| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1481915716-24612-3-git-send-email-irsaber@gmail.com>
Date: Fri, 16 Dec 2016 22:45:16 +0330
From: Saber Rezvani <irsaber@...il.com>
To: gregkh@...uxfoundation.org
Cc: devel@...verdev.osuosl.org, linux-kernel@...r.kernel.org,
abbotti@....co.uk, Saber Rezvani <irsaber@...il.com>
Subject: [PATCH 3/3] staging: comedi: cb_pcidas64: use preferred kernel type u32
Fix the checkpatch.pl issue:
CHECK: Prefer kernel type 'u32' over 'uint32_t'
Signed-off-by: Saber Rezvani <irsaber@...il.com>
---
drivers/staging/comedi/drivers/cb_pcidas64.c | 38 ++++++++++++++--------------
1 file changed, 19 insertions(+), 19 deletions(-)
diff --git a/drivers/staging/comedi/drivers/cb_pcidas64.c b/drivers/staging/comedi/drivers/cb_pcidas64.c
index f60096d..efbf277 100644
--- a/drivers/staging/comedi/drivers/cb_pcidas64.c
+++ b/drivers/staging/comedi/drivers/cb_pcidas64.c
@@ -1132,8 +1132,8 @@ struct pcidas64_private {
void __iomem *plx9080_iobase;
void __iomem *main_iobase;
/* local address (used by dma controller) */
- uint32_t local0_iobase;
- uint32_t local1_iobase;
+ u32 local0_iobase;
+ u32 local1_iobase;
/* dma buffers for analog input */
u16 *ai_buffer[MAX_AI_DMA_RING_COUNT];
/* physical addresses of ai dma buffers */
@@ -1169,9 +1169,9 @@ struct pcidas64_private {
u16 hw_config_bits;
u16 dac_control1_bits;
/* last bits written to plx9080 control register */
- uint32_t plx_control_bits;
+ u32 plx_control_bits;
/* last bits written to plx interrupt control and status register */
- uint32_t plx_intcsr_bits;
+ u32 plx_intcsr_bits;
/* index of calibration source readable through ai ch0 */
int calibration_source;
/* bits written to i2c calibration/range register */
@@ -1266,7 +1266,7 @@ static void enable_ai_interrupts(struct comedi_device *dev,
{
const struct pcidas64_board *board = dev->board_ptr;
struct pcidas64_private *devpriv = dev->private;
- uint32_t bits;
+ u32 bits;
unsigned long flags;
bits = EN_ADC_OVERRUN_BIT | EN_ADC_DONE_INTR_BIT |
@@ -1292,7 +1292,7 @@ static void init_plx9080(struct comedi_device *dev)
{
const struct pcidas64_board *board = dev->board_ptr;
struct pcidas64_private *devpriv = dev->private;
- uint32_t bits;
+ u32 bits;
void __iomem *plx_iobase = devpriv->plx9080_iobase;
devpriv->plx_control_bits =
@@ -2279,17 +2279,17 @@ static inline unsigned int dma_transfer_size(struct comedi_device *dev)
return num_samples;
}
-static uint32_t ai_convert_counter_6xxx(const struct comedi_device *dev,
+static u32 ai_convert_counter_6xxx(const struct comedi_device *dev,
const struct comedi_cmd *cmd)
{
/* supposed to load counter with desired divisor minus 3 */
return cmd->convert_arg / TIMER_BASE - 3;
}
-static uint32_t ai_scan_counter_6xxx(struct comedi_device *dev,
+static u32 ai_scan_counter_6xxx(struct comedi_device *dev,
struct comedi_cmd *cmd)
{
- uint32_t count;
+ u32 count;
/* figure out how long we need to delay at end of scan */
switch (cmd->scan_begin_src) {
@@ -2307,7 +2307,7 @@ static uint32_t ai_scan_counter_6xxx(struct comedi_device *dev,
return count - 3;
}
-static uint32_t ai_convert_counter_4020(struct comedi_device *dev,
+static u32 ai_convert_counter_4020(struct comedi_device *dev,
struct comedi_cmd *cmd)
{
struct pcidas64_private *devpriv = dev->private;
@@ -2382,7 +2382,7 @@ static void set_ai_pacing(struct comedi_device *dev, struct comedi_cmd *cmd)
{
const struct pcidas64_board *board = dev->board_ptr;
struct pcidas64_private *devpriv = dev->private;
- uint32_t convert_counter = 0, scan_counter = 0;
+ u32 convert_counter = 0, scan_counter = 0;
check_adc_timing(dev, cmd);
@@ -2572,7 +2572,7 @@ static int ai_cmd(struct comedi_device *dev, struct comedi_subdevice *s)
struct pcidas64_private *devpriv = dev->private;
struct comedi_async *async = s->async;
struct comedi_cmd *cmd = &async->cmd;
- uint32_t bits;
+ u32 bits;
unsigned int i;
unsigned long flags;
int retval;
@@ -2754,7 +2754,7 @@ static void pio_drain_ai_fifo_32(struct comedi_device *dev)
struct comedi_subdevice *s = dev->read_subdev;
unsigned int nsamples;
unsigned int i;
- uint32_t fifo_data;
+ u32 fifo_data;
int write_code =
readw(devpriv->main_iobase + ADC_WRITE_PNTR_REG) & 0x7fff;
int read_code =
@@ -2794,7 +2794,7 @@ static void drain_dma_buffers(struct comedi_device *dev, unsigned int channel)
const struct pcidas64_board *board = dev->board_ptr;
struct pcidas64_private *devpriv = dev->private;
struct comedi_subdevice *s = dev->read_subdev;
- uint32_t next_transfer_addr;
+ u32 next_transfer_addr;
int j;
int num_samples = 0;
void __iomem *pci_addr_reg;
@@ -3056,8 +3056,8 @@ static irqreturn_t handle_interrupt(int irq, void *d)
struct comedi_device *dev = d;
struct pcidas64_private *devpriv = dev->private;
unsigned short status;
- uint32_t plx_status;
- uint32_t plx_bits;
+ u32 plx_status;
+ u32 plx_bits;
plx_status = readl(devpriv->plx9080_iobase + PLX_REG_INTCSR);
status = readw(devpriv->main_iobase + HW_STATUS_REG);
@@ -3975,7 +3975,7 @@ static int auto_attach(struct comedi_device *dev,
struct pci_dev *pcidev = comedi_to_pci_dev(dev);
const struct pcidas64_board *board = NULL;
struct pcidas64_private *devpriv;
- uint32_t local_range, local_decode;
+ u32 local_range, local_decode;
int retval;
if (context < ARRAY_SIZE(pcidas64_boards))
@@ -4013,13 +4013,13 @@ static int auto_attach(struct comedi_device *dev,
PLX_LASRR_MEM_MASK;
local_decode = readl(devpriv->plx9080_iobase + PLX_REG_LAS0BA) &
local_range & PLX_LASBA_MEM_MASK;
- devpriv->local0_iobase = ((uint32_t)devpriv->main_phys_iobase &
+ devpriv->local0_iobase = ((u32)devpriv->main_phys_iobase &
~local_range) | local_decode;
local_range = readl(devpriv->plx9080_iobase + PLX_REG_LAS1RR) &
PLX_LASRR_MEM_MASK;
local_decode = readl(devpriv->plx9080_iobase + PLX_REG_LAS1BA) &
local_range & PLX_LASBA_MEM_MASK;
- devpriv->local1_iobase = ((uint32_t)devpriv->dio_counter_phys_iobase &
+ devpriv->local1_iobase = ((u32)devpriv->dio_counter_phys_iobase &
~local_range) | local_decode;
retval = alloc_and_init_dma_members(dev);
--
2.7.4
Powered by blists - more mailing lists