[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20181127110134.7xdwo7ird44qj2ih@pengutronix.de>
Date: Tue, 27 Nov 2018 12:01:34 +0100
From: Uwe Kleine-König
<u.kleine-koenig@...gutronix.de>
To: Schrempf Frieder <frieder.schrempf@...tron.de>
Cc: "linux-mtd@...ts.infradead.org" <linux-mtd@...ts.infradead.org>,
"boris.brezillon@...tlin.com" <boris.brezillon@...tlin.com>,
"linux-spi@...r.kernel.org" <linux-spi@...r.kernel.org>,
Shawn Guo <shawnguo@...nel.org>,
Sascha Hauer <s.hauer@...gutronix.de>,
Pengutronix Kernel Team <kernel@...gutronix.de>,
Fabio Estevam <fabio.estevam@....com>,
NXP Linux Team <linux-imx@....com>,
Rob Herring <robh+dt@...nel.org>,
Mark Rutland <mark.rutland@....com>,
Li Yang <leoyang.li@....com>,
"devicetree@...r.kernel.org" <devicetree@...r.kernel.org>,
"yogeshnarayan.gaur@....com" <yogeshnarayan.gaur@....com>,
"richard@....at" <richard@....at>,
"prabhakar.kushwaha@....com" <prabhakar.kushwaha@....com>,
"linux-kernel@...r.kernel.org" <linux-kernel@...r.kernel.org>,
"marek.vasut@...il.com" <marek.vasut@...il.com>,
"han.xu@....com" <han.xu@....com>,
"broonie@...nel.org" <broonie@...nel.org>,
"miquel.raynal@...tlin.com" <miquel.raynal@...tlin.com>,
"david.wolfe@....com" <david.wolfe@....com>,
"computersforpeace@...il.com" <computersforpeace@...il.com>,
"dwmw2@...radead.org" <dwmw2@...radead.org>,
"linux-arm-kernel@...ts.infradead.org"
<linux-arm-kernel@...ts.infradead.org>
Subject: Re: [PATCH v6 1/9] ARM: dts: Reflect change of FSL QSPI driver and
remove unused properties
Hello,
On Tue, Nov 27, 2018 at 10:24:19AM +0000, Schrempf Frieder wrote:
> The FSL QSPI driver will be moved to the SPI framework and it then
> acts as a SPI controller. Therefore the subnodes need to set
> spi-[rx/tx]-bus-width = <4>, so quad mode is used just as before.
>
> Also the properties 'bus-num', 'fsl,spi-num-chipselects' and
> 'fsl,spi-flash-chipselects' were never read by the driver and
> can be removed.
>
> The 'reg' properties are adjusted to reflect what bus and
> chipselect the flash is connected to, as the new driver needs
> this information.
>
> The property 'fsl,qspi-has-second-chip' is not needed anymore
> and will be removed after the old driver was disabled to avoid
> breaking ls1021a-moxa-uc-8410a.dts.
>
> Signed-off-by: Frieder Schrempf <frieder.schrempf@...tron.de>
do we need to change the binding document accordingly?
Best regards
Uwe
--
Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Powered by blists - more mailing lists