| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <4F79D0BB020000780007C02D@nat28.tlf.novell.com>
Date: Mon, 02 Apr 2012 15:15:55 +0100
From: "Jan Beulich" <JBeulich@...e.com>
To: <mingo@...e.hu>, <tglx@...utronix.de>, <hpa@...or.com>
Cc: <linux-kernel@...r.kernel.org>
Subject: [PATCH] x86: clear HPET configuration registers on startup
While Linux itself has been calling hpet_disable() for quite a while,
having e.g. a secondary (kexec) kernel depend on such behavior of the
primary (crashed) environment is fragile. It particularly broke until
very recently when the primary environment was Xen based, as that
hypervisor did not clear any of the HPET settings it may have used.
Rather than blindly (and incompletely) clearing certain HPET settings
in hpet_disable(), latch the config register settings during boot and
restore then here.
(Note on the hpet_set_mode() change: Now that we're clearing the level
bit upon initialization, there's no need anymore to do so here.)
Signed-off-by: Jan Beulich <jbeulich@...e.com>
---
arch/x86/kernel/hpet.c | 59 ++++++++++++++++++++++++++++++++++++++++++-------
1 file changed, 51 insertions(+), 8 deletions(-)
--- 3.4-rc1-x86-hpet.orig/arch/x86/kernel/hpet.c
+++ 3.4-rc1-x86-hpet/arch/x86/kernel/hpet.c
@@ -319,8 +319,6 @@ static void hpet_set_mode(enum clock_eve
now = hpet_readl(HPET_COUNTER);
cmp = now + (unsigned int) delta;
cfg = hpet_readl(HPET_Tn_CFG(timer));
- /* Make sure we use edge triggered interrupts */
- cfg &= ~HPET_TN_LEVEL;
cfg |= HPET_TN_ENABLE | HPET_TN_PERIODIC |
HPET_TN_SETVAL | HPET_TN_32BIT;
hpet_writel(cfg, HPET_Tn_CFG(timer));
@@ -787,15 +785,16 @@ static int hpet_clocksource_register(voi
return 0;
}
+static u32 *hpet_boot_cfg;
+
/**
* hpet_enable - Try to setup the HPET timer. Returns 1 on success.
*/
int __init hpet_enable(void)
{
- unsigned long hpet_period;
- unsigned int id;
+ u32 hpet_period, cfg, id;
u64 freq;
- int i;
+ unsigned int i, last;
if (!is_hpet_capable())
return 0;
@@ -847,15 +846,45 @@ int __init hpet_enable(void)
id = hpet_readl(HPET_ID);
hpet_print_config();
+ last = (id & HPET_ID_NUMBER) >> HPET_ID_NUMBER_SHIFT;
+
#ifdef CONFIG_HPET_EMULATE_RTC
/*
* The legacy routing mode needs at least two channels, tick timer
* and the rtc emulation channel.
*/
- if (!(id & HPET_ID_NUMBER))
+ if (!last)
goto out_nohpet;
#endif
+ cfg = hpet_readl(HPET_CFG);
+ hpet_boot_cfg = kmalloc((last + 2) * sizeof(*hpet_boot_cfg),
+ GFP_KERNEL);
+ if (hpet_boot_cfg)
+ *hpet_boot_cfg = cfg;
+ else
+ pr_warn("HPET initial state will not be saved\n");
+ cfg &= ~(HPET_CFG_ENABLE | HPET_CFG_LEGACY);
+ hpet_writel(cfg, HPET_Tn_CFG(i));
+ if (cfg)
+ pr_warn("HPET: Unrecognized bits %#x set in global cfg\n",
+ cfg);
+
+ for (i = 0; i <= last; ++i) {
+ cfg = hpet_readl(HPET_Tn_CFG(i));
+ if (hpet_boot_cfg)
+ hpet_boot_cfg[i + 1] = cfg;
+ cfg &= ~(HPET_TN_ENABLE | HPET_TN_LEVEL | HPET_TN_FSB);
+ hpet_writel(cfg, HPET_Tn_CFG(i));
+ cfg &= ~(HPET_TN_PERIODIC | HPET_TN_PERIODIC_CAP
+ | HPET_TN_64BIT_CAP | HPET_TN_32BIT | HPET_TN_ROUTE
+ | HPET_TN_FSB | HPET_TN_FSB_CAP);
+ if (cfg)
+ pr_warn("HPET: Unrecognized bits %#x set in cfg#%u\n",
+ cfg, i);
+ }
+ hpet_print_config();
+
if (hpet_clocksource_register())
goto out_nohpet;
@@ -923,14 +952,28 @@ fs_initcall(hpet_late_init);
void hpet_disable(void)
{
if (is_hpet_capable() && hpet_virt_address) {
- unsigned int cfg = hpet_readl(HPET_CFG);
+ unsigned int cfg = hpet_readl(HPET_CFG), id, last;
- if (hpet_legacy_int_enabled) {
+ if (hpet_boot_cfg)
+ cfg = *hpet_boot_cfg;
+ else if (hpet_legacy_int_enabled) {
cfg &= ~HPET_CFG_LEGACY;
hpet_legacy_int_enabled = 0;
}
cfg &= ~HPET_CFG_ENABLE;
hpet_writel(cfg, HPET_CFG);
+
+ if (!hpet_boot_cfg)
+ return;
+
+ id = hpet_readl(HPET_ID);
+ last = ((id & HPET_ID_NUMBER) >> HPET_ID_NUMBER_SHIFT);
+
+ for (id = 0; id <= last; ++id)
+ hpet_writel(hpet_boot_cfg[id + 1], HPET_Tn_CFG(id));
+
+ if (*hpet_boot_cfg & HPET_CFG_ENABLE)
+ hpet_writel(*hpet_boot_cfg, HPET_CFG);
}
}
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists