From: Dave Hansen This uses INVPCID to shoot down individual lines of the user mapping instead of marking the entire user map as invalid. This could/might/possibly be faster. This for sure needs tlb_single_page_flush_ceiling to be redetermined; esp. since INVPCID is _slow_. A detailed performance analysis is available here: https://lkml.kernel.org/r/3062e486-3539-8a1f-5724-16199420be71@intel.com [ Peterz: Split out from big combo patch ] Signed-off-by: Dave Hansen Signed-off-by: Peter Zijlstra (Intel) Signed-off-by: Ingo Molnar Signed-off-by: Thomas Gleixner Cc: Andy Lutomirski Cc: Boris Ostrovsky Cc: Borislav Petkov Cc: Brian Gerst Cc: Denys Vlasenko Cc: Eduardo Valentin Cc: Greg KH Cc: H. Peter Anvin Cc: Josh Poimboeuf Cc: Juergen Gross Cc: Linus Torvalds Cc: Will Deacon Cc: aliguori@amazon.com Cc: daniel.gruss@iaik.tugraz.at Cc: hughd@google.com Cc: keescook@google.com --- arch/x86/include/asm/cpufeatures.h | 1 arch/x86/include/asm/tlbflush.h | 23 ++++++++++++- arch/x86/mm/init.c | 64 +++++++++++++++++++++---------------- 3 files changed, 60 insertions(+), 28 deletions(-) --- a/arch/x86/include/asm/cpufeatures.h +++ b/arch/x86/include/asm/cpufeatures.h @@ -197,6 +197,7 @@ #define X86_FEATURE_CAT_L3 ( 7*32+ 4) /* Cache Allocation Technology L3 */ #define X86_FEATURE_CAT_L2 ( 7*32+ 5) /* Cache Allocation Technology L2 */ #define X86_FEATURE_CDP_L3 ( 7*32+ 6) /* Code and Data Prioritization L3 */ +#define X86_FEATURE_INVPCID_SINGLE ( 7*32+ 7) /* Effectively INVPCID && CR4.PCIDE=1 */ #define X86_FEATURE_HW_PSTATE ( 7*32+ 8) /* AMD HW-PState */ #define X86_FEATURE_PROC_FEEDBACK ( 7*32+ 9) /* AMD ProcFeedbackInterface */ --- a/arch/x86/include/asm/tlbflush.h +++ b/arch/x86/include/asm/tlbflush.h @@ -85,6 +85,18 @@ static inline u16 kern_pcid(u16 asid) return asid + 1; } +/* + * The user PCID is just the kernel one, plus the "switch bit". + */ +static inline u16 user_pcid(u16 asid) +{ + u16 ret = kern_pcid(asid); +#ifdef CONFIG_PAGE_TABLE_ISOLATION + ret |= 1 << X86_CR3_PTI_SWITCH_BIT; +#endif + return ret; +} + struct pgd_t; static inline unsigned long build_cr3(pgd_t *pgd, u16 asid) { @@ -335,6 +347,8 @@ static inline void __native_flush_tlb_gl /* * Using INVPCID is considerably faster than a pair of writes * to CR4 sandwiched inside an IRQ flag save/restore. + * + * Note, this works with CR4.PCIDE=0 or 1. */ invpcid_flush_all(); return; @@ -368,7 +382,14 @@ static inline void __native_flush_tlb_si if (!static_cpu_has(X86_FEATURE_PTI)) return; - invalidate_user_asid(loaded_mm_asid); + /* + * Some platforms #GP if we call invpcid(type=1/2) before CR4.PCIDE=1. + * Just use invalidate_user_asid() in case we are called early. + */ + if (!this_cpu_has(X86_FEATURE_INVPCID_SINGLE)) + invalidate_user_asid(loaded_mm_asid); + else + invpcid_flush_one(user_pcid(loaded_mm_asid), addr); } /* --- a/arch/x86/mm/init.c +++ b/arch/x86/mm/init.c @@ -203,34 +203,44 @@ static void __init probe_page_size_mask( static void setup_pcid(void) { -#ifdef CONFIG_X86_64 - if (boot_cpu_has(X86_FEATURE_PCID)) { - if (boot_cpu_has(X86_FEATURE_PGE)) { - /* - * This can't be cr4_set_bits_and_update_boot() -- - * the trampoline code can't handle CR4.PCIDE and - * it wouldn't do any good anyway. Despite the name, - * cr4_set_bits_and_update_boot() doesn't actually - * cause the bits in question to remain set all the - * way through the secondary boot asm. - * - * Instead, we brute-force it and set CR4.PCIDE - * manually in start_secondary(). - */ - cr4_set_bits(X86_CR4_PCIDE); - } else { - /* - * flush_tlb_all(), as currently implemented, won't - * work if PCID is on but PGE is not. Since that - * combination doesn't exist on real hardware, there's - * no reason to try to fully support it, but it's - * polite to avoid corrupting data if we're on - * an improperly configured VM. - */ - setup_clear_cpu_cap(X86_FEATURE_PCID); - } + if (!IS_ENABLED(CONFIG_X86_64)) + return; + + if (!boot_cpu_has(X86_FEATURE_PCID)) + return; + + if (boot_cpu_has(X86_FEATURE_PGE)) { + /* + * This can't be cr4_set_bits_and_update_boot() -- the + * trampoline code can't handle CR4.PCIDE and it wouldn't + * do any good anyway. Despite the name, + * cr4_set_bits_and_update_boot() doesn't actually cause + * the bits in question to remain set all the way through + * the secondary boot asm. + * + * Instead, we brute-force it and set CR4.PCIDE manually in + * start_secondary(). + */ + cr4_set_bits(X86_CR4_PCIDE); + + /* + * INVPCID's single-context modes (2/3) only work if we set + * X86_CR4_PCIDE, *and* we INVPCID support. It's unusable + * on systems that have X86_CR4_PCIDE clear, or that have + * no INVPCID support at all. + */ + if (boot_cpu_has(X86_FEATURE_INVPCID)) + setup_force_cpu_cap(X86_FEATURE_INVPCID_SINGLE); + } else { + /* + * flush_tlb_all(), as currently implemented, won't work if + * PCID is on but PGE is not. Since that combination + * doesn't exist on real hardware, there's no reason to try + * to fully support it, but it's polite to avoid corrupting + * data if we're on an improperly configured VM. + */ + setup_clear_cpu_cap(X86_FEATURE_PCID); } -#endif } #ifdef CONFIG_X86_32