[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <20180531165109.8476-1-jagan@amarulasolutions.com>
Date: Thu, 31 May 2018 22:21:09 +0530
From: Jagan Teki <jagan@...rulasolutions.com>
To: Maxime Ripard <maxime.ripard@...e-electrons.com>,
Chen-Yu Tsai <wens@...e.org>,
Michael Trimarchi <michael@...rulasolutions.com>,
Icenowy Zheng <icenowy@...c.io>
Cc: devicetree@...r.kernel.org, linux-arm-kernel@...ts.infradead.org,
linux-kernel@...r.kernel.org, linux-sunxi@...glegroups.com,
Jagan Teki <jagan@...rulasolutions.com>
Subject: [PATCH v2] arm64: allwinner: a64-amarula-relic: Enable AP6330 WiFi support
Enable AP6330 WiFi/BT combo chip on Amarula A64-Relic board:
- WiFi SDIO interface is connected to MMC1
- WiFi WL-PMU-EN pin connected to gpio PL2: attach to mmc-pwrseq
- WiFi WL-WAKE-AP pin connected to gpio PL3
- 32kHz external oscillator gate clock from RTC
Signed-off-by: Jagan Teki <jagan@...rulasolutions.com>
---
Changes for v2:
- Move external rtc clock nodes into main rtc node definition
of sun50i-a64.dtsi
.../dts/allwinner/sun50i-a64-amarula-relic.dts | 31 ++++++++++++++++++++++
arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi | 3 +++
2 files changed, 34 insertions(+)
diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
index ce4a256ff086..eac4793c8502 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
@@ -21,12 +21,43 @@
chosen {
stdout-path = "serial0:115200n8";
};
+
+ wifi_pwrseq: wifi-pwrseq {
+ compatible = "mmc-pwrseq-simple";
+ clocks = <&rtc 1>;
+ clock-names = "ext_clock";
+ reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* WL-PMU-EN: PL2 */
+ };
};
&ehci0 {
status = "okay";
};
+&mmc1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&mmc1_pins>;
+ vmmc-supply = <®_dcdc1>;
+ /*
+ * Schematic shows both dldo4 and eldo1 connected for vcc-io-wifi, but
+ * dldo4 connection shows DNP(Do Not Populate) and eldo1 connected with
+ * 0Ohm register to vcc-io-wifi so eldo1 is used.
+ */
+ vqmmc-supply = <®_eldo1>;
+ mmc-pwrseq = <&wifi_pwrseq>;
+ bus-width = <4>;
+ non-removable;
+ status = "okay";
+
+ brcmf: wifi@1 {
+ reg = <1>;
+ compatible = "brcm,bcm4329-fmac";
+ interrupt-parent = <&r_pio>;
+ interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>; /* WL-WAKE-AP: PL3 */
+ interrupt-names = "host-wake";
+ };
+};
+
&mmc2 {
pinctrl-names = "default";
pinctrl-0 = <&mmc2_pins>;
diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
index 1b2ef28c42bd..82516aec4153 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
@@ -634,6 +634,9 @@
reg = <0x01f00000 0x54>;
interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH>;
+ clock-output-names = "rtc-osc32k", "rtc-osc32k-out";
+ clocks = <&osc32k>;
+ #clock-cells = <1>;
};
r_intc: interrupt-controller@...0c00 {
--
2.14.3
Powered by blists - more mailing lists