lists.openwall.net   lists  /  announce  owl-users  owl-dev  john-users  john-dev  passwdqc-users  yescrypt  popa3d-users  /  oss-security  kernel-hardening  musl  sabotage  tlsify  passwords  /  crypt-dev  xvendor  /  Bugtraq  Full-Disclosure  linux-kernel  linux-netdev  linux-ext4  linux-hardening  linux-cve-announce  PHC 
Open Source and information security mailing list archives
 
Hash Suite: Windows password security audit tool. GUI, reports in PDF.
[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-ID: <3bdb712d-38bd-e2ca-63cf-8406a7b5689d@wiesinger.com>
Date:   Tue, 22 May 2018 21:11:57 +0200
From:   Gerhard Wiesinger <lists@...singer.com>
To:     Andrew Lunn <andrew@...n.ch>,
        Florian Fainelli <f.fainelli@...il.com>,
        linux-kernel@...r.kernel.org
Subject: B53 DSA switch problem on Banana Pi-R1 on Fedora 26

Hello,

I'm trying to get B53 DSA switch working on the Banana Pi-R1 on Fedora 
26 to run (I will upgrade to Fedora 27 and Fedora 28 when networking 
works again). Previously the switch was configured with swconfig without 
any problems.

Kernel: 4.16.7-100.fc26.armv7hl

b53_common: found switch: BCM53125, rev 4

I see all interfaces: lan1 to lan4 and wan.

i get the following error messages:

# master and self, same results

bridge vlan add dev lan1 vid 101 pvid untagged self
RTNETLINK answers: Operation not supported
bridge vlan add dev lan2 vid 101 pvid untagged self
RTNETLINK answers: Operation not supported
bridge vlan add dev lan3 vid 101 pvid untagged self
RTNETLINK answers: Operation not supported
bridge vlan add dev lan4 vid 101 pvid untagged self
RTNETLINK answers: Operation not supported

# No quite sure here regarding CPU interface and VLAN, because this 
changed with some patches, also from dsa.txt

bridge vlan add dev eth0 vid 101 self
RTNETLINK answers: Operation not supported

Planned network structure will be as with 4.7.x kernels:

br0 <=> eth0.101 <=> eth0 (vlan 101 tagged) <=> lan 1-lan4 (vlan 101 
untagged pvid)

br1 <=> eth0.102 <=> eth0 (vlan 102 tagged) <=> wan (vlan 102 untagged pvid)

I think the rest of the config is clear after some research now, but I 
provide details if that one worked well.

If necessary I can provide full commands & logs and further details.

Thank you.

Any ideas?

Ciao,

Gerhard


Powered by blists - more mailing lists

Powered by Openwall GNU/*/Linux Powered by OpenVZ