[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20171203151726.16639-3-simon@nikanor.nu>
Date: Sun, 3 Dec 2017 16:17:22 +0100
From: Simon Sandström <simon@...anor.nu>
To: gregkh@...uxfoundation.org
Cc: linux@...f-Entwicklungen.de, devel@...verdev.osuosl.org,
linux-kernel@...r.kernel.org
Subject: [PATCH 2/6] staging: pi433: Capitalize constant definitions
Fixes checkpatch.pl warnings "Avoid CamelCase <DIO_x>".
Signed-off-by: Simon Sandström <simon@...anor.nu>
---
drivers/staging/pi433/pi433_if.c | 32 ++++++++++++-------------
drivers/staging/pi433/rf69_registers.h | 44 +++++++++++++++++-----------------
2 files changed, 38 insertions(+), 38 deletions(-)
diff --git a/drivers/staging/pi433/pi433_if.c b/drivers/staging/pi433/pi433_if.c
index 3404cb9722c9..840a7c7bf19a 100644
--- a/drivers/staging/pi433/pi433_if.c
+++ b/drivers/staging/pi433/pi433_if.c
@@ -133,20 +133,20 @@ static irqreturn_t DIO0_irq_handler(int irq, void *dev_id)
{
struct pi433_device *device = dev_id;
- if (device->irq_state[DIO0] == DIO_PacketSent)
+ if (device->irq_state[DIO0] == DIO_PACKET_SENT)
{
device->free_in_fifo = FIFO_SIZE;
dev_dbg(device->dev, "DIO0 irq: Packet sent\n");
wake_up_interruptible(&device->fifo_wait_queue);
}
- else if (device->irq_state[DIO0] == DIO_Rssi_DIO0)
+ else if (device->irq_state[DIO0] == DIO_RSSI_DIO0)
{
dev_dbg(device->dev, "DIO0 irq: RSSI level over threshold\n");
wake_up_interruptible(&device->rx_wait_queue);
}
- else if (device->irq_state[DIO0] == DIO_PayloadReady)
+ else if (device->irq_state[DIO0] == DIO_PAYLOAD_READY)
{
- dev_dbg(device->dev, "DIO0 irq: PayloadReady\n");
+ dev_dbg(device->dev, "DIO0 irq: Payload ready\n");
device->free_in_fifo = 0;
wake_up_interruptible(&device->fifo_wait_queue);
}
@@ -158,11 +158,11 @@ static irqreturn_t DIO1_irq_handler(int irq, void *dev_id)
{
struct pi433_device *device = dev_id;
- if (device->irq_state[DIO1] == DIO_FifoNotEmpty_DIO1)
+ if (device->irq_state[DIO1] == DIO_FIFO_NOT_EMPTY_DIO1)
{
device->free_in_fifo = FIFO_SIZE;
}
- else if (device->irq_state[DIO1] == DIO_FifoLevel)
+ else if (device->irq_state[DIO1] == DIO_FIFO_LEVEL)
{
if (device->rx_active) device->free_in_fifo = FIFO_THRESHOLD - 1;
else device->free_in_fifo = FIFO_SIZE - FIFO_THRESHOLD - 1;
@@ -309,14 +309,14 @@ pi433_start_rx(struct pi433_device *dev)
if (retval) return retval;
/* setup rssi irq */
- SET_CHECKED(rf69_set_dio_mapping(dev->spi, DIO0, DIO_Rssi_DIO0));
- dev->irq_state[DIO0] = DIO_Rssi_DIO0;
+ SET_CHECKED(rf69_set_dio_mapping(dev->spi, DIO0, DIO_RSSI_DIO0));
+ dev->irq_state[DIO0] = DIO_RSSI_DIO0;
irq_set_irq_type(dev->irq_num[DIO0], IRQ_TYPE_EDGE_RISING);
/* setup fifo level interrupt */
SET_CHECKED(rf69_set_fifo_threshold(dev->spi, FIFO_SIZE - FIFO_THRESHOLD));
- SET_CHECKED(rf69_set_dio_mapping(dev->spi, DIO1, DIO_FifoLevel));
- dev->irq_state[DIO1] = DIO_FifoLevel;
+ SET_CHECKED(rf69_set_dio_mapping(dev->spi, DIO1, DIO_FIFO_LEVEL));
+ dev->irq_state[DIO1] = DIO_FIFO_LEVEL;
irq_set_irq_type(dev->irq_num[DIO1], IRQ_TYPE_EDGE_RISING);
/* set module to receiving mode */
@@ -378,8 +378,8 @@ pi433_receive(void *data)
}
/* configure payload ready irq */
- SET_CHECKED(rf69_set_dio_mapping(spi, DIO0, DIO_PayloadReady));
- dev->irq_state[DIO0] = DIO_PayloadReady;
+ SET_CHECKED(rf69_set_dio_mapping(spi, DIO0, DIO_PAYLOAD_READY));
+ dev->irq_state[DIO0] = DIO_PAYLOAD_READY;
irq_set_irq_type(dev->irq_num[DIO0], IRQ_TYPE_EDGE_RISING);
/* fixed or unlimited length? */
@@ -590,13 +590,13 @@ pi433_tx_thread(void *data)
rf69_set_tx_cfg(device, &tx_cfg);
/* enable fifo level interrupt */
- SET_CHECKED(rf69_set_dio_mapping(spi, DIO1, DIO_FifoLevel));
- device->irq_state[DIO1] = DIO_FifoLevel;
+ SET_CHECKED(rf69_set_dio_mapping(spi, DIO1, DIO_FIFO_LEVEL));
+ device->irq_state[DIO1] = DIO_FIFO_LEVEL;
irq_set_irq_type(device->irq_num[DIO1], IRQ_TYPE_EDGE_FALLING);
/* enable packet sent interrupt */
- SET_CHECKED(rf69_set_dio_mapping(spi, DIO0, DIO_PacketSent));
- device->irq_state[DIO0] = DIO_PacketSent;
+ SET_CHECKED(rf69_set_dio_mapping(spi, DIO0, DIO_PACKET_SENT));
+ device->irq_state[DIO0] = DIO_PACKET_SENT;
irq_set_irq_type(device->irq_num[DIO0], IRQ_TYPE_EDGE_RISING);
enable_irq(device->irq_num[DIO0]); /* was disabled by rx active check */
diff --git a/drivers/staging/pi433/rf69_registers.h b/drivers/staging/pi433/rf69_registers.h
index 6335d42142fe..d23b8b668ef5 100644
--- a/drivers/staging/pi433/rf69_registers.h
+++ b/drivers/staging/pi433/rf69_registers.h
@@ -346,28 +346,28 @@
#define DIO5 5
/* DIO Mapping values (packet mode) */
-#define DIO_ModeReady_DIO4 0x00
-#define DIO_ModeReady_DIO5 0x03
-#define DIO_ClkOut 0x00
-#define DIO_Data 0x01
-#define DIO_TimeOut_DIO1 0x03
-#define DIO_TimeOut_DIO4 0x00
-#define DIO_Rssi_DIO0 0x03
-#define DIO_Rssi_DIO3_4 0x01
-#define DIO_RxReady 0x02
-#define DIO_PLLLock 0x03
-#define DIO_TxReady 0x01
-#define DIO_FifoFull_DIO1 0x01
-#define DIO_FifoFull_DIO3 0x00
-#define DIO_SyncAddress 0x02
-#define DIO_FifoNotEmpty_DIO1 0x02
-#define DIO_FifoNotEmpty_FIO2 0x00
-#define DIO_Automode 0x04
-#define DIO_FifoLevel 0x00
-#define DIO_CrcOk 0x00
-#define DIO_PayloadReady 0x01
-#define DIO_PacketSent 0x00
-#define DIO_Dclk 0x00
+#define DIO_MODE_READY_DIO4 0x00
+#define DIO_MODE_READY_DIO5 0x03
+#define DIO_CLK_OUT 0x00
+#define DIO_DATA 0x01
+#define DIO_TIMEOUT_DIO1 0x03
+#define DIO_TIMEOUT_DIO4 0x00
+#define DIO_RSSI_DIO0 0x03
+#define DIO_RSSI_DIO3_4 0x01
+#define DIO_RX_READY 0x02
+#define DIO_PLL_LOCK 0x03
+#define DIO_TX_READY 0x01
+#define DIO_FIFO_FULL_DIO1 0x01
+#define DIO_FIFO_FULL_DIO3 0x00
+#define DIO_SYNC_ADDRESS 0x02
+#define DIO_FIFO_NOT_EMPTY_DIO1 0x02
+#define DIO_FIFO_NOT_EMPTY_FIO2 0x00
+#define DIO_AUTOMODE 0x04
+#define DIO_FIFO_LEVEL 0x00
+#define DIO_CRC_OK 0x00
+#define DIO_PAYLOAD_READY 0x01
+#define DIO_PACKET_SENT 0x00
+#define DIO_DCLK 0x00
/* RegDioMapping2 CLK_OUT part */
#define MASK_DIOMAPPING2_CLK_OUT 0x07
--
2.11.0
Powered by blists - more mailing lists