| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1335470290-3436-1-git-send-email-stigge@antcom.de>
Date: Thu, 26 Apr 2012 21:58:09 +0200
From: Roland Stigge <stigge@...com.de>
To: stern@...land.harvard.edu, gregkh@...uxfoundation.org,
grant.likely@...retlab.ca, rob.herring@...xeda.com,
linux-usb@...r.kernel.org, linux-kernel@...r.kernel.org,
devicetree-discuss@...ts.ozlabs.org,
linux-arm-kernel@...ts.infradead.org
Cc: Roland Stigge <stigge@...com.de>
Subject: [PATCH RESEND v5 1/2] ohci-nxp: Driver cleanup
Cleanup for ohci-nxp.c:
* Cleanup of resource handling (mem and irq), use devm_request_and_ioremap()
* Use DMA_BIT_MASK()
* Don't remove __devinit
* Removed obsolete gpio.h include
* More consistent bit access symbols
* Removed unused extern declaration ocpi_enable()
* Added error handling on i2c_get_adapter()
* Whitespace cleanup
Signed-off-by: Roland Stigge <stigge@...com.de>
---
Applies to v3.4-rc4
I separated these two patches out from the series of LPC32xx conversion since
most of the other patches are already integrated into the respective
subsystem's -next branches.
drivers/usb/host/ohci-nxp.c | 44 ++++++++++++++++++++++++++------------------
1 file changed, 26 insertions(+), 18 deletions(-)
--- linux-2.6.orig/drivers/usb/host/ohci-nxp.c
+++ linux-2.6/drivers/usb/host/ohci-nxp.c
@@ -29,7 +29,6 @@
#include <mach/platform.h>
#include <mach/irqs.h>
-#include <asm/gpio.h>
#define USB_CONFIG_BASE 0x31020000
#define PWRMAN_BASE 0x40004000
@@ -38,7 +37,9 @@
/* USB_CTRL bit defines */
#define USB_SLAVE_HCLK_EN (1 << 24)
+#define USB_DEV_NEED_CLK_EN (1 << 22)
#define USB_HOST_NEED_CLK_EN (1 << 21)
+#define PAD_CONTROL_LAST_DRIVEN (1 << 19)
#define USB_OTG_CLK_CTRL IO_ADDRESS(USB_CONFIG_BASE + 0xFF4)
#define USB_OTG_CLK_STAT IO_ADDRESS(USB_CONFIG_BASE + 0xFF8)
@@ -117,7 +118,6 @@ static struct i2c_driver isp1301_driver;
static struct i2c_client *isp1301_i2c_client;
extern int usb_disabled(void);
-extern int ocpi_enable(void);
static struct clk *usb_clk;
@@ -220,7 +220,7 @@ static void isp1301_configure_lpc32xx(vo
ISP1301_I2C_INTERRUPT_RISING | ISP1301_I2C_REG_CLEAR_ADDR, ~0);
/* Enable usb_need_clk clock after transceiver is initialized */
- __raw_writel((__raw_readl(USB_CTRL) | (1 << 22)), USB_CTRL);
+ __raw_writel(__raw_readl(USB_CTRL) | USB_HOST_NEED_CLK_EN, USB_CTRL);
printk(KERN_INFO "ISP1301 Vendor ID : 0x%04x\n",
i2c_smbus_read_word_data(isp1301_i2c_client, 0x00));
@@ -374,9 +374,13 @@ static int __devinit usb_hcd_nxp_probe(s
const struct hc_driver *driver = &ohci_nxp_hc_driver;
struct i2c_adapter *i2c_adap;
struct i2c_board_info i2c_info;
+ struct resource *res;
int ret = 0, irq;
+ pdev->dev.coherent_dma_mask = DMA_BIT_MASK(32);
+ pdev->dev.dma_mask = &pdev->dev.coherent_dma_mask;
+
dev_dbg(&pdev->dev, "%s: " DRIVER_DESC " (nxp)\n", hcd_name);
if (usb_disabled()) {
err("USB is disabled");
@@ -384,16 +388,8 @@ static int __devinit usb_hcd_nxp_probe(s
goto out;
}
- if (pdev->num_resources != 2
- || pdev->resource[0].flags != IORESOURCE_MEM
- || pdev->resource[1].flags != IORESOURCE_IRQ) {
- err("Invalid resource configuration");
- ret = -ENODEV;
- goto out;
- }
-
/* Enable AHB slave USB clock, needed for further USB clock control */
- __raw_writel(USB_SLAVE_HCLK_EN | (1 << 19), USB_CTRL);
+ __raw_writel(USB_SLAVE_HCLK_EN | PAD_CONTROL_LAST_DRIVEN, USB_CTRL);
ret = i2c_add_driver(&isp1301_driver);
if (ret < 0) {
@@ -401,6 +397,11 @@ static int __devinit usb_hcd_nxp_probe(s
goto out;
}
i2c_adap = i2c_get_adapter(2);
+ if (!i2c_adap) {
+ err("failed on i2c_get_adapter");
+ goto out_i2c_driver;
+ }
+
memset(&i2c_info, 0, sizeof(struct i2c_board_info));
strlcpy(i2c_info.type, "isp1301_nxp", I2C_NAME_SIZE);
isp1301_i2c_client = i2c_new_probed_device(i2c_adap, &i2c_info,
@@ -442,7 +443,7 @@ static int __devinit usb_hcd_nxp_probe(s
while ((__raw_readl(USB_OTG_CLK_STAT) & USB_CLOCK_MASK) !=
USB_CLOCK_MASK) ;
- hcd = usb_create_hcd (driver, &pdev->dev, dev_name(&pdev->dev));
+ hcd = usb_create_hcd(driver, &pdev->dev, dev_name(&pdev->dev));
if (!hcd) {
err("Failed to allocate HC buffer");
ret = -ENOMEM;
@@ -452,14 +453,21 @@ static int __devinit usb_hcd_nxp_probe(s
/* Set all USB bits in the Start Enable register */
nxp_set_usb_bits();
- hcd->rsrc_start = pdev->resource[0].start;
- hcd->rsrc_len = pdev->resource[0].end - pdev->resource[0].start + 1;
- if (!request_mem_region(hcd->rsrc_start, hcd->rsrc_len, hcd_name)) {
- dev_dbg(&pdev->dev, "request_mem_region failed\n");
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ if (!res) {
+ dev_err(&pdev->dev, "Failed to get MEM resource");
+ ret = -ENOMEM;
+ goto out4;
+ }
+
+ hcd->regs = devm_request_and_ioremap(&pdev->dev, res);
+ if (!hcd->regs) {
+ err("Failed to devm_request_and_ioremap");
ret = -ENOMEM;
goto out4;
}
- hcd->regs = (void __iomem *)pdev->resource[0].start;
+ hcd->rsrc_start = res->start;
+ hcd->rsrc_len = resource_size(res);
irq = platform_get_irq(pdev, 0);
if (irq < 0) {
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists