| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1368422224-19590-1-git-send-email-prabhakar.csengg@gmail.com>
Date: Mon, 13 May 2013 10:47:04 +0530
From: Lad Prabhakar <prabhakar.csengg@...il.com>
To: LMML <linux-media@...r.kernel.org>
Cc: DLOS <davinci-linux-open-source@...ux.davincidsp.com>,
LKML <linux-kernel@...r.kernel.org>,
Mauro Carvalho Chehab <mchehab@...hat.com>,
"Lad, Prabhakar" <prabhakar.csengg@...il.com>,
Hans Verkuil <hans.verkuil@...co.com>,
Laurent Pinchart <laurent.pinchart@...asonboard.com>,
Guennadi Liakhovetski <g.liakhovetski@....de>,
Sylwester Nawrocki <s.nawrocki@...sung.com>,
Sakari Ailus <sakari.ailus@....fi>,
Grant Likely <grant.likely@...retlab.ca>,
Sascha Hauer <s.hauer@...gutronix.de>,
Rob Herring <rob.herring@...xeda.com>,
Rob Landley <rob@...dley.net>, Arnd Bergmann <arnd@...db.de>,
devicetree-discuss@...ts.ozlabs.org, linux-doc@...r.kernel.org
Subject: [PATCH RFC V4 FINAL] media: i2c: mt9p031: add OF support
From: Lad, Prabhakar <prabhakar.csengg@...il.com>
add OF support for the mt9p031 sensor driver.
Alongside this patch sorts the header inclusion alphabetically.
Signed-off-by: Lad, Prabhakar <prabhakar.csengg@...il.com>
Cc: Hans Verkuil <hans.verkuil@...co.com>
Cc: Laurent Pinchart <laurent.pinchart@...asonboard.com>
Cc: Mauro Carvalho Chehab <mchehab@...hat.com>
Cc: Guennadi Liakhovetski <g.liakhovetski@....de>
Cc: Sylwester Nawrocki <s.nawrocki@...sung.com>
Cc: Sakari Ailus <sakari.ailus@....fi>
Cc: Grant Likely <grant.likely@...retlab.ca>
Cc: Sascha Hauer <s.hauer@...gutronix.de>
Cc: Rob Herring <rob.herring@...xeda.com>
Cc: Rob Landley <rob@...dley.net>
Cc: Arnd Bergmann <arnd@...db.de>
Cc: devicetree-discuss@...ts.ozlabs.org
Cc: davinci-linux-open-source@...ux.davincidsp.com
Cc: linux-doc@...r.kernel.org
Cc: linux-kernel@...r.kernel.org
---
Changes for v4:
1: Renamed "gpio-reset" property to "reset-gpios".
2: Dropped assigning the driver data from the of node.
Changes for v3:
1: Dropped check if gpio-reset is valid.
2: Fixed some code nits.
3: Included a reference to the V4L2 DT bindings documentation.
Changes for v2:
1: Used '-' instead of '_' for device properties.
2: Specified gpio reset pin as phandle in device node.
3: Handle platform data properly even if kernel is compiled with
devicetree support.
4: Used dev_* for messages in drivers instead of pr_*.
5: Changed compatible property to "aptina,mt9p031" and "aptina,mt9p031m".
6: Sorted the header inclusion alphabetically and fixed some minor code nits.
.../devicetree/bindings/media/i2c/mt9p031.txt | 40 +++++++++++++++++++
drivers/media/i2c/mt9p031.c | 42 +++++++++++++++++++-
2 files changed, 80 insertions(+), 2 deletions(-)
create mode 100644 Documentation/devicetree/bindings/media/i2c/mt9p031.txt
diff --git a/Documentation/devicetree/bindings/media/i2c/mt9p031.txt b/Documentation/devicetree/bindings/media/i2c/mt9p031.txt
new file mode 100644
index 0000000..59d613c
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/mt9p031.txt
@@ -0,0 +1,40 @@
+* Aptina 1/2.5-Inch 5Mp CMOS Digital Image Sensor
+
+The Aptina MT9P031 is a 1/2.5-inch CMOS active pixel digital image sensor with
+an active array size of 2592H x 1944V. It is programmable through a simple
+two-wire serial interface.
+
+Required Properties :
+- compatible : value should be either one among the following
+ (a) "aptina,mt9p031" for mt9p031 sensor
+ (b) "aptina,mt9p031m" for mt9p031m sensor
+
+- input-clock-frequency : Input clock frequency.
+
+- pixel-clock-frequency : Pixel clock frequency.
+
+Optional Properties :
+- reset-gpios: Chip reset GPIO
+
+For further reading of port node refer Documentation/devicetree/bindings/media/
+video-interfaces.txt.
+
+Example:
+
+ i2c0@...2000 {
+ ...
+ ...
+ mt9p031@5d {
+ compatible = "aptina,mt9p031";
+ reg = <0x5d>;
+ reset-gpios = <&gpio3 30 0>;
+
+ port {
+ mt9p031_1: endpoint {
+ input-clock-frequency = <6000000>;
+ pixel-clock-frequency = <96000000>;
+ };
+ };
+ };
+ ...
+ };
diff --git a/drivers/media/i2c/mt9p031.c b/drivers/media/i2c/mt9p031.c
index 28cf95b..a58207c 100644
--- a/drivers/media/i2c/mt9p031.c
+++ b/drivers/media/i2c/mt9p031.c
@@ -16,9 +16,11 @@
#include <linux/delay.h>
#include <linux/device.h>
#include <linux/gpio.h>
-#include <linux/module.h>
#include <linux/i2c.h>
#include <linux/log2.h>
+#include <linux/module.h>
+#include <linux/of_device.h>
+#include <linux/of_gpio.h>
#include <linux/pm.h>
#include <linux/regulator/consumer.h>
#include <linux/slab.h>
@@ -28,6 +30,7 @@
#include <media/v4l2-chip-ident.h>
#include <media/v4l2-ctrls.h>
#include <media/v4l2-device.h>
+#include <media/v4l2-of.h>
#include <media/v4l2-subdev.h>
#include "aptina-pll.h"
@@ -928,10 +931,35 @@ static const struct v4l2_subdev_internal_ops mt9p031_subdev_internal_ops = {
* Driver initialization and probing
*/
+static struct mt9p031_platform_data *
+mt9p031_get_pdata(struct i2c_client *client)
+{
+ struct device_node *np;
+ struct mt9p031_platform_data *pdata;
+
+ if (!IS_ENABLED(CONFIG_OF) || !client->dev.of_node)
+ return client->dev.platform_data;
+
+ np = v4l2_of_get_next_endpoint(client->dev.of_node, NULL);
+ if (!np)
+ return NULL;
+
+ pdata = devm_kzalloc(&client->dev, sizeof(struct mt9p031_platform_data),
+ GFP_KERNEL);
+ if (!pdata)
+ return NULL;
+
+ pdata->reset = of_get_named_gpio(client->dev.of_node, "reset-gpios", 0);
+ of_property_read_u32(np, "input-clock-frequency", &pdata->ext_freq);
+ of_property_read_u32(np, "pixel-clock-frequency", &pdata->target_freq);
+
+ return pdata;
+}
+
static int mt9p031_probe(struct i2c_client *client,
const struct i2c_device_id *did)
{
- struct mt9p031_platform_data *pdata = client->dev.platform_data;
+ struct mt9p031_platform_data *pdata = mt9p031_get_pdata(client);
struct i2c_adapter *adapter = to_i2c_adapter(client->dev.parent);
struct mt9p031 *mt9p031;
unsigned int i;
@@ -1070,8 +1098,18 @@ static const struct i2c_device_id mt9p031_id[] = {
};
MODULE_DEVICE_TABLE(i2c, mt9p031_id);
+#if IS_ENABLED(CONFIG_OF)
+static const struct of_device_id mt9p031_of_match[] = {
+ { .compatible = "aptina,mt9p031", },
+ { .compatible = "aptina,mt9p031m", },
+ { /* sentinel */ },
+};
+MODULE_DEVICE_TABLE(of, mt9p031_of_match);
+#endif
+
static struct i2c_driver mt9p031_i2c_driver = {
.driver = {
+ .of_match_table = of_match_ptr(mt9p031_of_match),
.name = "mt9p031",
},
.probe = mt9p031_probe,
--
1.7.4.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists