| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20180129232031.GA7695@lenoch>
Date: Tue, 30 Jan 2018 00:20:31 +0100
From: Ladislav Michl <ladis@...ux-mips.org>
To: Pavel Machek <pavel@....cz>
Cc: lgirdwood@...il.com, broonie@...nel.org, robh+dt@...nel.org,
mark.rutland@....com, perex@...ex.cz, tiwai@...e.com,
bhumirks@...il.com, alsa-devel@...a-project.org,
devicetree@...r.kernel.org, linux-kernel@...r.kernel.org,
pali.rohar@...il.com, sre@...nel.org,
linux-arm-kernel <linux-arm-kernel@...ts.infradead.org>,
linux-omap@...r.kernel.org, tony@...mide.com, khilman@...nel.org,
aaro.koskinen@....fi, ivo.g.dimitrov.75@...il.com,
patrikbachan@...il.com, serge@...lyn.com, abcloriens@...il.com,
clayton@...ftyguy.net, martijn@...xit.nl,
sakari.ailus@...ux.intel.com,
Filip Matijević <filip.matijevic.pz@...il.com>
Subject: Re: [PATCH] sound/tlv320dac33: Add device tree support
On Tue, Jan 30, 2018 at 12:05:39AM +0100, Pavel Machek wrote:
>
> This adds device tree support to tlv320dac33.c.
>
> Signed-off-by: Pavel Machek <pavel@....cz>
>
> diff --git a/Documentation/devicetree/bindings/sound/tlv320dac33.txt b/Documentation/devicetree/bindings/sound/tlv320dac33.txt
> new file mode 100644
> index 0000000..6cbd311
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/sound/tlv320dac33.txt
> @@ -0,0 +1,32 @@
> +Texas Instruments - tlv320dac33 Codec module
> +
> +The tlv320dac33 serial control bus communicates through I2C protocols.
> +
> +Required properties:
> +
> +- compatible - "ti,tlv320dac33"
> +- reg - I2C slave address
> +
> +Optional properties:
> +
> +- power-gpios - gpio pin to power the device, active high
While driver used gpio in platform data, isn't it more likely
regulator which powers device?
> +- interrupts - The interrupt output from the device.
> +- interrupt-parent - The parent interrupt controller.
> +
> +- ti,keep-bclk - Keep the BCLK running in FIFO modes
> +- ti,burst-bclkdiv - BCLK divider value in burst mode
> +
> +Example:
> +
> +tlv320dac33: audio-codec@19 {
> + compatible = "ti,tlv320dac33";
> + reg = <0x19>;
> +
> + interrupt-parent = <&gpio2>;
> + interrupts = <21 1>; /* gpio_53, IRQF_TRIGGER_RISING */
> + power-gpio = <&gpio2 28 0>; /* gpio_60 */
> +
> + ti,keep-bclk;
> + ti,burst-bclkdiv = <3>;
> +};
> diff --git a/sound/soc/codecs/tlv320dac33.c b/sound/soc/codecs/tlv320dac33.c
> index 5b94a15..2a0fe06 100644
> --- a/sound/soc/codecs/tlv320dac33.c
> +++ b/sound/soc/codecs/tlv320dac33.c
> @@ -30,6 +32,7 @@
> #include <linux/interrupt.h>
> #include <linux/gpio.h>
> #include <linux/regulator/consumer.h>
> +#include <linux/of_gpio.h>
> #include <linux/slab.h>
> #include <sound/core.h>
> #include <sound/pcm.h>
> @@ -105,7 +108,7 @@ struct tlv320dac33_priv {
> unsigned int nsample; /* burst read amount from host */
> int mode1_latency; /* latency caused by the i2c writes in
> * us */
> - u8 burst_bclkdiv; /* BCLK divider value in burst mode */
> + u32 burst_bclkdiv; /* BCLK divider value in burst mode */
> unsigned int burst_rate; /* Interface speed in Burst modes */
>
> int keep_bclk; /* Keep the BCLK continuously running
> @@ -1484,16 +1487,11 @@ static struct snd_soc_dai_driver dac33_dai = {
> static int dac33_i2c_probe(struct i2c_client *client,
> const struct i2c_device_id *id)
> {
> - struct tlv320dac33_platform_data *pdata;
> + struct tlv320dac33_platform_data *pdata = client->dev.platform_data;
> struct tlv320dac33_priv *dac33;
> + struct device_node *np = client->dev.of_node;
> int ret, i;
>
> - if (client->dev.platform_data == NULL) {
> - dev_err(&client->dev, "Platform data not set\n");
> - return -ENODEV;
> - }
> - pdata = client->dev.platform_data;
> -
> dac33 = devm_kzalloc(&client->dev, sizeof(struct tlv320dac33_priv),
> GFP_KERNEL);
> if (dac33 == NULL)
> @@ -1505,10 +1503,26 @@ static int dac33_i2c_probe(struct i2c_client *client,
>
> i2c_set_clientdata(client, dac33);
>
> - dac33->power_gpio = pdata->power_gpio;
> - dac33->burst_bclkdiv = pdata->burst_bclkdiv;
> - dac33->keep_bclk = pdata->keep_bclk;
> - dac33->mode1_latency = pdata->mode1_latency;
> + if (pdata) {
> + dac33->power_gpio = pdata->power_gpio;
> + dac33->burst_bclkdiv = pdata->burst_bclkdiv;
> + dac33->keep_bclk = pdata->keep_bclk;
> + dac33->mode1_latency = pdata->mode1_latency;
> + } else if (np) {
> + ret = of_get_named_gpio(np, "power-gpios", 0);
> + if (ret >= 0)
> + dac33->power_gpio = ret;
> + else
> + dac33->power_gpio = -1;
> +
> + if (of_property_read_bool(np, "ti,keep-bclk"))
> + dac33->keep_bclk = true;
> +
> + of_property_read_u32(np, "ti,burst-bclkdiv", &dac33->burst_bclkdiv);
> + } else {
> + dev_err(&client->dev, "Platform data not set\n");
> + return -ENODEV;
> + }
> if (!dac33->mode1_latency)
> dac33->mode1_latency = 10000; /* 10ms */
> dac33->irq = client->irq;
> @@ -1574,9 +1588,16 @@ static const struct i2c_device_id tlv320dac33_i2c_id[] = {
> };
> MODULE_DEVICE_TABLE(i2c, tlv320dac33_i2c_id);
>
> +static const struct of_device_id tlv320dac33_of_match[] = {
> + { .compatible = "ti,tlv320dac33", },
> + {},
> +};
> +MODULE_DEVICE_TABLE(i2c, tlv320dac33_of_match);
> +
> static struct i2c_driver tlv320dac33_i2c_driver = {
> .driver = {
> .name = "tlv320dac33-codec",
> + .of_match_table = of_match_ptr(tlv320dac33_of_match),
> },
> .probe = dac33_i2c_probe,
> .remove = dac33_i2c_remove,
>
> --
> (english) http://www.livejournal.com/~pavelmachek
> (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
Powered by blists - more mailing lists