Date:	Tue, 28 Jul 2015 11:58:55 -0600
From:	Alex Williamson <alex.williamson@...hat.com>
To:	Bhushan Bharat <Bharat.Bhushan@...escale.com>
Cc:	Pranavkumar Sawargaonkar <pranavkumar@...aro.org>,
	"kvm@...r.kernel.org" <kvm@...r.kernel.org>,
	"kvmarm@...ts.cs.columbia.edu" <kvmarm@...ts.cs.columbia.edu>,
	"linux-arm-kernel@...ts.infradead.org" 
	<linux-arm-kernel@...ts.infradead.org>,
	"linux-kernel@...r.kernel.org" <linux-kernel@...r.kernel.org>,
	"christoffer.dall@...aro.org" <christoffer.dall@...aro.org>,
	"marc.zyngier@....com" <marc.zyngier@....com>,
	"will.deacon@....com" <will.deacon@....com>,
	"bhelgaas@...gle.com" <bhelgaas@...gle.com>,
	"arnd@...db.de" <arnd@...db.de>,
	"rob.herring@...aro.org" <rob.herring@...aro.org>,
	"eric.auger@...aro.org" <eric.auger@...aro.org>,
	"patches@....com" <patches@....com>,
	Stuart Yoder <stuart.yoder@...escale.com>
Subject: Re: [RFC 0/2] VFIO: Add virtual MSI doorbell support.

On Tue, 2015-07-28 at 17:23 +0000, Bhushan Bharat wrote:
> Hi Alex,
> 
> > -----Original Message-----
> > From: Alex Williamson [mailto:alex.williamson@...hat.com]
> > Sent: Tuesday, July 28, 2015 9:52 PM
> > To: Pranavkumar Sawargaonkar
> > Cc: kvm@...r.kernel.org; kvmarm@...ts.cs.columbia.edu; linux-arm-
> > kernel@...ts.infradead.org; linux-kernel@...r.kernel.org;
> > christoffer.dall@...aro.org; marc.zyngier@....com; will.deacon@....com;
> > bhelgaas@...gle.com; arnd@...db.de; rob.herring@...aro.org;
> > eric.auger@...aro.org; patches@....com; Bhushan Bharat-R65777; Yoder
> > Stuart-B08248
> > Subject: Re: [RFC 0/2] VFIO: Add virtual MSI doorbell support.
> > 
> > On Fri, 2015-07-24 at 14:33 +0530, Pranavkumar Sawargaonkar wrote:
> > > In current VFIO MSI/MSI-X implementation, linux host kernel allocates
> > > MSI/MSI-X vectors when userspace requests through vfio ioctls.
> > > Vfio creates irqfd mappings to notify MSI/MSI-X interrupts to the
> > > userspace when raised.
> > > Guest OS will see emulated MSI/MSI-X controller and receives an
> > > interrupt when kernel notifies the same via irqfd.
> > >
> > > Host kernel allocates MSI/MSI-X using standard linux routines like
> > > pci_enable_msix_range() and pci_enable_msi_range().
> > > These routines along with requset_irq() in host kernel sets up
> > > MSI/MSI-X vectors with Physical MSI/MSI-X addresses provided by
> > > interrupt controller driver in host kernel.
> > >
> > > This means when a device is assigned with the guest OS, MSI/MSI-X
> > > addresses present in PCIe EP are the PAs programmed by the host linux
> > kernel.
> > >
> > > In x86 MSI/MSI-X physical address range is reserved and iommu is aware
> > > about these addreses and transalation is bypassed for these address range.
> > >
> > > Unlike x86, ARM/ARM64 does not reserve MSI/MSI-X Physical address
> > > range and all the transactions including MSI go through iommu/smmu
> > without bypass.
> > > This requires extending current vfio MSI layer with additional
> > > functionality for ARM/ARM64 by 1. Programing IOVA (referred as a MSI
> > > virtual doorbell address)
> > >    in device's MSI vector as a MSI address.
> > >    This IOVA will be provided by the userspace based on the
> > >    MSI/MSI-X addresses reserved for the guest.
> > > 2. Create an IOMMU mapping between this IOVA and
> > >    Physical address (PA) assigned to the MSI vector.
> > >
> > > This RFC is proposing a solution for MSI/MSI-X passthrough for
> > ARM/ARM64.
> > 
> > 
> > Hi Pranavkumar,
> > 
> > Freescale has the same, or very similar, need, so any solution in this space
> > will need to work for both ARM and powerpc.  I'm not a big fan of this
> > approach as it seems to require the user to configure MSI/X via ioctl and then
> > call a separate ioctl mapping the doorbells.  That's more code for the user,
> > more code to get wrong and potentially a gap between configuring MSI/X
> > and enabling mappings where we could see IOMMU faults.
> > 
> > If we know that doorbell mappings are required, why can't we set aside a
> > bank of IOVA space and have them mapped automatically as MSI/X is being
> > configured?  Then the user's need for special knowledge and handling of this
> > case is limited to setup.  The IOVA space will be mapped and used as needed,
> > we only need the user to specify the IOVA space reserved for this.  Thanks,
> 
> We probably need a mix of both to support Freescale PowerPC and ARM
> based machines.
> In this mix mode kernel vfio driver will reserve some IOVA for mapping
> MSI page/s.

If vfio is reserving pages independently from the user, this becomes
what Marc called "shaping" the VM and what x86 effectively does.  An
interface extension should expose these implicit regions so the user can
avoid them for DMA memory mapping.

>  If any other iova mapping will overlap with this then it will return
> error and user-space. Ideally this should be choosen in such a way
> that it never overlap, which is easy on some systems but can be tricky
> on some other system like Freescale PowerPC. This is not sufficient
> for at-least Freescale PowerPC based SOC. This is because of hardware
> limitation, where we need to fit this reserved iova address within
> aperture decided by user-space. So if we allow user-space to change
> this reserved iova address to a value decided by user-spece itself
> then we can support both ARM/PowerPC based solutions.

Yes, that's my intention, to allow userspace to specify the reserved
region.  I believe you have some additional restrictions on the number
of MSI banks available and whether MSI banks can be shared, but I would
hope that doesn't preclude a shared interface with ARM.

> I have some implementation ready/tested with this approach and if this
> approach looks good then I can submit a RFC patch.

Yes, please post.  Thanks,

Alex

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Powered by blists - more mailing lists