[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <1496704922-12261-1-git-send-email-yamada.masahiro@socionext.com>
Date: Tue, 6 Jun 2017 08:21:39 +0900
From: Masahiro Yamada <yamada.masahiro@...ionext.com>
To: linux-mtd@...ts.infradead.org
Cc: Enrico Jorns <ejo@...gutronix.de>,
Artem Bityutskiy <artem.bityutskiy@...ux.intel.com>,
Dinh Nguyen <dinguyen@...nel.org>,
Boris Brezillon <boris.brezillon@...e-electrons.com>,
Marek Vasut <marek.vasut@...il.com>,
Graham Moore <grmoore@...nsource.altera.com>,
David Woodhouse <dwmw2@...radead.org>,
Masami Hiramatsu <mhiramat@...nel.org>,
Chuanxiao Dong <chuanxiao.dong@...el.com>,
Jassi Brar <jaswinder.singh@...aro.org>,
Masahiro Yamada <yamada.masahiro@...ionext.com>,
Cyrille Pitchen <cyrille.pitchen@...ev4u.fr>,
devicetree@...r.kernel.org, linux-kernel@...r.kernel.org,
Brian Norris <computersforpeace@...il.com>,
Richard Weinberger <richard@....at>,
Rob Herring <robh+dt@...nel.org>,
Mark Rutland <mark.rutland@....com>
Subject: [PATCH v4 00/23] mtd: nand: denali: Denali NAND IP patch bomb
This patch series intends to solve various problems.
[1] The driver just retrieves the OOB area as-is
whereas the controller uses syndrome page layout.
[2] Many NAND chip specific parameters are hard-coded in the driver.
[3] ONFi devices are not working
[4] It can not read Bad Block Marker
Outstanding changes are:
- Fix raw/oob callbacks for syndrome page layout
- Implement setup_data_interface() callback
- Fix/implement more commands for ONFi devices
- Allow to skip the driver internal bounce buffer
- Support PIO in case DMA is not supported
- Switch from ->cmdfunc over to ->cmd_ctrl
18 patches were merged at v2.
11 patches were merged at v3.
Here is the rest of the series.
v1: https://lkml.org/lkml/2016/11/26/144
v2: https://lkml.org/lkml/2017/3/22/804
v3: https://lkml.org/lkml/2017/3/30/90
Masahiro Yamada (23):
mtd: nand: denali_dt: clean up resource ioremap
mtd: nand: denali: use BIT() and GENMASK() for register macros
mtd: nand: add generic helpers to check, match, maximize ECC settings
mtd: nand: denali: avoid hard-coding ECC step, strength, bytes
mtd: nand: denali: remove Toshiba and Hynix specific fixup code
mtd: nand: denali_dt: add compatible strings for UniPhier SoC variants
mtd: nand: denali: set NAND_ECC_CUSTOM_PAGE_ACCESS
mtd: nand: denali: do not propagate NAND_STATUS_FAIL to waitfunc()
mtd: nand: denali: remove unneeded find_valid_banks()
mtd: nand: denali: handle timing parameters by setup_data_interface()
mtd: nand: denali: rework interrupt handling
mtd: nand: denali: fix NAND_CMD_STATUS handling
mtd: nand: denali: fix NAND_CMD_PARAM handling
mtd: nand: denali: switch over to cmd_ctrl instead of cmdfunc
mtd: nand: denali: fix bank reset function to detect the number of
chips
mtd: nand: denali: use interrupt instead of polling for bank reset
mtd: nand: denali: propagate page to helpers via function argument
mtd: nand: denali: merge struct nand_buf into struct denali_nand_info
mtd: nand: denali: use flag instead of register macro for direction
mtd: nand: denali: fix raw and oob accessors for syndrome page layout
mtd: nand: denali: skip driver internal bounce buffer when possible
mtd: nand: denali: use non-managed kmalloc() for DMA buffer
mtd: nand: denali: enable bad block table scan
.../devicetree/bindings/mtd/denali-nand.txt | 13 +
drivers/mtd/nand/denali.c | 1701 +++++++++-----------
drivers/mtd/nand/denali.h | 294 ++--
drivers/mtd/nand/denali_dt.c | 54 +-
drivers/mtd/nand/denali_pci.c | 15 +-
drivers/mtd/nand/nand_base.c | 219 +++
include/linux/mtd/nand.h | 35 +
7 files changed, 1235 insertions(+), 1096 deletions(-)
--
2.7.4
Powered by blists - more mailing lists