[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <50EF616E.7040609@wwwdotorg.org>
Date: Thu, 10 Jan 2013 17:48:46 -0700
From: Stephen Warren <swarren@...dotorg.org>
To: Thierry Reding <thierry.reding@...onic-design.de>
CC: linux-tegra@...r.kernel.org,
Grant Likely <grant.likely@...retlab.ca>,
Rob Herring <rob.herring@...xeda.com>,
Russell King <linux@....linux.org.uk>,
Bjorn Helgaas <bhelgaas@...gle.com>,
Andrew Murray <andrew.murray@....com>,
Jason Gunthorpe <jgunthorpe@...idianresearch.com>,
Arnd Bergmann <arnd@...db.de>,
Thomas Petazzoni <thomas.petazzoni@...e-electrons.com>,
devicetree-discuss@...ts.ozlabs.org, linux-kernel@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org, linux-pci@...r.kernel.org
Subject: Re: [PATCH 10/14] PCI: tegra: Move PCIe driver to drivers/pci/host
On 01/09/2013 01:43 PM, Thierry Reding wrote:
> Move the PCIe driver from arch/arm/mach-tegra into the drivers/pci/host
> directory. The motivation is to collect various host controller drivers
> in the same location in order to facilitate refactoring.
>
> The Tegra PCIe driver has been largely rewritten, both in order to turn
> it into a proper platform driver and to add MSI (based on code by
> Krishna Kishore <kthota@...dia.com>) as well as device tree support.
> diff --git a/arch/arm/mach-tegra/board-dt-tegra20.c b/arch/arm/mach-tegra/board-dt-tegra20.c
> static void __init trimslice_init(void)
> {
> #ifdef CONFIG_TEGRA_PCI
> - int ret;
> -
> - ret = tegra_pcie_init(true, true);
> - if (ret)
> - pr_err("tegra_pci_init() failed: %d\n", ret);
> + platform_device_register(&tegra_pcie_device);
That struct doesn't actually exist anywhere; only an extern definition
is added (and that extern definition isn't removed by patch 14 either).
> diff --git a/drivers/pci/host/Kconfig b/drivers/pci/host/Kconfig
> +config PCI_TEGRA
> + bool "NVIDIA Tegra PCIe controller"
> + depends on ARCH_TEGRA_2x_SOC
Perhaps depend on ARCH_TEGRA; that will save churn once this is ported
to Tegra30, and shouldn't cause any problems before then.
> diff --git a/drivers/pci/host/pci-tegra.c b/drivers/pci/host/pci-tegra.c
> +#define AFI_INTR_CODE 0xb8
> +#define AFI_INTR_CODE_MASK 0xf
> +#define AFI_INTR_MASTER_ABORT 4
> +#define AFI_INTR_LEGACY 6
Adding defines for at least some other codes here, would help further
below ...
> +static irqreturn_t tegra_pcie_isr(int irq, void *arg)
> + if (code == AFI_INTR_MASTER_ABORT) {
> + dev_dbg(pcie->dev, "%s, signature: %08x\n", err_msg[code],
> + signature);
> + } else
> + dev_err(pcie->dev, "%s, signature: %08x\n", err_msg[code],
> + signature);
> +
> + if (code == 3 || code == 4 || code == 7) {
... i.e. here.
> + u32 fpci = afi_readl(pcie, AFI_UPPER_FPCI_ADDRESS) & 0xff;
> + u64 address = (u64)fpci << 32 | (signature & 0xfffffffc);
> + dev_dbg(pcie->dev, " FPCI address: %10llx\n", address);
I'd suggest making that dev_err(), or at least something higher than
debug, since the message indicating the error happened is dev_err(), so
the complete details may as well be available since they're small.
> +static int tegra_pcie_enable_controller(struct tegra_pcie *pcie)
> +{
> + unsigned int timeout;
> + unsigned long value;
> +
> + /* enable dual controller and both ports */
> + value = afi_readl(pcie, AFI_PCIE_CONFIG);
> + value &= ~(AFI_PCIE_CONFIG_PCIEC0_DISABLE_DEVICE |
> + AFI_PCIE_CONFIG_PCIEC1_DISABLE_DEVICE |
> + AFI_PCIE_CONFIG_SM2TMS0_XBAR_CONFIG_MASK);
> + value |= AFI_PCIE_CONFIG_SM2TMS0_XBAR_CONFIG_DUAL;
> + afi_writel(pcie, value, AFI_PCIE_CONFIG);
Eventually, we should probably derive the port enables from the state of
the root port DT nodes, so that we can disable some and presumably save
a little power. Also, I notice that the nvidia,num-lanes property isn't
implemented yet. Still, we can probably take care of this later.
> +static void tegra_pcie_power_off(struct tegra_pcie *pcie)
> + if (!IS_ERR_OR_NULL(pcie->pex_clk_supply)) {
Hmm. I think we should make supplies mandatory; it doesn't make sense
for regulator support to be disabled on Tegra, and where a specific
board doesn't actually have a regulator, you're supposed to provide a
dummy fixed regulator so the driver doesn't have to care.
The same comment obviously applies to tegra_pcie_power_on() and wherever
regulator_get() happens.
> +static int tegra_pcie_parse_dt(struct tegra_pcie *pcie)
> + pcie->vdd_supply = devm_regulator_get(pcie->dev, "vdd");
> + if (IS_ERR(pcie->vdd_supply))
> + return PTR_ERR(pcie->vdd_supply);
> +
> + pcie->pex_clk_supply = devm_regulator_get(pcie->dev, "pex-clk");
> + if (IS_ERR(pcie->pex_clk_supply))
> + return PTR_ERR(pcie->pex_clk_supply);
Oh, I guess the regulator_get() calls are already strict.
> +static int tegra_pcie_add_port(struct tegra_pcie *pcie, struct device_node *np)
> + port = devm_kzalloc(pcie->dev, sizeof(*port), GFP_KERNEL);
> + if (!port)
> + return -ENOMEM;
> +
> + INIT_LIST_HEAD(&port->list);
> + port->index = index;
> + port->pcie = pcie;
> +
> + port->base = devm_request_and_ioremap(pcie->dev, ®s);
> + if (!port->base)
> + return -EADDRNOTAVAIL;
> +
> + if (!tegra_pcie_port_check_link(port)) {
> + dev_info(pcie->dev, "link %u down, ignoring\n", port->index);
Perhaps devm_kfree(port)? Not a big leak, but equally if you don't, it's
an unreferenced memory block.
> + return -ENODEV;
> + }
> +
> + list_add_tail(&port->list, &pcie->ports);
> +
> + return 0;
> +}
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists