[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <20180702142840.42801396@xps13>
Date: Mon, 2 Jul 2018 14:28:40 +0200
From: Miquel Raynal <miquel.raynal@...tlin.com>
To: Masahiro Yamada <yamada.masahiro@...ionext.com>
Cc: linux-mtd@...ts.infradead.org,
Boris Brezillon <boris.brezillon@...tlin.com>,
Rob Herring <robh+dt@...nel.org>,
Richard Weinberger <richard@....at>,
devicetree@...r.kernel.org, linux-kernel@...r.kernel.org,
Marek Vasut <marek.vasut@...il.com>,
Brian Norris <computersforpeace@...il.com>,
David Woodhouse <dwmw2@...radead.org>,
Mark Rutland <mark.rutland@....com>
Subject: Re: [PATCH v4 0/5] mtd: rawnand: denali: add new clocks and improve
setup_data_interface
Hi Masahiro,
Masahiro Yamada <yamada.masahiro@...ionext.com> wrote on Sat, 23 Jun
2018 01:06:33 +0900:
> The ->setup_data_interface() hook needs to know the clock frequency.
> In fact, this IP needs three clocks, but the current driver does not
> represent it. Thus, it is hard to understand what is the correct
> clock frequency.
> (at least, clock property is not described in the DT-binding at all.)
>
> This series adds more clocks based on the IP datasheet, and document
> it in the DT binding.
> In the new binding, three clocks are required: core clock, bus interface
> clock, ECC engine clock.
>
> 1/5 is a backport candidate to fix SOCFPGA.
>
>
> Masahiro Yamada (5):
> mtd: rawnand: denali_dt: set clk_x_rate to 200 MHz unconditionally
> mtd: rawnand: denali_dt: use dev as a shorthand of &pdev->dev
> dt-binding: mtd: denali_dt: document clock property
> mtd: rawnand: denali_dt: add more clocks based on IP datasheet
> mtd: rawnand: denali: optimize timing parameters for data interface
Applied patches 2-5/5 to nand/next on top of v4-18.rc3 (to have the fix
1/5).
Thanks,
Miquèl
Powered by blists - more mailing lists