[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <55F3A798.5090904@tul.cz>
Date: Sat, 12 Sep 2015 06:18:32 +0200
From: Petr Cvek <petr.cvek@....cz>
To: Robert Jarzmik <robert.jarzmik@...e.fr>
Cc: zonque@...il.com, ulf.hansson@...aro.org,
Samuel Ortiz <samuel@...tiz.org>,
Dmitry Eremin-Solenikov <dbaryshkov@...il.com>,
netdev@...r.kernel.org, linux-kernel@...r.kernel.org,
Arnd Bergmann <arnd@...db.de>
Subject: Re: [PATCH 2/3] net: irda: pxaficp_ir: convert to readl and writel
Dne 11.9.2015 v 08:18 Robert Jarzmik napsal(a):
> Petr Cvek <petr.cvek@....cz> writes:
>
>>> Should have been posted to linux arm kernel mailing list, unless my mailer
>>> failed ...
>>>
>> Searching for:
>>
>> "ARM: pxa: add resources to pxaficp_ir"
>>
>> did not found anything, same was for "ficp" in the linux-arm-kernel/netdev/linux-kernel
>> mailing list archive.
> Ah ok, I'll resend it then.
>
>>>> BTW This patch required update of my kernel repo. It seems that my:
>>>>
>>>> magician.c patches + ficp patch + new dma engine
>>>>
>>>> does not work for me at all. Kernel throws some panic about interrupts and then
>>>> it ends in an infinite stack dumping loop. Fault occurs before rootfs is
>>>> mounted, so probably around MMC init (with removed SD card it fails normally
>>>> with no rootfs found error).
>>> Could you send me (privately) the stack you're getting please. This is something
>>> I'd like to catch up early in the -rc releases.
>>
>> Well this will be problem as I cannot save anything to an SD card after and
>> during the failure. Only viable interfaces would be earlycon on an infraport
>> or high speed camera on LCD :-).
> Ah just as on my mioa701. I ended up soldering a JTAG cable :)
Rather not :-D.
>
>>> And it is true I have not tested the rootfs special case, where drivers are not
>>> yet initialized (and more specifically gpio and interrupt chip). Your backtrace
>>> should tell me if you fall into this category of issues ... but I digress, this
>>> has no link with pxaficp.
>>
>> Should I start new thread? (same bug can be present in the FICP too)
> Yes, this pxamci bothers me, it deserves a thread.
Will start soon.
>>
>> Anyway after mmc dma revert I was still not able to start FICP. There is an error:
>>
>> Unable to handle kernel paging request at virtual address 32e00004
>>
>> from pxa_irda_startup() and it seems it is caused by register definitions. For example:
>>
>> writel_relaxed((val), (irda)->stuart_base + (off));
>>
>> is called by
>>
>> stuart_writel(si, 0, STIER);
>>
>> but STIER is not just an offset, but full register address:
>>
>> __REG(0x40700004)
>>
>> So the definition should be changed, unless there is another patch I did not
>> received (in that case, send me full patchset again please) :-).
> Agreed, this is a bug in this patch. With this fix, is the pxaficp working or do
> you need a bit more time to experiment ?
I have tried with a nasty hack (use only lower part of address, it should equal with reg offset):
#undef __REG
-#define __REG(x) (x)
+#define __REG(x) (x & 0xffff)
and it seems to work. The module inits and I am able to see IrDA traffic and ping other machine. FIR mode (mostly impacted by DMA) is still untested as magician unfortunately supports only SIR mode.
Petr
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists