| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1541601809-16950-6-git-send-email-frieder.schrempf@kontron.de>
Date: Wed, 7 Nov 2018 15:43:22 +0100
From: Frieder Schrempf <frieder.schrempf@...tron.de>
To: linux-mtd@...ts.infradead.org, boris.brezillon@...tlin.com,
linux-spi@...r.kernel.org
Cc: dwmw2@...radead.org, computersforpeace@...il.com,
marek.vasut@...il.com, richard@....at, miquel.raynal@...tlin.com,
broonie@...nel.org, david.wolfe@....com, fabio.estevam@....com,
prabhakar.kushwaha@....com, yogeshnarayan.gaur@....com,
han.xu@....com, shawnguo@...nel.org,
Frieder Schrempf <frieder.schrempf@...eet.de>,
Li Yang <leoyang.li@....com>, Rob Herring <robh+dt@...nel.org>,
Mark Rutland <mark.rutland@....com>,
linux-arm-kernel@...ts.infradead.org, devicetree@...r.kernel.org,
linux-kernel@...r.kernel.org
Subject: [PATCH v4 05/10] arm64: dts: Reflect change of FSL QSPI driver and remove unused properties
From: Frieder Schrempf <frieder.schrempf@...eet.de>
The FSL QSPI driver was moved to the SPI framework and it now
acts as a SPI controller. Therefore the subnodes need to set
spi-[rx/tx]-bus-width = <4>, so quad mode is used just as before.
Also the properties 'num-cs' and 'bus-num' were never read by the
driver and can be removed.
The property 'fsl,qspi-has-second-chip' is not needed anymore
and will be removed after the old driver was disabled to avoid
breaking fsl-ls1046a-rdb.dts.
Signed-off-by: Frieder Schrempf <frieder.schrempf@...eet.de>
---
arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts | 3 ++-
arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts | 4 ++--
arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts | 6 ++++--
arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi | 4 ++++
4 files changed, 12 insertions(+), 5 deletions(-)
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts b/arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts
index dff3d64..8a50094 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts
@@ -135,7 +135,6 @@
};
&qspi {
- bus-num = <0>;
status = "okay";
qflash0: s25fl128s@0 {
@@ -143,6 +142,8 @@
#address-cells = <1>;
#size-cells = <1>;
spi-max-frequency = <20000000>;
+ spi-rx-bus-width = <4>;
+ spi-tx-bus-width = <4>;
reg = <0>;
};
};
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts b/arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts
index e58a8ca..2f220ec 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts
@@ -163,8 +163,6 @@
};
&qspi {
- num-cs = <2>;
- bus-num = <0>;
status = "okay";
qflash0: s25fl128s@0 {
@@ -172,6 +170,8 @@
#address-cells = <1>;
#size-cells = <1>;
spi-max-frequency = <20000000>;
+ spi-rx-bus-width = <4>;
+ spi-tx-bus-width = <4>;
reg = <0>;
};
};
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts b/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
index a59b482..07c665c 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
@@ -99,8 +99,6 @@
};
&qspi {
- num-cs = <2>;
- bus-num = <0>;
status = "okay";
qflash0: s25fs512s@0 {
@@ -108,6 +106,8 @@
#address-cells = <1>;
#size-cells = <1>;
spi-max-frequency = <20000000>;
+ spi-rx-bus-width = <4>;
+ spi-tx-bus-width = <4>;
reg = <0>;
};
@@ -116,6 +116,8 @@
#address-cells = <1>;
#size-cells = <1>;
spi-max-frequency = <20000000>;
+ spi-rx-bus-width = <4>;
+ spi-tx-bus-width = <4>;
reg = <1>;
};
};
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi
index c11f52e..10d2fe0 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi
@@ -134,6 +134,8 @@
#size-cells = <1>;
compatible = "st,m25p80";
spi-max-frequency = <20000000>;
+ spi-rx-bus-width = <4>;
+ spi-tx-bus-width = <4>;
reg = <0>;
};
flash2: s25fl256s1@2 {
@@ -141,6 +143,8 @@
#size-cells = <1>;
compatible = "st,m25p80";
spi-max-frequency = <20000000>;
+ spi-rx-bus-width = <4>;
+ spi-tx-bus-width = <4>;
reg = <2>;
};
};
--
2.7.4
Powered by blists - more mailing lists