linux-kernel - RE: [PATCH net v2 2/2] net: ixgbe: Use new PCI_DEV_FLAGS_NO_RELAXED

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-ID: <87618083B2453E4A8714035B62D67992B4095363@FMSMSX105.amr.corp.intel.com>
Date:   Fri, 18 Aug 2017 05:04:03 +0000
From:   "Tantilov, Emil S" <emil.s.tantilov@...el.com>
To:     Ding Tianhong <dingtianhong@...wei.com>,
        "davem@...emloft.net" <davem@...emloft.net>,
        "Kirsher, Jeffrey T" <jeffrey.t.kirsher@...el.com>,
        "keescook@...omium.org" <keescook@...omium.org>,
        "linux-kernel@...r.kernel.org" <linux-kernel@...r.kernel.org>,
        "sparclinux@...r.kernel.org" <sparclinux@...r.kernel.org>,
        "intel-wired-lan@...ts.osuosl.org" <intel-wired-lan@...ts.osuosl.org>,
        "alexander.duyck@...il.com" <alexander.duyck@...il.com>,
        "netdev@...r.kernel.org" <netdev@...r.kernel.org>,
        "linuxarm@...wei.com" <linuxarm@...wei.com>
Subject: RE: [PATCH net v2 2/2] net: ixgbe: Use new
 PCI_DEV_FLAGS_NO_RELAXED_ORDERING flag

>-----Original Message-----
>From: Ding Tianhong [mailto:dingtianhong@...wei.com]
>Sent: Thursday, August 17, 2017 5:39 PM
>To: Tantilov, Emil S <emil.s.tantilov@...el.com>; davem@...emloft.net;
>Kirsher, Jeffrey T <jeffrey.t.kirsher@...el.com>; keescook@...omium.org;
>linux-kernel@...r.kernel.org; sparclinux@...r.kernel.org; intel-wired-
>lan@...ts.osuosl.org; alexander.duyck@...il.com; netdev@...r.kernel.org;
>linuxarm@...wei.com
>Subject: Re: [PATCH net v2 2/2] net: ixgbe: Use new
>PCI_DEV_FLAGS_NO_RELAXED_ORDERING flag
>
>
>
>On 2017/8/17 22:17, Tantilov, Emil S wrote:
>
>>> 	ret_val = ixgbe_start_hw_generic(hw);
>>>
>>> -#ifndef CONFIG_SPARC
>>> -	/* Disable relaxed ordering */
>>> -	for (i = 0; ((i < hw->mac.max_tx_queues) &&
>>> -	     (i < IXGBE_DCA_MAX_QUEUES_82598)); i++) {
>>> -		regval = IXGBE_READ_REG(hw, IXGBE_DCA_TXCTRL(i));
>>> -		regval &= ~IXGBE_DCA_TXCTRL_DESC_WRO_EN;
>>> -		IXGBE_WRITE_REG(hw, IXGBE_DCA_TXCTRL(i), regval);
>>> -	}
>>> +	if (!pcie_relaxed_ordering_enabled(adapter->pdev)) {
>>
>> As Alex mentioned there is no need for this check in any form.
>>
>> The HW defaults to Relaxed Ordering enabled unless it is disabled in
>> the PCIe Device Control Register. So the above logic is already done by
>HW.
>>
>> All you have to do is strip the code disabling relaxed ordering.
>>
>
>Hi Tantilov:
>
>I misunderstood Alex's suggestion, But I still couldn't find the logic
>where
>the HW disable the Relaxed Ordering when the PCIe Device Control Register
>disable it, can you point it out?

If you look at the datasheet (82599) - the description of CTRL_EXT.RO_DIS (bit 17, 0b):

Relaxed Ordering Disable. When set to 1b, the device does not request any relaxed
ordering transactions. When this bit is cleared and the Enable Relaxed Ordering bit in
the Device Control register is set, the device requests relaxed ordering transactions per queues as configured in the DCA_RXCTRL[n] and DCA_TXCTRL[n] registers.

So if you remove the code that clears the bits in DCA_T/RXCTRL relaxed ordering should
be enabled by HW when the bus allows it.

Thanks,
Emil