| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1419234532-22657-7-git-send-email-sukadev@linux.vnet.ibm.com> Date: Sun, 21 Dec 2014 23:48:51 -0800 From: Sukadev Bhattiprolu <sukadev@...ux.vnet.ibm.com> To: Arnaldo Carvalho de Melo <acme@...nel.org>, Jiri Olsa <jolsa@...hat.com>, Michael Ellerman <mpe@...erman.id.au>, Paul Mackerras <paulus@...ba.org> Cc: dev@...yps.com, peterz@...radead.org, hbabu@...ibm.com, <linux-kernel@...r.kernel.org>, linuxppc-dev@...ts.ozlabs.org Subject: [PATCH v6 6/7] powerpc/perf/hv-gpci: add the remaining gpci requests From: Cody P Schafer <cody@...ux.vnet.ibm.com> Add the remaining gpci requests that contain counters suitable for use by perf. Omit those that don't contain any counters (but note their ommision). Changelog[v6] [Jiri Olsa, Sukadev Bhattiprolu] Replace 'starting_index' with what it really means for the event. Eg if starting_index refers to a partition_id for an event, allow user to specify a value for partition_id rather than 'starting_index'. Also use a =? to indicate required parameters: eg partition_id=? CC: Haren Myneni <hbabu@...ibm.com> CC: Cody P Schafer <dev@...yps.com> Signed-off-by: Sukadev Bhattiprolu <sukadev@...ux.vnet.ibm.com> Signed-off-by: Cody P Schafer <cody@...ux.vnet.ibm.com> --- arch/powerpc/perf/hv-gpci-requests.h | 187 ++++++++++++++++++++++++++++++++++- 1 file changed, 186 insertions(+), 1 deletion(-) diff --git a/arch/powerpc/perf/hv-gpci-requests.h b/arch/powerpc/perf/hv-gpci-requests.h index f42d131..1345835 100644 --- a/arch/powerpc/perf/hv-gpci-requests.h +++ b/arch/powerpc/perf/hv-gpci-requests.h @@ -20,7 +20,9 @@ * * - starting_index_kind is one of the following, depending on the event: * - * chip_id: hardware chip id or -1 for current hw chip + * hw_chip_id: hardware chip id or -1 for current hw chip + * partition_id + * sibling_part_id, * phys_processor_idx: * 0xffffffffffffffff: or -1, which means it is irrelavant for the event * @@ -63,6 +65,33 @@ REQUEST(__count(0, 8, processor_time_in_timebase_cycles) ) #include I(REQUEST_END) +#define REQUEST_NAME entitled_capped_uncapped_donated_idle_timebase_by_partition +#define REQUEST_NUM 0x20 +#define REQUEST_IDX_KIND "sibling_part_id=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 8, partition_id) + __count(0x8, 8, entitled_cycles) + __count(0x10, 8, consumed_capped_cycles) + __count(0x18, 8, consumed_uncapped_cycles) + __count(0x20, 8, cycles_donated) + __count(0x28, 8, purr_idle_cycles) +) +#include I(REQUEST_END) + +/* + * Not available for counter_info_version >= 0x8, use + * run_instruction_cycles_by_partition(0x100) instead. + */ +#define REQUEST_NAME run_instructions_run_cycles_by_partition +#define REQUEST_NUM 0x30 +#define REQUEST_IDX_KIND "sibling_part_id=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 8, partition_id) + __count(0x8, 8, instructions_completed) + __count(0x10, 8, cycles) +) +#include I(REQUEST_END) + #define REQUEST_NAME system_performance_capabilities #define REQUEST_NUM 0x40 #define REQUEST_IDX_KIND "starting_index=0xffffffffffffffff" @@ -73,4 +102,160 @@ REQUEST(__field(0, 1, perf_collect_privileged) ) #include I(REQUEST_END) +#define REQUEST_NAME processor_bus_utilization_abc_links +#define REQUEST_NUM 0x50 +#define REQUEST_IDX_KIND "hw_chip_id=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 4, hw_chip_id) + __array(0x4, 0xC, reserved1) + __count(0x10, 8, total_link_cycles) + __count(0x18, 8, idle_cycles_for_a_link) + __count(0x20, 8, idle_cycles_for_b_link) + __count(0x28, 8, idle_cycles_for_c_link) + __array(0x30, 0x20, reserved2) +) +#include I(REQUEST_END) + +#define REQUEST_NAME processor_bus_utilization_wxyz_links +#define REQUEST_NUM 0x60 +#define REQUEST_IDX_KIND "hw_chip_id=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 4, hw_chip_id) + __array(0x4, 0xC, reserved1) + __count(0x10, 8, total_link_cycles) + __count(0x18, 8, idle_cycles_for_w_link) + __count(0x20, 8, idle_cycles_for_x_link) + __count(0x28, 8, idle_cycles_for_y_link) + __count(0x30, 8, idle_cycles_for_z_link) + __array(0x38, 0x28, reserved2) +) +#include I(REQUEST_END) + +#define REQUEST_NAME processor_bus_utilization_gx_links +#define REQUEST_NUM 0x70 +#define REQUEST_IDX_KIND "hw_chip_id=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 4, hw_chip_id) + __array(0x4, 0xC, reserved1) + __count(0x10, 8, gx0_in_address_cycles) + __count(0x18, 8, gx0_in_data_cycles) + __count(0x20, 8, gx0_in_retries) + __count(0x28, 8, gx0_in_bus_cycles) + __count(0x30, 8, gx0_in_cycles_total) + __count(0x38, 8, gx0_out_address_cycles) + __count(0x40, 8, gx0_out_data_cycles) + __count(0x48, 8, gx0_out_retries) + __count(0x50, 8, gx0_out_bus_cycles) + __count(0x58, 8, gx0_out_cycles_total) + __count(0x60, 8, gx1_in_address_cycles) + __count(0x68, 8, gx1_in_data_cycles) + __count(0x70, 8, gx1_in_retries) + __count(0x78, 8, gx1_in_bus_cycles) + __count(0x80, 8, gx1_in_cycles_total) + __count(0x88, 8, gx1_out_address_cycles) + __count(0x90, 8, gx1_out_data_cycles) + __count(0x98, 8, gx1_out_retries) + __count(0xA0, 8, gx1_out_bus_cycles) + __count(0xA8, 8, gx1_out_cycles_total) +) +#include I(REQUEST_END) + +#define REQUEST_NAME processor_bus_utilization_mc_links +#define REQUEST_NUM 0x80 +#define REQUEST_IDX_KIND "hw_chip_id=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 4, hw_chip_id) + __array(0x4, 0xC, reserved1) + __count(0x10, 8, mc0_frames) + __count(0x18, 8, mc0_reads) + __count(0x20, 8, mc0_write) + __count(0x28, 8, mc0_total_cycles) + __count(0x30, 8, mc1_frames) + __count(0x38, 8, mc1_reads) + __count(0x40, 8, mc1_writes) + __count(0x48, 8, mc1_total_cycles) +) +#include I(REQUEST_END) + +/* Processor_config (0x90) skipped, no counters */ +/* Current_processor_frequency (0x91) skipped, no counters */ + +#define REQUEST_NAME processor_core_utilization +#define REQUEST_NUM 0x94 +#define REQUEST_IDX_KIND "phys_processor_idx=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 4, phys_processor_idx) + __field(0x4, 4, hw_processor_id) + __count(0x8, 8, cycles_across_any_thread) + __count(0x10, 8, timebase_at_collection) + __count(0x18, 8, purr_cycles) + __count(0x20, 8, sum_of_cycles_across_all_threads) + __count(0x28, 8, instructions_completed) +) +#include I(REQUEST_END) + +/* Processor_core_power_mode (0x95) skipped, no counters */ +/* Affinity_domain_information_by_virtual_processor (0xA0) skipped, + * no counters */ +/* Affinity_domain_information_by_domain (0xB0) skipped, no counters */ +/* Affinity_domain_information_by_partition (0xB1) skipped, no counters */ +/* Physical_memory_info (0xC0) skipped, no counters */ +/* Processor_bus_topology (0xD0) skipped, no counters */ + +#define REQUEST_NAME partition_hypervisor_queuing_times +#define REQUEST_NUM 0xE0 +#define REQUEST_IDX_KIND "partition_id=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 2, partition_id) + __array(0x2, 6, reserved1) + __count(0x8, 8, time_waiting_for_entitlement) + __count(0x10, 8, times_waited_for_entitlement) + __count(0x18, 8, time_waiting_for_phys_processor) + __count(0x20, 8, times_waited_for_phys_processor) + __count(0x28, 8, dispatches_on_home_core) + __count(0x30, 8, dispatches_on_home_primary_affinity_domain) + __count(0x38, 8, dispatches_on_home_secondary_affinity_domain) + __count(0x40, 8, dispatches_off_home_secondary_affinity_domain) + __count(0x48, 8, dispatches_on_dedicated_processor_donating_cycles) +) +#include I(REQUEST_END) + +#define REQUEST_NAME system_hypervisor_times +#define REQUEST_NUM 0xF0 +#define REQUEST_IDX_KIND "starting_index=0xffffffffffffffff" +#include I(REQUEST_BEGIN) +REQUEST(__count(0, 8, time_spent_to_dispatch_virtual_processors) + __count(0x8, 8, time_spent_processing_virtual_processor_timers) + __count(0x10, 8, time_spent_managing_partitions_over_entitlement) + __count(0x18, 8, time_spent_on_system_management) +) +#include I(REQUEST_END) + +#define REQUEST_NAME system_tlbie_count_and_time +#define REQUEST_NUM 0xF4 +#define REQUEST_IDX_KIND "starting_index=0xffffffffffffffff" +#include I(REQUEST_BEGIN) +REQUEST(__count(0, 8, tlbie_instructions_issued) + /* + * FIXME: The spec says the offset here is 0x10, which I suspect + * is wrong. + */ + __count(0x8, 8, time_spent_issuing_tlbies) +) +#include I(REQUEST_END) + +#define REQUEST_NAME partition_instruction_count_and_time +#define REQUEST_NUM 0x100 +#define REQUEST_IDX_KIND "partition_id=?" +#include I(REQUEST_BEGIN) +REQUEST(__field(0, 2, partition_id) + __array(0x2, 0x6, reserved1) + __count(0x8, 8, instructions_performed) + __count(0x10, 8, time_collected) +) +#include I(REQUEST_END) + +/* set_mmcrh (0x80001000) skipped, no counters */ +/* retrieve_hpmcx (0x80002000) skipped, no counters */ + #include "req-gen/_end.h" -- 1.8.3.1 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@...r.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists