[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <1330563422-14078-4-git-send-email-ddaney.cavm@gmail.com>
Date: Wed, 29 Feb 2012 16:57:00 -0800
From: David Daney <ddaney.cavm@...il.com>
To: linux-mips@...ux-mips.org, ralf@...ux-mips.org,
devicetree-discuss@...ts.ozlabs.org,
Grant Likely <grant.likely@...retlab.ca>,
Rob Herring <rob.herring@...xeda.com>
Cc: linux-kernel@...r.kernel.org, David Daney <david.daney@...ium.com>
Subject: [PATCH v6 3/5] MIPS: Octeon: Add irq handlers for GPIO interrupts.
From: David Daney <david.daney@...ium.com>
This is needed for follow-on on patches for Octeon to use the Device
Tree to configure GPIO interrupts.
Signed-off-by: David Daney <david.daney@...ium.com>
---
arch/mips/cavium-octeon/octeon-irq.c | 96 +++++++++++++++++++++++++++++++++-
1 files changed, 95 insertions(+), 1 deletions(-)
diff --git a/arch/mips/cavium-octeon/octeon-irq.c b/arch/mips/cavium-octeon/octeon-irq.c
index ffd4ae6..bdcedd3 100644
--- a/arch/mips/cavium-octeon/octeon-irq.c
+++ b/arch/mips/cavium-octeon/octeon-irq.c
@@ -505,6 +505,72 @@ static void octeon_irq_ciu_enable_all_v2(struct irq_data *data)
}
}
+static void octeon_irq_gpio_setup(struct irq_data *data)
+{
+ union cvmx_gpio_bit_cfgx cfg;
+ int bit = data->irq - OCTEON_IRQ_GPIO0;
+ u32 t = irqd_get_trigger_type(data);
+
+ cfg.u64 = 0;
+ cfg.s.int_en = 1;
+ cfg.s.int_type = (t & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING)) != 0;
+ cfg.s.rx_xor = (t & (IRQ_TYPE_LEVEL_LOW | IRQ_TYPE_EDGE_FALLING)) != 0;
+
+ /* 1 uS glitch filter*/
+ cfg.s.fil_cnt = 7;
+ cfg.s.fil_sel = 3;
+
+ cvmx_write_csr(CVMX_GPIO_BIT_CFGX(bit), cfg.u64);
+}
+
+static void octeon_irq_ciu_enable_gpio_v2(struct irq_data *data)
+{
+ octeon_irq_gpio_setup(data);
+ octeon_irq_ciu_enable_v2(data);
+}
+
+static void octeon_irq_ciu_enable_gpio(struct irq_data *data)
+{
+ octeon_irq_gpio_setup(data);
+ octeon_irq_ciu_enable(data);
+}
+
+static int octeon_irq_ciu_gpio_set_type(struct irq_data *data, unsigned int t)
+{
+ u32 current_type = irqd_get_trigger_type(data);
+
+ /* If the type has been set, don't change it */
+ if (current_type && current_type != t)
+ return -EINVAL;
+
+ irqd_set_trigger_type(data, t);
+ return IRQ_SET_MASK_OK;
+}
+
+static void octeon_irq_ciu_disable_gpio_v2(struct irq_data *data)
+{
+ int bit = data->irq - OCTEON_IRQ_GPIO0;
+ cvmx_write_csr(CVMX_GPIO_BIT_CFGX(bit), 0);
+
+ octeon_irq_ciu_disable_all_v2(data);
+}
+
+static void octeon_irq_ciu_disable_gpio(struct irq_data *data)
+{
+ int bit = data->irq - OCTEON_IRQ_GPIO0;
+ cvmx_write_csr(CVMX_GPIO_BIT_CFGX(bit), 0);
+
+ octeon_irq_ciu_disable_all(data);
+}
+
+static void octeon_irq_ciu_gpio_ack(struct irq_data *data)
+{
+ int bit = data->irq - OCTEON_IRQ_GPIO0;
+ u64 mask = 1ull << bit;
+
+ cvmx_write_csr(CVMX_GPIO_INT_CLR, mask);
+}
+
#ifdef CONFIG_SMP
static void octeon_irq_cpu_offline_ciu(struct irq_data *data)
@@ -717,6 +783,31 @@ static struct irq_chip octeon_irq_chip_ciu_mbox = {
.flags = IRQCHIP_ONOFFLINE_ENABLED,
};
+static struct irq_chip octeon_irq_chip_ciu_gpio_v2 = {
+ .name = "CIU-GPIO",
+ .irq_enable = octeon_irq_ciu_enable_gpio_v2,
+ .irq_disable = octeon_irq_ciu_disable_gpio_v2,
+ .irq_ack = octeon_irq_ciu_gpio_ack,
+ .irq_mask = octeon_irq_ciu_disable_local_v2,
+ .irq_unmask = octeon_irq_ciu_enable_v2,
+ .irq_set_type = octeon_irq_ciu_gpio_set_type,
+#ifdef CONFIG_SMP
+ .irq_set_affinity = octeon_irq_ciu_set_affinity_v2,
+#endif
+};
+
+static struct irq_chip octeon_irq_chip_ciu_gpio = {
+ .name = "CIU-GPIO",
+ .irq_enable = octeon_irq_ciu_enable_gpio,
+ .irq_disable = octeon_irq_ciu_disable_gpio,
+ .irq_mask = octeon_irq_dummy_mask,
+ .irq_ack = octeon_irq_ciu_gpio_ack,
+ .irq_set_type = octeon_irq_ciu_gpio_set_type,
+#ifdef CONFIG_SMP
+ .irq_set_affinity = octeon_irq_ciu_set_affinity,
+#endif
+};
+
/*
* Watchdog interrupts are special. They are associated with a single
* core, so we hardwire the affinity to that core.
@@ -890,6 +981,7 @@ static void __init octeon_irq_init_ciu(void)
struct irq_chip *chip_edge;
struct irq_chip *chip_mbox;
struct irq_chip *chip_wd;
+ struct irq_chip *chip_gpio;
octeon_irq_init_ciu_percpu();
octeon_irq_setup_secondary = octeon_irq_setup_secondary_ciu;
@@ -904,6 +996,7 @@ static void __init octeon_irq_init_ciu(void)
chip_edge = &octeon_irq_chip_ciu_edge_v2;
chip_mbox = &octeon_irq_chip_ciu_mbox_v2;
chip_wd = &octeon_irq_chip_ciu_wd_v2;
+ chip_gpio = &octeon_irq_chip_ciu_gpio_v2;
} else {
octeon_irq_ip2 = octeon_irq_ip2_v1;
octeon_irq_ip3 = octeon_irq_ip3_v1;
@@ -911,6 +1004,7 @@ static void __init octeon_irq_init_ciu(void)
chip_edge = &octeon_irq_chip_ciu_edge;
chip_mbox = &octeon_irq_chip_ciu_mbox;
chip_wd = &octeon_irq_chip_ciu_wd;
+ chip_gpio = &octeon_irq_chip_ciu_gpio;
}
octeon_irq_ip4 = octeon_irq_ip4_mask;
@@ -921,7 +1015,7 @@ static void __init octeon_irq_init_ciu(void)
for (i = 0; i < 16; i++)
octeon_irq_set_ciu_mapping(i + OCTEON_IRQ_WORKQ0, 0, i + 0, chip, handle_level_irq);
for (i = 0; i < 16; i++)
- octeon_irq_set_ciu_mapping(i + OCTEON_IRQ_GPIO0, 0, i + 16, chip, handle_level_irq);
+ octeon_irq_set_ciu_mapping(i + OCTEON_IRQ_GPIO0, 0, i + 16, chip_gpio, handle_level_irq);
octeon_irq_set_ciu_mapping(OCTEON_IRQ_MBOX0, 0, 32, chip_mbox, handle_percpu_irq);
octeon_irq_set_ciu_mapping(OCTEON_IRQ_MBOX1, 0, 33, chip_mbox, handle_percpu_irq);
--
1.7.2.3
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists