
> +++ b/drivers/usb/host/pci-quirks.c
> @@ -169,6 +169,7 @@ static int __devinit mmio_resource_enabl
> static void __devinit quirk_usb_handoff_ohci(struct pci_dev *pdev)
> {
> void __iomem *base;
> + u32 control;
>
> if (!mmio_resource_enabled(pdev, 0))
> return;
> @@ -177,10 +178,14 @@ static void __devinit quirk_usb_handoff_
> if (base == NULL)
> return;
>
> + control = readl(base + OHCI_CONTROL);
> +
> /* On PA-RISC, PDC can leave IR set incorrectly; ignore it there. */
> -#ifndef __hppa__
> -{
> - u32 control = readl(base + OHCI_CONTROL);
> +#ifdef __hppa__
> +#define OHCI_CTRL_MASK (OHCI_CTRL_RWC | OHCI_CTRL_IR)
> +#else
> +#define OHCI_CTRL_MASK OHCI_CTRL_RWC
> +
> if (control & OHCI_CTRL_IR) {
> int wait_time = 500; /* arbitrary; 5 seconds */
> writel(OHCI_INTR_OC, base + OHCI_INTRENABLE);
> @@ -194,13 +199,12 @@ static void __devinit quirk_usb_handoff_
> dev_warn(&pdev->dev, "OHCI: BIOS handoff failed"
> " (BIOS bug?) %08x\n",
> readl(base + OHCI_CONTROL));
> -
> - /* reset controller, preserving RWC */
> - writel(control & OHCI_CTRL_RWC, base + OHCI_CONTROL);
> }
> -}
> #endif
>
> + /* reset controller, preserving RWC (and possibly IR) */
> + writel(control & OHCI_CTRL_MASK, base + OHCI_CONTROL);
> +
> /*
> * disable interrupts
> */
>
>
Hello,
i think it was back when my distro got linux 2.6.37 that i noticed the
usb devices are not powered off anymore during shutdown. i was(/am)
lazy and didn't bother to investigate, until today. i found
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/42149 which
mentioned this patch (and that it was supposedly added in 2.6.37).
i boldly reversed this part for my current kernel (2.6.38.1) and build it*:
--- a/drivers/usb/host/ohci-hcd.c
+++ b/drivers/usb/host/ohci-hcd.c
@@ -398,7 +398,14 @@ ohci_shutdown (struct usb_hcd *hcd)
ohci = hcd_to_ohci (hcd);
ohci_writel (ohci, OHCI_INTR_MIE, &ohci->regs->intrdisable);
- ohci_usb_reset (ohci);
+ ohci->hc_control = ohci_readl(ohci, &ohci->regs->control);
+
+ /* If the SHUTDOWN quirk is set, don't put the controller in RESET */
+ ohci->hc_control &= (ohci->flags & OHCI_QUIRK_SHUTDOWN ?
+ OHCI_CTRL_RWC | OHCI_CTRL_HCFS :
+ OHCI_CTRL_RWC);
+ ohci_writel(ohci, ohci->hc_control, &ohci->regs->control);
+
/* flush the writes */
(void) ohci_readl (ohci, &ohci->regs->control);
}
lo and behold, my usb devices are now powered off again at shutdown.
this was my first ever hack on the linux code, and i have no real idea
what i'm doing here...
but if theres anything i can do to help to solve this problem, please
let me know!
lspci -v | grep USB
00:0b.0 USB Controller: nVidia Corporation MCP51 USB Controller (rev
a3) (prog-if 10 [OHCI])
00:0b.1 USB Controller: nVidia Corporation MCP51 USB Controller (rev
a3) (prog-if 20 [EHCI])
cheers
.andre
* by following this method
https://wiki.archlinux.org/index.php/Kernel_Compilation
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists