| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1489049402-15791-5-git-send-email-zhangqing@rock-chips.com>
Date: Thu, 9 Mar 2017 16:50:02 +0800
From: Elaine Zhang <zhangqing@...k-chips.com>
To: lee.jones@...aro.org, lgirdwood@...il.com, broonie@...nel.org
Cc: huangtao@...k-chips.com, xxx@...k-chips.com,
linux-rockchip@...ts.infradead.org, linux-kernel@...r.kernel.org,
chenjh@...k-chips.com, Elaine Zhang <zhangqing@...k-chips.com>
Subject: [PATCH v1 4/4] mfd: rk808: Add RK805 support
The RK805 chip is a Power Management IC (PMIC) for multimedia and handheld
devices. It contains the following components:
- Regulators
- RTC
- Clocking
Both RK808 and RK805 chips are using a similar register map,
so we can reuse the RTC and Clocking functionality.
Signed-off-by: Elaine Zhang <zhangqing@...k-chips.com>
---
drivers/clk/Kconfig | 4 +-
drivers/mfd/Kconfig | 4 +-
drivers/mfd/rk808.c | 109 ++++++++++++++++++++++++++++++++++++++++++++++++++++
drivers/rtc/Kconfig | 4 +-
4 files changed, 115 insertions(+), 6 deletions(-)
diff --git a/drivers/clk/Kconfig b/drivers/clk/Kconfig
index 9356ab4b7d76..7ca8f02a1232 100644
--- a/drivers/clk/Kconfig
+++ b/drivers/clk/Kconfig
@@ -39,10 +39,10 @@ config COMMON_CLK_MAX77686
clock.
config COMMON_CLK_RK808
- tristate "Clock driver for RK808/RK818"
+ tristate "Clock driver for RK805/RK808/RK818"
depends on MFD_RK808
---help---
- This driver supports RK808 and RK818 crystal oscillator clock. These
+ This driver supports RK805, RK808 and RK818 crystal oscillator clock. These
multi-function devices have two fixed-rate oscillators,
clocked at 32KHz each. Clkout1 is always on, Clkout2 can off
by control register.
diff --git a/drivers/mfd/Kconfig b/drivers/mfd/Kconfig
index 55ecdfb74d31..b410a348b756 100644
--- a/drivers/mfd/Kconfig
+++ b/drivers/mfd/Kconfig
@@ -892,13 +892,13 @@ config MFD_RC5T583
different functionality of the device.
config MFD_RK808
- tristate "Rockchip RK808/RK818 Power Management Chip"
+ tristate "Rockchip RK805/RK808/RK818 Power Management Chip"
depends on I2C && OF
select MFD_CORE
select REGMAP_I2C
select REGMAP_IRQ
help
- If you say yes here you get support for the RK808 and RK818
+ If you say yes here you get support for the RK805, RK808 and RK818
Power Management chips.
This driver provides common support for accessing the device
through I2C interface. The device supports multiple sub-devices
diff --git a/drivers/mfd/rk808.c b/drivers/mfd/rk808.c
index 3334a2a7f3fb..97fd4c0a811d 100644
--- a/drivers/mfd/rk808.c
+++ b/drivers/mfd/rk808.c
@@ -70,6 +70,14 @@ static bool rk808_is_volatile_reg(struct device *dev, unsigned int reg)
.volatile_reg = rk808_is_volatile_reg,
};
+static const struct regmap_config rk805_regmap_config = {
+ .reg_bits = 8,
+ .val_bits = 8,
+ .max_register = RK805_OFF_SOURCE_REG,
+ .cache_type = REGCACHE_RBTREE,
+ .volatile_reg = rk808_is_volatile_reg,
+};
+
static const struct regmap_config rk808_regmap_config = {
.reg_bits = 8,
.val_bits = 8,
@@ -86,6 +94,16 @@ static bool rk808_is_volatile_reg(struct device *dev, unsigned int reg)
}
};
+static const struct mfd_cell rk805s[] = {
+ { .name = "rk808-clkout", },
+ { .name = "rk808-regulator", },
+ {
+ .name = "rk808-rtc",
+ .num_resources = ARRAY_SIZE(rtc_resources),
+ .resources = &rtc_resources[0],
+ },
+};
+
static const struct mfd_cell rk808s[] = {
{ .name = "rk808-clkout", },
{ .name = "rk808-regulator", },
@@ -106,6 +124,12 @@ static bool rk808_is_volatile_reg(struct device *dev, unsigned int reg)
},
};
+static const struct rk808_reg_data rk805_pre_init_reg[] = {
+ {RK805_BUCK4_CONFIG_REG, BUCK_ILMIN_MASK, BUCK_ILMIN_400MA},
+ {RK805_GPIO_IO_POL_REG, SLP_SD_MSK, SLEEP_FUN},
+ {RK805_THERMAL_REG, TEMP_HOTDIE_MSK, TEMP115C},
+};
+
static const struct rk808_reg_data rk808_pre_init_reg[] = {
{ RK808_BUCK3_CONFIG_REG, BUCK_ILMIN_MASK, BUCK_ILMIN_150MA },
{ RK808_BUCK4_CONFIG_REG, BUCK_ILMIN_MASK, BUCK_ILMIN_200MA },
@@ -135,6 +159,41 @@ static bool rk808_is_volatile_reg(struct device *dev, unsigned int reg)
VB_LO_SEL_3500MV },
};
+static const struct regmap_irq rk805_irqs[] = {
+ [RK805_IRQ_PWRON_RISE] = {
+ .mask = RK805_IRQ_PWRON_RISE_MSK,
+ .reg_offset = 0,
+ },
+ [RK805_IRQ_VB_LOW] = {
+ .mask = RK805_IRQ_VB_LOW_MSK,
+ .reg_offset = 0,
+ },
+ [RK805_IRQ_PWRON] = {
+ .mask = RK805_IRQ_PWRON_MSK,
+ .reg_offset = 0,
+ },
+ [RK805_IRQ_PWRON_LP] = {
+ .mask = RK805_IRQ_PWRON_LP_MSK,
+ .reg_offset = 0,
+ },
+ [RK805_IRQ_HOTDIE] = {
+ .mask = RK805_IRQ_HOTDIE_MSK,
+ .reg_offset = 0,
+ },
+ [RK805_IRQ_RTC_ALARM] = {
+ .mask = RK805_IRQ_RTC_ALARM_MSK,
+ .reg_offset = 0,
+ },
+ [RK805_IRQ_RTC_PERIOD] = {
+ .mask = RK805_IRQ_RTC_PERIOD_MSK,
+ .reg_offset = 0,
+ },
+ [RK805_IRQ_PWRON_FALL] = {
+ .mask = RK805_IRQ_PWRON_FALL_MSK,
+ .reg_offset = 0,
+ },
+};
+
static const struct regmap_irq rk808_irqs[] = {
/* INT_STS */
[RK808_IRQ_VOUT_LO] = {
@@ -247,6 +306,17 @@ static bool rk808_is_volatile_reg(struct device *dev, unsigned int reg)
},
};
+static struct regmap_irq_chip rk805_irq_chip = {
+ .name = "rk805",
+ .irqs = rk805_irqs,
+ .num_irqs = ARRAY_SIZE(rk805_irqs),
+ .num_regs = 1,
+ .status_base = RK805_INT_STS_REG,
+ .mask_base = RK805_INT_STS_MSK_REG,
+ .ack_base = RK805_INT_STS_REG,
+ .init_ack_masked = true,
+};
+
static const struct regmap_irq_chip rk808_irq_chip = {
.name = "rk808",
.irqs = rk808_irqs,
@@ -272,6 +342,34 @@ static bool rk808_is_volatile_reg(struct device *dev, unsigned int reg)
};
static struct i2c_client *rk808_i2c_client;
+
+static void rk805_device_shutdown(void)
+{
+ int ret;
+ struct rk808 *rk808 = i2c_get_clientdata(rk808_i2c_client);
+
+ if (!rk808) {
+ dev_warn(&rk808_i2c_client->dev,
+ "have no rk808, so do nothing here\n");
+ return;
+ }
+
+ /* close rtc int when power off */
+ regmap_update_bits(rk808->regmap,
+ RK808_INT_STS_MSK_REG1,
+ (0x3 << 5), (0x3 << 5));
+ regmap_update_bits(rk808->regmap,
+ RK808_RTC_INT_REG,
+ (0x3 << 2), (0x0 << 2));
+
+ /* pmic sleep shutdown function */
+ ret = regmap_update_bits(rk808->regmap,
+ RK805_GPIO_IO_POL_REG,
+ SLP_SD_MSK, SHUTDOWN_FUN);
+ if (ret)
+ dev_err(&rk808_i2c_client->dev, "power off error!\n");
+}
+
static void rk808_device_shutdown(void)
{
int ret;
@@ -309,6 +407,7 @@ static void rk818_device_shutdown(void)
}
static const struct of_device_id rk808_of_match[] = {
+ { .compatible = "rockchip,rk805" },
{ .compatible = "rockchip,rk808" },
{ .compatible = "rockchip,rk818" },
{ },
@@ -352,6 +451,15 @@ static int rk808_probe(struct i2c_client *client,
dev_info(&client->dev, "Chip id: 0x%x\n", (unsigned int)rk808->variant);
switch (rk808->variant) {
+ case RK805_ID:
+ rk808->regmap_cfg = &rk805_regmap_config;
+ rk808->regmap_irq_chip = &rk805_irq_chip;
+ pre_init_reg = rk805_pre_init_reg;
+ nr_pre_init_regs = ARRAY_SIZE(rk805_pre_init_reg);
+ cells = rk805s;
+ nr_cells = ARRAY_SIZE(rk805s);
+ pm_pwroff_fn = rk805_device_shutdown;
+ break;
case RK808_ID:
rk808->regmap_cfg = &rk808_regmap_config;
rk808->regmap_irq_chip = &rk808_irq_chip;
@@ -444,6 +552,7 @@ static int rk808_remove(struct i2c_client *client)
}
static const struct i2c_device_id rk808_ids[] = {
+ { "rk805" },
{ "rk808" },
{ "rk818" },
{ },
diff --git a/drivers/rtc/Kconfig b/drivers/rtc/Kconfig
index 5dc673dc9487..47d6a8df06db 100644
--- a/drivers/rtc/Kconfig
+++ b/drivers/rtc/Kconfig
@@ -352,11 +352,11 @@ config RTC_DRV_MAX77686
will be called rtc-max77686.
config RTC_DRV_RK808
- tristate "Rockchip RK808/RK818 RTC"
+ tristate "Rockchip RK805/RK808/RK818 RTC"
depends on MFD_RK808
help
If you say yes here you will get support for the
- RTC of RK808 and RK818 PMIC.
+ RTC of RK805, RK808 and RK818 PMIC.
This driver can also be built as a module. If so, the module
will be called rk808-rtc.
--
1.9.1
Powered by blists - more mailing lists