| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <571A210E.2020607@ti.com>
Date: Fri, 22 Apr 2016 16:03:10 +0300
From: Grygorii Strashko <grygorii.strashko@...com>
To: "David Rivshin (Allworx)" <drivshin.allworx@...il.com>,
<netdev@...r.kernel.org>, <linux-omap@...r.kernel.org>
CC: <linux-arm-kernel@...ts.infradead.org>,
<devicetree@...r.kernel.org>, <linux-kernel@...r.kernel.org>,
David Miller <davem@...emloft.net>,
Mugunthan V N <mugunthanvnm@...com>,
Andrew Goodbody <andrew.goodbody@...brionix.com>,
Markus Brunner <systemprogrammierung.brunner@...il.com>,
Nicolas Chauvet <kwizart@...il.com>
Subject: Re: [PATCH net v2 1/3] drivers: net: cpsw: fix parsing of phy-handle
DT property in dual_emac config
On 04/21/2016 09:19 PM, David Rivshin (Allworx) wrote:
> From: David Rivshin <drivshin@...worx.com>
>
> Commit 9e42f715264ff158478fa30eaed847f6e131366b ("drivers: net: cpsw: add
> phy-handle parsing") saved the "phy-handle" phandle into a new cpsw_priv
> field. However, phy connections are per-slave, so the phy_node field should
> be in cpsw_slave_data rather than cpsw_priv.
>
> This would go unnoticed in a single emac configuration. But in dual_emac
> mode, the last "phy-handle" property parsed for either slave would be used
> by both of them, causing them both to refer to the same phy_device.
>
> Fixes: 9e42f715264f ("drivers: net: cpsw: add phy-handle parsing")
> Signed-off-by: David Rivshin <drivshin@...worx.com>
> Tested-by: Nicolas Chauvet <kwizart@...il.com>
> ---
> I would suggest this for -stable. It should apply cleanly as far back
> as 4.4.
>
> Changes since v1 [1]:
> - Rebased (no conflicts)
> - Added Tested-by from Nicolas Chauvet
>
> [1] https://patchwork.ozlabs.org/patch/560326/
Reviewed-by: Grygorii Strashko <grygorii.strashko@...com>
>
> drivers/net/ethernet/ti/cpsw.c | 13 ++++++-------
> drivers/net/ethernet/ti/cpsw.h | 1 +
> 2 files changed, 7 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c
> index 42fdfd4..d69cb3f 100644
> --- a/drivers/net/ethernet/ti/cpsw.c
> +++ b/drivers/net/ethernet/ti/cpsw.c
> @@ -363,15 +363,14 @@ static inline void slave_write(struct cpsw_slave *slave, u32 val, u32 offset)
> __raw_writel(val, slave->regs + offset);
> }
>
> struct cpsw_priv {
> spinlock_t lock;
> struct platform_device *pdev;
> struct net_device *ndev;
> - struct device_node *phy_node;
> struct napi_struct napi_rx;
> struct napi_struct napi_tx;
> struct device *dev;
> struct cpsw_platform_data data;
> struct cpsw_ss_regs __iomem *regs;
> struct cpsw_wr_regs __iomem *wr_regs;
> u8 __iomem *hw_stats;
> @@ -1144,16 +1143,16 @@ static void cpsw_slave_open(struct cpsw_slave *slave, struct cpsw_priv *priv)
>
> if (priv->data.dual_emac)
> cpsw_add_dual_emac_def_ale_entries(priv, slave, slave_port);
> else
> cpsw_ale_add_mcast(priv->ale, priv->ndev->broadcast,
> 1 << slave_port, 0, 0, ALE_MCAST_FWD_2);
>
> - if (priv->phy_node)
> - slave->phy = of_phy_connect(priv->ndev, priv->phy_node,
> + if (slave->data->phy_node)
> + slave->phy = of_phy_connect(priv->ndev, slave->data->phy_node,
> &cpsw_adjust_link, 0, slave->data->phy_if);
> else
> slave->phy = phy_connect(priv->ndev, slave->data->phy_id,
> &cpsw_adjust_link, slave->data->phy_if);
> if (IS_ERR(slave->phy)) {
> dev_err(priv->dev, "phy %s not found on slave %d\n",
> slave->data->phy_id, slave->slave_num);
> @@ -1936,20 +1935,19 @@ static void cpsw_slave_init(struct cpsw_slave *slave, struct cpsw_priv *priv,
>
> slave->data = data;
> slave->regs = regs + slave_reg_ofs;
> slave->sliver = regs + sliver_reg_ofs;
> slave->port_vlan = data->dual_emac_res_vlan;
> }
>
> -static int cpsw_probe_dt(struct cpsw_priv *priv,
> +static int cpsw_probe_dt(struct cpsw_platform_data *data,
> struct platform_device *pdev)
> {
> struct device_node *node = pdev->dev.of_node;
> struct device_node *slave_node;
> - struct cpsw_platform_data *data = &priv->data;
> int i = 0, ret;
> u32 prop;
>
> if (!node)
> return -EINVAL;
>
> if (of_property_read_u32(node, "slaves", &prop)) {
> @@ -2029,15 +2027,16 @@ static int cpsw_probe_dt(struct cpsw_priv *priv,
> int lenp;
> const __be32 *parp;
>
> /* This is no slave child node, continue */
> if (strcmp(slave_node->name, "slave"))
> continue;
>
> - priv->phy_node = of_parse_phandle(slave_node, "phy-handle", 0);
> + slave_data->phy_node = of_parse_phandle(slave_node,
> + "phy-handle", 0);
> parp = of_get_property(slave_node, "phy_id", &lenp);
> if (of_phy_is_fixed_link(slave_node)) {
> struct device_node *phy_node;
> struct phy_device *phy_dev;
>
> /* In the case of a fixed PHY, the DT node associated
> * to the PHY is the Ethernet MAC DT node.
> @@ -2271,15 +2270,15 @@ static int cpsw_probe(struct platform_device *pdev)
> * This may be required here for child devices.
> */
> pm_runtime_enable(&pdev->dev);
>
> /* Select default pin state */
> pinctrl_pm_select_default_state(&pdev->dev);
>
> - if (cpsw_probe_dt(priv, pdev)) {
> + if (cpsw_probe_dt(&priv->data, pdev)) {
> dev_err(&pdev->dev, "cpsw: platform data missing\n");
> ret = -ENODEV;
> goto clean_runtime_disable_ret;
> }
> data = &priv->data;
>
> if (is_valid_ether_addr(data->slave_data[0].mac_addr)) {
> diff --git a/drivers/net/ethernet/ti/cpsw.h b/drivers/net/ethernet/ti/cpsw.h
> index 442a703..e50afd1 100644
> --- a/drivers/net/ethernet/ti/cpsw.h
> +++ b/drivers/net/ethernet/ti/cpsw.h
> @@ -14,14 +14,15 @@
> #ifndef __CPSW_H__
> #define __CPSW_H__
>
> #include <linux/if_ether.h>
> #include <linux/phy.h>
>
> struct cpsw_slave_data {
> + struct device_node *phy_node;
> char phy_id[MII_BUS_ID_SIZE];
> int phy_if;
> u8 mac_addr[ETH_ALEN];
> u16 dual_emac_res_vlan; /* Reserved VLAN for DualEMAC */
> };
>
> struct cpsw_platform_data {
>
--
regards,
-grygorii
Powered by blists - more mailing lists