[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <CAPDyKFrhBfGq0RBBdFLex+88XqrLB-Bm3rc2Q_UZCw8XB520ug@mail.gmail.com>
Date: Wed, 17 Jan 2018 10:33:28 +0100
From: Ulf Hansson <ulf.hansson@...aro.org>
To: Patrice CHOTARD <patrice.chotard@...com>
Cc: Russell King <linux@...linux.org.uk>,
Michael Turquette <mturquette@...libre.com>,
Stephen Boyd <sboyd@...eaurora.org>,
Linus Walleij <linus.walleij@...aro.org>,
Rob Herring <robh+dt@...nel.org>,
Mark Rutland <mark.rutland@....com>,
Alexandre Torgue <alexandre.torgue@...com>,
"linux-mmc@...r.kernel.org" <linux-mmc@...r.kernel.org>,
Linux Kernel Mailing List <linux-kernel@...r.kernel.org>,
linux-clk <linux-clk@...r.kernel.org>,
linux-arm-kernel@...ts.infradead.org, linux-gpio@...r.kernel.org,
devicetree@...r.kernel.org
Subject: Re: [PATCH v2 03/15] mmc: mmci: Don't pretend all variants to have
OPENDRAIN bit
[...]
> /* Busy detection for the ST Micro variant */
> @@ -1455,16 +1465,13 @@ static void mmci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
> ~MCI_ST_DATA2DIREN);
> }
>
> - if (ios->bus_mode == MMC_BUSMODE_OPENDRAIN) {
> - if (host->hw_designer != AMBA_VENDOR_ST)
> - pwr |= MCI_ROD;
> - else {
> - /*
> - * The ST Micro variant use the ROD bit for something
> - * else and only has OD (Open Drain).
> - */
> - pwr |= MCI_OD;
> - }
> + if (ios->bus_mode == MMC_BUSMODE_OPENDRAIN &&
> + host->variant->opendrain) {
A few nitpicks (because I anyway had some comment on patch4):
The above can be written on one line and the brackets isn't needed.
Replace host->variant->opendrain with variant->opendrain. The same
applies to the below change.
> + /*
> + * The ST Micro variant use the ROD bit for
> + * something else and only has OD (Open Drain).
> + */
I think we can remove this comment, as this information becomes
implicit when we start using the variant data.
> + pwr |= host->variant->opendrain;
> }
>
> /*
> --
> 1.9.1
>
Kind regards
Uffe
Powered by blists - more mailing lists