[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <20161125123442.28410-1-wens@csie.org>
Date: Fri, 25 Nov 2016 20:34:34 +0800
From: Chen-Yu Tsai <wens@...e.org>
To: Liam Girdwood <lgirdwood@...il.com>,
Mark Brown <broonie@...nel.org>,
Maxime Ripard <maxime.ripard@...e-electrons.com>,
Lee Jones <lee.jones@...aro.org>
Cc: Chen-Yu Tsai <wens@...e.org>, alsa-devel@...a-project.org,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org,
devicetree@...r.kernel.org,
Mylene Josserand <mylene.josserand@...e-electrons.com>
Subject: [PATCH v2 0/8] ASoC: sunxi: Add support for audio codec in A23/H3 SoCs
Hi everyone,
This is v2 of my Allwinner A23 and H3 audio codec support series.
Changes since v1:
- Use DEFINE_RES_MEM for the analog path controls block resources.
- Added Rob's ack.
This series adds support for the audio codec found in Allwinner A23 and
H3 SoCs. The design and data paths are similar to the audio codec found
in earlier SoCs such as the A31. The analog audio paths are symmetrical
with left/right channels and down-mix selectors for mono differential
output.
What deviates from previous SoCs is that the analog path controls have
been moved to a separate control bus, accessed through a message box
like register interface in the PRCM block. This necessitates writing
a separate component driver for it, which is then tied into the sound
card as an ASoC auxiliary device.
Patch 1 adds the analog path controls block to the sun6i-prcm driver as
a sub-device, for the A23. The H3 currently does not use the PRCM driver.
Patch 2 adds PCM and card support for the A23 codec to the sun4i-codec
driver.
Patch 3 adds a device node for the analog path controls block to the A23
dtsi.
Patch 4 adds a device node for the audio codec, and the phandle for the
analog path controls block to the A23 dtsi.
Patch 5 enables the audio codec for the A23 Q8 tablets. On these tablets
the headphone output is driven in DC coupled, or "direct drive", mode.
Patch 6 adds PCM and card support for the H3 codec to the sun4i-codec
driver.
Patch 7 adds device nodes for the audio codec and analog path controls
block to the H3 dtsi.
Patch 8 enables the audio codec on the Orange Pi PC. The audio output
jack on the board is tied to the line out pins on the SoC.
Please take a look and let me know what you think.
In addition, the sun4i-codec driver is getting pretty large. Maybe we
want to split the different parts into different files?
Regards
ChenYu
Chen-Yu Tsai (8):
mfd: sun6i-prcm: Add codec analog controls sub-device for Allwinner
A23
ASoC: sun4i-codec: Add support for A23 codec
ARM: dts: sun8i: Add codec analog path controls node in PRCM for
A23/A33
ARM: dts: sun8i-a23: Add device node for internal audio codec
ARM: dts: sun8i-a23: q8-tablet: Enable internal audio codec
ASoC: sun4i-codec: Add support for H3 codec
ARM: dts: sun8i-h3: Add device nodes for audio codec and its analog
controls
ARM: dts: sun8i-h3: orange-pi-pc: Enable audio codec
.../devicetree/bindings/sound/sun4i-codec.txt | 14 +-
arch/arm/boot/dts/sun8i-a23-a33.dtsi | 4 +
arch/arm/boot/dts/sun8i-a23-q8-tablet.dts | 23 +++
arch/arm/boot/dts/sun8i-a23.dtsi | 16 ++
arch/arm/boot/dts/sun8i-h3-orangepi-pc.dts | 8 +
arch/arm/boot/dts/sun8i-h3.dtsi | 19 +++
drivers/mfd/sun6i-prcm.c | 13 ++
sound/soc/sunxi/sun4i-codec.c | 179 +++++++++++++++++++++
8 files changed, 274 insertions(+), 2 deletions(-)
--
2.10.2
Powered by blists - more mailing lists