[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <1866837.JGGNoqQO1N@phil>
Date: Fri, 16 Mar 2018 12:02:53 +0100
From: Heiko Stuebner <heiko@...ech.de>
To: Enric Balletbo i Serra <enric.balletbo@...labora.com>
Cc: Rob Herring <robh+dt@...nel.org>,
Kishon Vijay Abraham I <kishon@...com>,
Brian Norris <briannorris@...omium.org>, dianders@...omium.org,
Chris Zhong <zyw@...k-chips.com>,
William wu <wulf@...k-chips.com>, hl@...k-chips.com,
devicetree@...r.kernel.org, linux-arm-kernel@...ts.infradead.org,
linux-rockchip@...ts.infradead.org, linux-kernel@...r.kernel.org,
kernel@...labora.com
Subject: Re: [PATCH v3 6/6] drm/rockchip: cdn-dp: remove the DP phy switch
Am Freitag, 16. Februar 2018, 13:09:56 CET schrieb Enric Balletbo i Serra:
> From: Chris Zhong <zyw@...k-chips.com>
>
> There are 2 Type-c PHYs in RK3399, but only one DP controller. Hence
> only one PHY can connect to DP controller at one time, the other should
> be disconnected. The GRF_SOC_CON26 register has a switch bit to do it,
> set this bit means enable PHY 1, clear this bit means enable PHY 0.
>
> If the board has 2 Type-C ports, the DP driver get the phy id from
> devm_of_phy_get_by_index, and then control this switch according to
> this id. But some others board only has one Type-C port, it may be PHY 0
> or PHY 1. The dts node id can not tell us the correct PHY id. Hence move
> this switch to PHY driver, the PHY driver can distinguish between PHY 0
> and PHY 1, and then write the correct register bit.
>
> Signed-off-by: Chris Zhong <zyw@...k-chips.com>
> Signed-off-by: Enric Balletbo i Serra <enric.balletbo@...labora.com>
applied to drm-misc with a note stating where the rest of the series
went to.
Thanks
Heiko
Powered by blists - more mailing lists