[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <20180419214204.19322-1-stefan@agner.ch>
Date: Thu, 19 Apr 2018 23:42:04 +0200
From: Stefan Agner <stefan@...er.ch>
To: akpm@...ux-foundation.org, mhocko@...e.com, catalin.marinas@....com
Cc: torvalds@...ux-foundation.org, pasha.tatashin@...cle.com,
ard.biesheuvel@...aro.org, linux-mm@...ck.org,
linux-kernel@...r.kernel.org, Stefan Agner <stefan@...er.ch>
Subject: [PATCH] treewide: use PHYS_ADDR_MAX to avoid type casting ULLONG_MAX
With PHYS_ADDR_MAX there is now a type safe variant for all
bits set. Make use of it.
Patch created using a sematic patch as follows:
// <smpl>
@@
typedef phys_addr_t;
@@
-(phys_addr_t)ULLONG_MAX
+PHYS_ADDR_MAX
// </smpl>
Signed-off-by: Stefan Agner <stefan@...er.ch>
---
arch/arm64/mm/init.c | 6 +++---
arch/mips/kernel/setup.c | 4 ++--
arch/powerpc/mm/mem.c | 2 +-
arch/sparc/mm/init_64.c | 2 +-
arch/x86/mm/init_32.c | 2 +-
arch/x86/mm/init_64.c | 2 +-
drivers/firmware/efi/arm-init.c | 2 +-
drivers/remoteproc/qcom_q6v5_pil.c | 2 +-
drivers/soc/qcom/mdt_loader.c | 4 ++--
9 files changed, 13 insertions(+), 13 deletions(-)
diff --git a/arch/arm64/mm/init.c b/arch/arm64/mm/init.c
index 9f3c47acf8ff..f48b19496141 100644
--- a/arch/arm64/mm/init.c
+++ b/arch/arm64/mm/init.c
@@ -310,7 +310,7 @@ static void __init arm64_memory_present(void)
}
#endif
-static phys_addr_t memory_limit = (phys_addr_t)ULLONG_MAX;
+static phys_addr_t memory_limit = PHYS_ADDR_MAX;
/*
* Limit the memory size that was specified via FDT.
@@ -401,7 +401,7 @@ void __init arm64_memblock_init(void)
* high up in memory, add back the kernel region that must be accessible
* via the linear mapping.
*/
- if (memory_limit != (phys_addr_t)ULLONG_MAX) {
+ if (memory_limit != PHYS_ADDR_MAX) {
memblock_mem_limit_remove_map(memory_limit);
memblock_add(__pa_symbol(_text), (u64)(_end - _text));
}
@@ -664,7 +664,7 @@ __setup("keepinitrd", keepinitrd_setup);
*/
static int dump_mem_limit(struct notifier_block *self, unsigned long v, void *p)
{
- if (memory_limit != (phys_addr_t)ULLONG_MAX) {
+ if (memory_limit != PHYS_ADDR_MAX) {
pr_emerg("Memory Limit: %llu MB\n", memory_limit >> 20);
} else {
pr_emerg("Memory Limit: none\n");
diff --git a/arch/mips/kernel/setup.c b/arch/mips/kernel/setup.c
index 563188ac6fa2..2c96c0c68116 100644
--- a/arch/mips/kernel/setup.c
+++ b/arch/mips/kernel/setup.c
@@ -93,7 +93,7 @@ void __init add_memory_region(phys_addr_t start, phys_addr_t size, long type)
* If the region reaches the top of the physical address space, adjust
* the size slightly so that (start + size) doesn't overflow
*/
- if (start + size - 1 == (phys_addr_t)ULLONG_MAX)
+ if (start + size - 1 == PHYS_ADDR_MAX)
--size;
/* Sanity check */
@@ -376,7 +376,7 @@ static void __init bootmem_init(void)
unsigned long reserved_end;
unsigned long mapstart = ~0UL;
unsigned long bootmap_size;
- phys_addr_t ramstart = (phys_addr_t)ULLONG_MAX;
+ phys_addr_t ramstart = PHYS_ADDR_MAX;
bool bootmap_valid = false;
int i;
diff --git a/arch/powerpc/mm/mem.c b/arch/powerpc/mm/mem.c
index 737f8a4632cc..7607a509c695 100644
--- a/arch/powerpc/mm/mem.c
+++ b/arch/powerpc/mm/mem.c
@@ -213,7 +213,7 @@ void __init mem_topology_setup(void)
/* Place all memblock_regions in the same node and merge contiguous
* memblock_regions
*/
- memblock_set_node(0, (phys_addr_t)ULLONG_MAX, &memblock.memory, 0);
+ memblock_set_node(0, PHYS_ADDR_MAX, &memblock.memory, 0);
}
void __init initmem_init(void)
diff --git a/arch/sparc/mm/init_64.c b/arch/sparc/mm/init_64.c
index 8aeb1aabe76e..f396048a0d68 100644
--- a/arch/sparc/mm/init_64.c
+++ b/arch/sparc/mm/init_64.c
@@ -1620,7 +1620,7 @@ static void __init bootmem_init_nonnuma(void)
(top_of_ram - total_ram) >> 20);
init_node_masks_nonnuma();
- memblock_set_node(0, (phys_addr_t)ULLONG_MAX, &memblock.memory, 0);
+ memblock_set_node(0, PHYS_ADDR_MAX, &memblock.memory, 0);
allocate_node_data(0);
node_set_online(0);
}
diff --git a/arch/x86/mm/init_32.c b/arch/x86/mm/init_32.c
index c893c6a3d707..979e0a02cbe1 100644
--- a/arch/x86/mm/init_32.c
+++ b/arch/x86/mm/init_32.c
@@ -692,7 +692,7 @@ void __init initmem_init(void)
high_memory = (void *) __va(max_low_pfn * PAGE_SIZE - 1) + 1;
#endif
- memblock_set_node(0, (phys_addr_t)ULLONG_MAX, &memblock.memory, 0);
+ memblock_set_node(0, PHYS_ADDR_MAX, &memblock.memory, 0);
sparse_memory_present_with_active_regions(0);
#ifdef CONFIG_FLATMEM
diff --git a/arch/x86/mm/init_64.c b/arch/x86/mm/init_64.c
index 0a400606dea0..765a50fb6364 100644
--- a/arch/x86/mm/init_64.c
+++ b/arch/x86/mm/init_64.c
@@ -742,7 +742,7 @@ kernel_physical_mapping_init(unsigned long paddr_start,
#ifndef CONFIG_NUMA
void __init initmem_init(void)
{
- memblock_set_node(0, (phys_addr_t)ULLONG_MAX, &memblock.memory, 0);
+ memblock_set_node(0, PHYS_ADDR_MAX, &memblock.memory, 0);
}
#endif
diff --git a/drivers/firmware/efi/arm-init.c b/drivers/firmware/efi/arm-init.c
index 80d1a885def5..b5214c143fee 100644
--- a/drivers/firmware/efi/arm-init.c
+++ b/drivers/firmware/efi/arm-init.c
@@ -193,7 +193,7 @@ static __init void reserve_regions(void)
* uses its own memory map instead.
*/
memblock_dump_all();
- memblock_remove(0, (phys_addr_t)ULLONG_MAX);
+ memblock_remove(0, PHYS_ADDR_MAX);
for_each_efi_memory_desc(md) {
paddr = md->phys_addr;
diff --git a/drivers/remoteproc/qcom_q6v5_pil.c b/drivers/remoteproc/qcom_q6v5_pil.c
index 8e70a627e0bb..da8edf3f85b3 100644
--- a/drivers/remoteproc/qcom_q6v5_pil.c
+++ b/drivers/remoteproc/qcom_q6v5_pil.c
@@ -615,7 +615,7 @@ static int q6v5_mpss_load(struct q6v5 *qproc)
struct elf32_hdr *ehdr;
phys_addr_t mpss_reloc;
phys_addr_t boot_addr;
- phys_addr_t min_addr = (phys_addr_t)ULLONG_MAX;
+ phys_addr_t min_addr = PHYS_ADDR_MAX;
phys_addr_t max_addr = 0;
bool relocate = false;
char seg_name[10];
diff --git a/drivers/soc/qcom/mdt_loader.c b/drivers/soc/qcom/mdt_loader.c
index 17b314d9a148..dc09d7ac905f 100644
--- a/drivers/soc/qcom/mdt_loader.c
+++ b/drivers/soc/qcom/mdt_loader.c
@@ -50,7 +50,7 @@ ssize_t qcom_mdt_get_size(const struct firmware *fw)
const struct elf32_phdr *phdrs;
const struct elf32_phdr *phdr;
const struct elf32_hdr *ehdr;
- phys_addr_t min_addr = (phys_addr_t)ULLONG_MAX;
+ phys_addr_t min_addr = PHYS_ADDR_MAX;
phys_addr_t max_addr = 0;
int i;
@@ -97,7 +97,7 @@ int qcom_mdt_load(struct device *dev, const struct firmware *fw,
const struct elf32_hdr *ehdr;
const struct firmware *seg_fw;
phys_addr_t mem_reloc;
- phys_addr_t min_addr = (phys_addr_t)ULLONG_MAX;
+ phys_addr_t min_addr = PHYS_ADDR_MAX;
phys_addr_t max_addr = 0;
size_t fw_name_len;
ssize_t offset;
--
2.17.0
Powered by blists - more mailing lists