| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <CAAhSdy11HQtiOD6XLqQcZ+zf_Z9Mx0nPrJ0ECNNuRkZt=CfdpA@mail.gmail.com>
Date: Wed, 25 Jun 2014 19:26:47 +0530
From: Anup Patel <anup@...infault.org>
To: Marc Zyngier <marc.zyngier@....com>
Cc: "kvmarm@...ts.cs.columbia.edu" <kvmarm@...ts.cs.columbia.edu>,
linux-arm-kernel <linux-arm-kernel@...ts.infradead.org>,
"linux-kernel@...r.kernel.org List" <linux-kernel@...r.kernel.org>,
Catalin Marinas <catalin.marinas@....com>,
Thomas Gleixner <tglx@...utronix.de>,
Will Deacon <will.deacon@....com>,
Christoffer Dall <christoffer.dall@...aro.org>,
Eric Auger <eric.auger@...aro.org>,
Ian Campbell <ian.campbell@...rix.com>,
Stefano Stabellini <stefano.stabellini@...citrix.com>
Subject: Re: [RFC PATCH 3/9] irqchip: GIC: Convert to EOImode == 1
Hi Marc,
On Wed, Jun 25, 2014 at 2:58 PM, Marc Zyngier <marc.zyngier@....com> wrote:
> So far, GICv2 has been used in with EOImode == 0. The effect of this
> mode is to perform the priority drop and the deactivation of the
> interrupt at the same time.
>
> While this works perfectly for Linux (we only have a single priority),
> it causes issues when an interrupt is forwarded to a guest, and when
> we want the guest to perform the EOI itself.
>
> For this case, the GIC architecture provides EOImode == 1, where:
> - A write to the EOI register drops the priority of the interrupt and leaves
> it active. Other interrupts at the same priority level can now be taken,
> but the active interrupt cannot be taken again
> - A write to the DIR marks the interrupt as inactive, meaning it can
> now be taken again.
>
> We only enable this feature when booted in HYP mode. Also, as most device
> trees are broken (they report the CPU interface size to be 4kB, while
> the GICv2 CPU interface size is 8kB), output a warning if we're booted
> in HYP mode, and disable the feature.
>
> Signed-off-by: Marc Zyngier <marc.zyngier@....com>
> ---
> drivers/irqchip/irq-gic.c | 61 +++++++++++++++++++++++++++++++++++++----
> include/linux/irqchip/arm-gic.h | 4 +++
> 2 files changed, 59 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/irqchip/irq-gic.c b/drivers/irqchip/irq-gic.c
> index 508b815..9295bf2 100644
> --- a/drivers/irqchip/irq-gic.c
> +++ b/drivers/irqchip/irq-gic.c
> @@ -45,6 +45,7 @@
> #include <asm/irq.h>
> #include <asm/exception.h>
> #include <asm/smp_plat.h>
> +#include <asm/virt.h>
>
> #include "irq-gic-common.h"
> #include "irqchip.h"
> @@ -94,6 +95,10 @@ struct irq_chip gic_arch_extn = {
> .irq_set_wake = NULL,
> };
>
> +static struct irq_chip *gic_chip;
> +
> +static bool supports_deactivate = false;
> +
> #ifndef MAX_GIC_NR
> #define MAX_GIC_NR 1
> #endif
> @@ -185,6 +190,12 @@ static void gic_eoi_irq(struct irq_data *d)
> writel_relaxed(gic_irq(d), gic_cpu_base(d) + GIC_CPU_EOI);
> }
>
> +static void gic_eoi_dir_irq(struct irq_data *d)
> +{
> + gic_eoi_irq(d);
> + writel_relaxed(gic_irq(d), gic_cpu_base(d) + GIC_CPU_DEACTIVATE);
> +}
> +
> static int gic_set_type(struct irq_data *d, unsigned int type)
> {
> void __iomem *base = gic_dist_base(d);
> @@ -277,6 +288,7 @@ static void __exception_irq_entry gic_handle_irq(struct pt_regs *regs)
> }
> if (irqnr < 16) {
> writel_relaxed(irqstat, cpu_base + GIC_CPU_EOI);
> + writel_relaxed(irqstat, cpu_base + GIC_CPU_DEACTIVATE);
> #ifdef CONFIG_SMP
> handle_IPI(irqnr, regs);
> #endif
> @@ -313,7 +325,7 @@ static void gic_handle_cascade_irq(unsigned int irq, struct irq_desc *desc)
> chained_irq_exit(chip, desc);
> }
>
> -static struct irq_chip gic_chip = {
> +static struct irq_chip gicv1_chip = {
> .name = "GIC",
> .irq_mask = gic_mask_irq,
> .irq_unmask = gic_unmask_irq,
> @@ -326,6 +338,19 @@ static struct irq_chip gic_chip = {
> .irq_set_wake = gic_set_wake,
> };
>
> +static struct irq_chip gicv2_chip = {
> + .name = "GIC",
> + .irq_mask = gic_mask_irq,
> + .irq_unmask = gic_unmask_irq,
> + .irq_eoi = gic_eoi_dir_irq,
> + .irq_set_type = gic_set_type,
> + .irq_retrigger = gic_retrigger,
> +#ifdef CONFIG_SMP
> + .irq_set_affinity = gic_set_affinity,
> +#endif
> + .irq_set_wake = gic_set_wake,
> +};
> +
> void __init gic_cascade_irq(unsigned int gic_nr, unsigned int irq)
> {
> if (gic_nr >= MAX_GIC_NR)
> @@ -377,6 +402,16 @@ static void __init gic_dist_init(struct gic_chip_data *gic)
> writel_relaxed(1, base + GIC_DIST_CTRL);
> }
>
> +static void gic_cpu_if_up(void)
> +{
> + void __iomem *cpu_base = gic_data_cpu_base(&gic_data[0]);
> + u32 val = 0;
> +
> + if (supports_deactivate)
> + val = GIC_CPU_CTRL_EOImodeNS;
> + writel_relaxed(val | 1, cpu_base + GIC_CPU_CTRL);
> +}
> +
> static void gic_cpu_init(struct gic_chip_data *gic)
> {
> void __iomem *dist_base = gic_data_dist_base(gic);
> @@ -402,7 +437,7 @@ static void gic_cpu_init(struct gic_chip_data *gic)
> gic_cpu_config(dist_base, NULL);
>
> writel_relaxed(0xf0, base + GIC_CPU_PRIMASK);
> - writel_relaxed(1, base + GIC_CPU_CTRL);
> + gic_cpu_if_up();
> }
>
> void gic_cpu_if_down(void)
> @@ -543,7 +578,7 @@ static void gic_cpu_restore(unsigned int gic_nr)
> writel_relaxed(0xa0a0a0a0, dist_base + GIC_DIST_PRI + i * 4);
>
> writel_relaxed(0xf0, cpu_base + GIC_CPU_PRIMASK);
> - writel_relaxed(1, cpu_base + GIC_CPU_CTRL);
> + gic_cpu_if_up();
> }
>
> static int gic_notifier(struct notifier_block *self, unsigned long cmd, void *v)
> @@ -770,11 +805,11 @@ static int gic_irq_domain_map(struct irq_domain *d, unsigned int irq,
> {
> if (hw < 32) {
> irq_set_percpu_devid(irq);
> - irq_set_chip_and_handler(irq, &gic_chip,
> + irq_set_chip_and_handler(irq, gic_chip,
> handle_percpu_devid_irq);
> set_irq_flags(irq, IRQF_VALID | IRQF_NOAUTOEN);
> } else {
> - irq_set_chip_and_handler(irq, &gic_chip,
> + irq_set_chip_and_handler(irq, gic_chip,
> handle_fasteoi_irq);
> set_irq_flags(irq, IRQF_VALID | IRQF_PROBE);
>
> @@ -951,6 +986,11 @@ void __init gic_init_bases(unsigned int gic_nr, int irq_start,
>
> gic_irqs -= hwirq_base; /* calculate # of irqs to allocate */
>
> + if (!supports_deactivate)
> + gic_chip = &gicv1_chip;
> + else
> + gic_chip = &gicv2_chip;
> +
> if (of_property_read_u32(node, "arm,routable-irqs",
> &nr_routable_irqs)) {
> irq_base = irq_alloc_descs(irq_start, 16, gic_irqs,
> @@ -980,7 +1020,7 @@ void __init gic_init_bases(unsigned int gic_nr, int irq_start,
> set_handle_irq(gic_handle_irq);
> }
>
> - gic_chip.flags |= gic_arch_extn.flags;
> + gic_chip->flags |= gic_arch_extn.flags;
> gic_dist_init(gic);
> gic_cpu_init(gic);
> gic_pm_init(gic);
> @@ -994,6 +1034,7 @@ gic_of_init(struct device_node *node, struct device_node *parent)
> {
> void __iomem *cpu_base;
> void __iomem *dist_base;
> + struct resource cu_res;
> u32 percpu_offset;
> int irq;
>
> @@ -1006,6 +1047,14 @@ gic_of_init(struct device_node *node, struct device_node *parent)
> cpu_base = of_iomap(node, 1);
> WARN(!cpu_base, "unable to map gic cpu registers\n");
>
> + of_address_to_resource(node, 1, &cpu_res);
> + if (is_hyp_mode_available()) {
Interrupt deactivation feature is not dependent on whether
hyp-mode is available or not.
We can use GICC_DIR even if CPU does not have
virtualization extension. Also, we can use GICV_DIR
when running as Guest or VM.
I think "supports_deactivate" should depend on
the GIC compatible string.
> + if (resource_size(&cpu_res) >= SZ_8K)
> + supports_deactivate = true;
> + else
> + pr_warn("GIC: CPU interface size is %x, DT is probably wrong\n", (int)resource_size(&cpu_res));
This will not work on APM X-Gene because, for
X-Gene first CPU page is at 0x78020000 and
second CPU page is at 0x78030000.
Ian had send-out a patch long time back to extend
GIC dt-bindings for addressing this issue.
(http://www.spinics.net/lists/arm-kernel/msg283767.html)
Regards,
Anup
> + }
> +
> if (of_property_read_u32(node, "cpu-offset", &percpu_offset))
> percpu_offset = 0;
>
> diff --git a/include/linux/irqchip/arm-gic.h b/include/linux/irqchip/arm-gic.h
> index 45e2d8c..ffe3911 100644
> --- a/include/linux/irqchip/arm-gic.h
> +++ b/include/linux/irqchip/arm-gic.h
> @@ -21,6 +21,10 @@
> #define GIC_CPU_ACTIVEPRIO 0xd0
> #define GIC_CPU_IDENT 0xfc
>
> +#define GIC_CPU_DEACTIVATE 0x1000
> +
> +#define GIC_CPU_CTRL_EOImodeNS (1 << 9)
> +
> #define GICC_IAR_INT_ID_MASK 0x3ff
>
> #define GIC_DIST_CTRL 0x000
> --
> 1.8.3.4
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@...ts.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists