linux-kernel - Re: [PATCH] spi: spi-geni-qcom: Add SPI driver support for GENI based QUP

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-ID: <20180522173000.GG24776@sirena.org.uk>
Date:   Tue, 22 May 2018 18:30:00 +0100
From:   Mark Brown <broonie@...nel.org>
To:     Stephen Boyd <swboyd@...omium.org>
Cc:     "Mahadevan, Girish" <girishm@...eaurora.org>,
        linux-kernel@...r.kernel.org, linux-spi@...r.kernel.org,
        sdharia@...eaurora.org, kramasub@...eaurora.org,
        dianders@...omium.org, linux-arm-msm@...r.kernel.org
Subject: Re: [PATCH] spi: spi-geni-qcom: Add SPI driver support for GENI
 based QUP

On Tue, May 22, 2018 at 09:46:39AM -0700, Stephen Boyd wrote:
> Quoting Mahadevan, Girish (2018-05-21 08:52:47)

> > Not sure I follow, the intention is to run the controller clock based on
> > the slave's max frequency.

> That's good. The problem I see is that we have to specify the max
> frequency in the controller/bus node, and also in the child/slave node.
> It should only need to be specified in the slave node, so making the
> cur_speed_hz equal the max_speed_hz is problematic. The current speed of
> the master should be determined by calling clk_get_rate().

We don't require that the slaves all individually set a speed since it
gets a bit redundant, it should be enough to just use the default the
controller provides.  A bigger problem with this is that the driver will
never see a transfer which doesn't explicitly have a speed set as the
core will ensure something is set, open coding this logic in every
driver would obviously be tiresome.

> > The intention was to allow a client to specify slave specific timing
> > requirements, e.g CS-CLK delay (based on the slave's data sheet).
> > So that the client drivers could setup these delays and pass it in part
> > of the controller_data member of the spi_device data structure.
> > The header file was meant to expose these timing params that the client
> > could specify. I honestly didn't know how else a client could specify
> > these to the controller driver.

> Do you mean spi-rx-delay-us and spi-tx-delay-us properties? Those are
> documented but don't seem to be used. There's also the delay_usecs part
> of the spi_transfer structure, which may be what you're talking about.

delay_usecs is for inter-transfer delays within a message rather than
after the initial chip select assert (it can be used to keep chip select
asserted for longer after the final transfer too).  Obviously this is
also something that shouldn't be configured in a driver specific
fashion.

Download attachment "signature.asc" of type "application/pgp-signature" (489 bytes)