32bit has the idt_descr sitting in the low level assembly entry code. There is no reason for that. Move it into the C file and use the 64bit version of it. Signed-off-by: Thomas Gleixner --- arch/x86/kernel/head_32.S | 6 ------ arch/x86/kernel/idt.c | 10 +++++----- 2 files changed, 5 insertions(+), 11 deletions(-) --- a/arch/x86/kernel/head_32.S +++ b/arch/x86/kernel/head_32.S @@ -626,7 +626,6 @@ ENTRY(initial_stack) .data .globl boot_gdt_descr -.globl idt_descr ALIGN # early boot GDT descriptor (must use 1:1 address mapping) @@ -635,11 +634,6 @@ ENTRY(initial_stack) .word __BOOT_DS+7 .long boot_gdt - __PAGE_OFFSET - .word 0 # 32-bit align idt_desc.address -idt_descr: - .word IDT_ENTRIES*8-1 # idt contains 256 entries - .long idt_table - # boot GDT descriptor (later on used by CPU#0): .word 0 # 32 bit align gdt_desc.address ENTRY(early_gdt_descr) --- a/arch/x86/kernel/idt.c +++ b/arch/x86/kernel/idt.c @@ -10,15 +10,15 @@ /* Must be page-aligned because the real IDT is used in a fixmap. */ gate_desc idt_table[IDT_ENTRIES] __page_aligned_bss; -#ifdef CONFIG_X86_64 -/* No need to be aligned, but done to keep all IDTs defined the same way. */ -gate_desc debug_idt_table[IDT_ENTRIES] __page_aligned_bss; - struct desc_ptr idt_descr __ro_after_init = { - .size = IDT_ENTRIES * 16 - 1, + .size = (IDT_ENTRIES * 2 * sizeof(unsigned long)) - 1, .address = (unsigned long) idt_table, }; +#ifdef CONFIG_X86_64 +/* No need to be aligned, but done to keep all IDTs defined the same way. */ +gate_desc debug_idt_table[IDT_ENTRIES] __page_aligned_bss; + const struct desc_ptr debug_idt_descr = { .size = IDT_ENTRIES * 16 - 1, .address = (unsigned long) debug_idt_table,