[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <2882257.eZXPo1Jdx9@lenovo>
Date: Tue, 26 Nov 2013 07:49:17 +0000
From: Florian Fainelli <f.fainelli@...il.com>
To: Jonas Jensen <jonas.jensen@...il.com>
Cc: netdev@...r.kernel.org, davem@...emloft.net,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org,
bhutchings@...arflare.com
Subject: Re: [PATCH v2 2/6] net: MOXA ART: connect to PHY
Le lundi 25 novembre 2013, 16:27:04 Jonas Jensen a écrit :
> The kernel now has a MDIO bus driver and a phy_driver (RTL8201CP),
> connect to this PHY using OF.
>
> Signed-off-by: Jonas Jensen <jonas.jensen@...il.com>
Looks good:
Reviewed-by: Florian Fainelli <f.fainelli@...il.com>
> ---
>
> Notes:
> Thanks for reviewing!
>
> Changes since v1:
>
> 1. split ethtool support to separate patch
> 2. changes to devicetree binding document
> 3. add moxart_mac_update_duplex()
> 4. compare previous link state/speed/duplex on link adjust
> 5. use of_get_phy_mode() not PHY_INTERFACE_MODE_MII
> 6. bail on of_parse_phandle() failure
> 7. remove "if (!priv->phy_dev) return -ENODEV;"
> moxart_do_ioctl()
> 8. remove "if (priv->phy_dev)"
> moxart_mac_open(), moxart_mac_stop()
>
> Applies to next-20131125
>
> .../devicetree/bindings/net/moxa,moxart-mac.txt | 47 ++++++++++-
> drivers/net/ethernet/moxa/moxart_ether.c | 92
> +++++++++++++++++++++- drivers/net/ethernet/moxa/moxart_ether.h |
> 2 +
> 3 files changed, 138 insertions(+), 3 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/net/moxa,moxart-mac.txt
> b/Documentation/devicetree/bindings/net/moxa,moxart-mac.txt index
> 583418b..56f0374 100644
> --- a/Documentation/devicetree/bindings/net/moxa,moxart-mac.txt
> +++ b/Documentation/devicetree/bindings/net/moxa,moxart-mac.txt
> @@ -1,21 +1,64 @@
> MOXA ART Ethernet Controller
>
> +Integrated MDIO bus node:
> +
> +- compatible: "moxa,moxart-mdio"
> +- Inherets from MDIO bus node binding[1]
> +
> +[1] Documentation/devicetree/bindings/net/phy.txt
> +
> +
> +Ethernet node:
> +
> Required properties:
>
> - compatible : Must be "moxa,moxart-mac"
> - reg : Should contain register location and length
> - interrupts : Should contain the mac interrupt number
>
> +Optional Properties:
> +
> +- phy-handle : the phandle to a PHY node
> +
> +
> Example:
>
> + mdio0: mdio@...00090 {
> + compatible = "moxa,moxart-mdio";
> + reg = <0x90900090 0x8>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + ethphy0: ethernet-phy@1 {
> + device_type = "ethernet-phy";
> + compatible = "moxa,moxart-rtl8201cp", "ethernet-phy-ieee802.3-c22";
> + reg = <1>;
> + };
> + };
> +
> + mdio1: mdio@...00090 {
> + compatible = "moxa,moxart-mdio";
> + reg = <0x92000090 0x8>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + ethphy1: ethernet-phy@1 {
> + device_type = "ethernet-phy";
> + compatible = "moxa,moxart-rtl8201cp", "ethernet-phy-ieee802.3-c22";
> + reg = <1>;
> + };
> + };
> +
> mac0: mac@...00000 {
> compatible = "moxa,moxart-mac";
> - reg = <0x90900000 0x100>;
> + reg = <0x90900000 0x90>;
> interrupts = <25 0>;
> + phy-handle = <ðphy0>;
> };
>
> mac1: mac@...00000 {
> compatible = "moxa,moxart-mac";
> - reg = <0x92000000 0x100>;
> + reg = <0x92000000 0x90>;
> interrupts = <27 0>;
> + phy-handle = <ðphy1>;
> };
> diff --git a/drivers/net/ethernet/moxa/moxart_ether.c
> b/drivers/net/ethernet/moxa/moxart_ether.c index 3c14afd..1b87034 100644
> --- a/drivers/net/ethernet/moxa/moxart_ether.c
> +++ b/drivers/net/ethernet/moxa/moxart_ether.c
> @@ -26,6 +26,9 @@
> #include <linux/of_irq.h>
> #include <linux/crc32.h>
> #include <linux/crc32c.h>
> +#include <linux/phy.h>
> +#include <linux/of_mdio.h>
> +#include <linux/of_net.h>
>
> #include "moxart_ether.h"
>
> @@ -61,6 +64,16 @@ static int moxart_set_mac_address(struct net_device
> *ndev, void *addr) return 0;
> }
>
> +static int moxart_do_ioctl(struct net_device *ndev, struct ifreq *ir, int
> cmd) +{
> + struct moxart_mac_priv_t *priv = netdev_priv(ndev);
> +
> + if (!netif_running(ndev))
> + return -EINVAL;
> +
> + return phy_mii_ioctl(priv->phy_dev, ir, cmd);
> +}
> +
> static void moxart_mac_free_memory(struct net_device *ndev)
> {
> struct moxart_mac_priv_t *priv = netdev_priv(ndev);
> @@ -110,6 +123,19 @@ static void moxart_mac_enable(struct net_device *ndev)
> writel(priv->reg_maccr, priv->base + REG_MAC_CTRL);
> }
>
> +static void moxart_mac_update_duplex(struct net_device *ndev)
> +{
> + struct moxart_mac_priv_t *priv = netdev_priv(ndev);
> +
> + priv->reg_maccr &= ~(FULLDUP | ENRX_IN_HALFTX);
> + if (priv->duplex)
> + priv->reg_maccr |= FULLDUP;
> + else
> + priv->reg_maccr |= ENRX_IN_HALFTX;
> +
> + writel(priv->reg_maccr, priv->base + REG_MAC_CTRL);
> +}
> +
> static void moxart_mac_setup_desc_ring(struct net_device *ndev)
> {
> struct moxart_mac_priv_t *priv = netdev_priv(ndev);
> @@ -169,6 +195,9 @@ static int moxart_mac_open(struct net_device *ndev)
> moxart_update_mac_address(ndev);
> moxart_mac_setup_desc_ring(ndev);
> moxart_mac_enable(ndev);
> +
> + phy_start(priv->phy_dev);
> +
> netif_start_queue(ndev);
>
> netdev_dbg(ndev, "%s: IMR=0x%x, MACCR=0x%x\n",
> @@ -184,6 +213,8 @@ static int moxart_mac_stop(struct net_device *ndev)
>
> napi_disable(&priv->napi);
>
> + phy_stop(priv->phy_dev);
> +
> netif_stop_queue(ndev);
>
> /* disable all interrupts */
> @@ -429,12 +460,49 @@ static struct net_device_ops moxart_netdev_ops = {
> .ndo_set_mac_address = moxart_set_mac_address,
> .ndo_validate_addr = eth_validate_addr,
> .ndo_change_mtu = eth_change_mtu,
> + .ndo_do_ioctl = moxart_do_ioctl,
> };
>
> +static void moxart_adjust_link(struct net_device *ndev)
> +{
> + struct moxart_mac_priv_t *priv = netdev_priv(ndev);
> + unsigned long flags;
> + int status_change = 0;
> +
> + if (priv->phy_dev->link) {
> + if (priv->speed != priv->phy_dev->speed) {
> + priv->speed = priv->phy_dev->speed;
> + status_change = 1;
> + }
> +
> + if (priv->duplex != priv->phy_dev->duplex) {
> + spin_lock_irqsave(&priv->txlock, flags);
> +
> + priv->duplex = priv->phy_dev->duplex;
> + moxart_mac_update_duplex(ndev);
> +
> + spin_unlock_irqrestore(&priv->txlock, flags);
> + status_change = 1;
> + }
> + }
> +
> + if (priv->link != priv->phy_dev->link) {
> + if (!priv->phy_dev->link) {
> + priv->speed = 0;
> + priv->duplex = -1;
> + }
> + priv->link = priv->phy_dev->link;
> + status_change = 1;
> + }
> +
> + if (status_change)
> + phy_print_status(priv->phy_dev);
> +}
> +
> static int moxart_mac_probe(struct platform_device *pdev)
> {
> struct device *p_dev = &pdev->dev;
> - struct device_node *node = p_dev->of_node;
> + struct device_node *node = p_dev->of_node, *phy_node;
> struct net_device *ndev;
> struct moxart_mac_priv_t *priv;
> struct resource *res;
> @@ -455,6 +523,28 @@ static int moxart_mac_probe(struct platform_device
> *pdev) priv = netdev_priv(ndev);
> priv->ndev = ndev;
>
> + priv->link = 0;
> + priv->speed = 0;
> + priv->duplex = -1;
> +
> + phy_node = of_parse_phandle(node, "phy-handle", 0);
> + if (!phy_node) {
> + dev_err(p_dev, "of_parse_phandle failed\n");
> + ret = -ENODEV;
> + goto init_fail;
> + }
> +
> + if (phy_node) {
> + priv->phy_dev = of_phy_connect(priv->ndev, phy_node,
> + &moxart_adjust_link,
> + 0, of_get_phy_mode(node));
> + if (!priv->phy_dev) {
> + dev_err(p_dev, "of_phy_connect failed\n");
> + ret = -ENODEV;
> + goto init_fail;
> + }
> + }
> +
> res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> ndev->base_addr = res->start;
> priv->base = devm_ioremap_resource(p_dev, res);
> diff --git a/drivers/net/ethernet/moxa/moxart_ether.h
> b/drivers/net/ethernet/moxa/moxart_ether.h index 2be9280..b8877bf 100644
> --- a/drivers/net/ethernet/moxa/moxart_ether.h
> +++ b/drivers/net/ethernet/moxa/moxart_ether.h
> @@ -297,6 +297,8 @@ struct moxart_mac_priv_t {
> unsigned int reg_imr;
> struct napi_struct napi;
> struct net_device *ndev;
> + struct phy_device *phy_dev;
> + int speed, duplex, link;
>
> dma_addr_t rx_base;
> dma_addr_t rx_mapping[RX_DESC_NUM];
--
Florian
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists